ترغب بنشر مسار تعليمي؟ اضغط هنا

Density-functional description of superconducting and magnetic proximity effects across a tunneling barrier

46   0   0.0 ( 0 )
 نشر من قبل Jorge Quintanilla
 تاريخ النشر 2008
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

A density-functional formalism for superconductivity {em and} magnetism is presented. The resulting relations unify previously derived Kohn-Sham equations for superconductors and for non-collinear magnetism. The formalism, which discriminates Cooper pair singlets from triplets, is applied to two quantum liquids coupled by tunneling through a barrier. An exact expression is derived, relating the eigenstates and eigenvalues of the Kohn-Sham equations, unperturbed by tunneling, on one side of the barrier to the proximity-induced ordering potential on the other.

قيم البحث

اقرأ أيضاً

We studied the proximity effect between a superconductor (Nb) and a diluted ferromagnetic alloy (CuNi) in a bilayer geometry. We measured the local density of states on top of the ferromagnetic layer, which thickness varies on each sample, with a ver y low temperature Scanning Tunneling Microscope. The measured spectra display a very high homogeneity. The analysis of the experimental data shows the need to take into account an additional scattering mechanism. By including in the Usadel equations the effect of the spin relaxation in the ferromagnetic alloy, we obtain a good description of the experimental data.
We demonstrate simultaneous measurements of DC transport properties and flux noise of a hybrid superconducting magnetometer based on the proximity effect (superconducting quantum interference proximity transistor, SQUIPT). The noise is probed by a cr yogenic amplifier operating in the frequency range of a few MHz. In our non-optimized device, we achieve minimum flux noise $sim 4;muPhi_0/Hz^{1/2}$, set by the shot noise of the probe tunnel junction. The flux noise performance can be improved by further optimization of the SQUIPT parameters, primarily minimization of the proximity junction length and cross section. Furthermore, the experiment demonstrates that the setup can be used to investigate shot noise in other nonlinear devices with high impedance. This technique opens the opportunity to measure sensitive magnetometers including SQUIPT devices with very low dissipation.
Epitaxial Fe/magnesium gallium spinel oxide (MgGa2O4)/Fe(001) magnetic tunnel junctions (MTJs) were fabricated by magnetron sputtering. Tunnel magnetoresistance (TMR) ratio up to 121% at room temperature (196% at 4 K) was observed, suggesting a TMR e nhancement by the coherent tunneling effect in the MgGa2O4 barrier. The MgGa2O4 layer had a spinel structure and it showed good lattice matching with the Fe layers owing to slight tetragonal lattice distortion of MgGa2O4. Barrier thickness dependence of the tunneling resistance and current-voltage characteristics revealed that the barrier height of the MgGa2O4 barrier is much lower than that in an MgAl2O4 barrier. This study demonstrates the potential of Ga-based spinel oxides for MTJ barriers having a large TMR ratio at a low resistance area product.
The kernel of the study of magnetic quantum materials focuses on the magnetic phase transitions, among which the most common phenomenon is the transition between low-temperature magnetic-ordered phase to high-temperature paramagnetic phase. A paramou nt question is if such paramagnetic phase of the correlated solids can be well described by single-particle band theory to facilitate the experimental observations. In this work, we investigate the properties of temperature-driven paramagnetic phase via two different approaches within the framework of density functional theory, monomorphous and polymorphous description. From a comprehensive comparison of total energies, symmetries and band structures, we demonstrate the necessity for a proper treatment of paramagnetic phases with several prototypical examples. For Pauli paramagnetism phase, the vanishing of spin moments permits us to apply a nonmagnetic monomorphous description, while for paramagnetism with disordered local moments, such description imposes unrealistic high symmetry, leading to a metallic state in certain cases, inconsistent with the experimental observation. In contrast, the polymorphous description based on a large-enough supercell with disordered local moments is able to count in the effects of distinct local environments, such as symmetry lowing, providing a more reliable paramagnetic electronic structure and total energy compared with experiments. Our work shed new insights on discovering the temperature-dependent magnetic phase transition in the field of magnetic quantum materials.
A finite-temperature density functional approach to describe the properties of parahydrogen in the liquid-vapor coexistence region is presented. The first proposed functional is zero-range, where the density-gradient term is adjusted so as to reprodu ce the surface tension of the liquid-vapor interface at low temperature. The second functional is finite-range and, while it is fitted to reproduce bulk pH2 properties only, it is shown to yield surface properties in good agreement with experiments. These functionals are used to study the surface thickness of the liquid-vapor interface, the wetting transition of parahydrogen on a planar Rb model surface, and homogeneous cavitation in bulk liquid pH2.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا