اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCooling of a micro-mechanical oscillator using radiation pressure induced dynamical back-action
65
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Cooling of a 58 MHz micro-mechanical resonator from room temperature to 11 K is demonstrated using cavity enhanced radiation pressure. Detuned pumping of an optical resonance allows enhancement of the blue shifted motional sideband (caused by the oscillators Brownian motion) with respect to the red-shifted sideband leading to cooling of the mechanical oscillator mode. The reported cooling mechanism is a manifestation of the effect of radiation pressure induced dynamical backaction. These results constitute an important step towards achieving ground state cooling of a mechanical oscillator.
قيم البحث
اقرأ أيضاً
A quantum theory of cooling of a mechanical oscillator by radiation pressure-induced dynamical back-action is developed, which is analogous to sideband cooling of trapped ions. We find that final occupancies well below unity can be attained when the
mechanical oscillation frequency is larger than the cavity linewidth. It is shown that the final average occupancy can be retrieved directly from the optical output spectrum.
We demonstrate passive feedback cooling of a mechanical resonator based on radiation pressure forces and assisted by photothermal forces in a high-finesse optical cavity. The resonator is a free-standing high-reflectance micro-mirror (of mass m=400ng
and mechanical quality factor Q=10^4) that is used as back-mirror in a detuned Fabry-Perot cavity of optical finesse F=500. We observe an increased damping in the dynamics of the mechanical oscillator by a factor of 30 and a corresponding cooling of the oscillator modes below 10 K starting from room temperature. This effect is an important ingredient for recently proposed schemes to prepare quantum entanglement of macroscopic mechanical oscillators.
The theoretical work of V.B. Braginsky predicted that radiation pressure can couple the mechanical, mirror-eigenmodes of a Fabry-Perot resonator to its optical modes, leading to a parametric oscillation instability. This regime is characterized by re
generative mechanical oscillation of the mechanical mirror eigenmodes. We have recently observed the excitation of mechanical modes in an ultra-high-Q optical microcavity. Here, we present a detailed experimental analysis of this effect and demonstrate that radiation pressure is the excitation mechanism of the observed mechanical oscillations.
We present first results from a number of experiments conducted on a 0.53 kg cylindrical dumbbell-shaped sapphire crystal. This is the first reported optomechanical experiment of this nature utilising a novel modification to the typical cylindrical a
rchitecture. Mechanical motion of the crystal structure alters the dimensions of the crystal, and the induced strain changes the permittivity. These two effects result in parametric frequency modulation of resonant microwave whispering gallery modes that are simultaneously excited within the crystal. A novel low-noise microwave readout system is implemented allowing extremely low noise measurements of this frequency modulation near our modes of interest, having a phase noise floor of -165 dBc/Hz at 100 kHz. Fine-tuning of the crystals suspension has allowed for the optimisation of mechanical quality factors in preparation for cryogenic experiments, with a value of Q=8 x 10^7 achieved at 127 kHz. This results in a Q x f product of 10^13, equivalent to the best measured values in a macroscopic sapphire mechanical system. Results are presented that demonstrate the excitation of mechanical modes via radiation pressure force, allowing an experimental method of determining the transducers displacement sensitivity df/dx, and calibrating the system. Finally, we demonstrate parametric back-action phenomenon within the system. These are all important steps towards the overall goal of the experiment; to cool a macroscopic device to the quantum ground state at millikelvin temperatures.
We demonstrate an accurate method to control the motion of a micromechanical oscillator in contact with a thermal bath. The experiment is carried out on the cantilever tip of an Atomic Force Microscope (AFM). Applying an appropriate time dependent ex
ternal force, we decrease the time necessary to reach equilibrium by two orders of magnitude compared to the intrinsic equilibration time. Finally, we analyze the energetic cost of such a fast equilibration, by measuring with kBT accuracy the energy exchanges along the process.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
