ترغب بنشر مسار تعليمي؟ اضغط هنا

Nanolithography with metastable helium atoms in a high-power standing-wave light field

127   0   0.0 ( 0 )
 نشر من قبل S. J. H. Petra
 تاريخ النشر 2003
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We have created periodic nanoscale structures in a gold substrate with a lithography process using metastable triplet helium atoms that damage a hydrofobic resist layer on top of the substrate. A beam of metastable helium atoms is transversely cooled and guided through an intense standing-wave light field. Compared to commonly used low-power optical masks, a high-power light field (saturation parameter of 10E7) increases the confinement of the atoms in the standing-wave considerably, and makes the alignment of the experimental setup less critical. Due to the high internal energy of the metastable helium atoms (20 eV), a dose of only one atom per resist molecule is required. With an exposure time of only eight minutes, parallel lines with a separation of 542 nm and a width of 100 nm (1/11th of the wavelength used for the optical mask) are created.

قيم البحث

اقرأ أيضاً

The motion of metastable helium atoms travelling through a standing light wave is investigated with a semi-classical numerical model. The results of a calculation including the velocity dependence of the dipole force are compared with those of the co mmonly used approach, which assumes a conservative dipole force. The comparison is made for two atom guiding regimes that can be used for the production of nanostructure arrays; a low power regime, where the atoms are focused in a standing wave by the dipole force, and a higher power regime, in which the atoms channel along the potential minima of the light field. In the low power regime the differences between the two models are negligible and both models show that, for lithography purposes, pattern widths of 150 nm can be achieved. In the high power channelling regime the conservative force model, predicting 100 nm features, is shown to break down. The model that incorporates velocity dependence, resulting in a structure size of 40 nm, remains valid, as demonstrated by a comparison with quantum Monte-Carlo wavefunction calculations.
Atoms from an otherwise unconfined 87Rb condensate are shown to be suspended against gravity using repeated reflections from a pulsed optical standing wave. Reflection efficiency was optimized using a triple-pulse sequence that, theoretically, provid es accuracies better than 99.9%. Experimentally, up to 100 reflections are observed, leading to dynamical suspension for over 100 ms. The velocity sensitivity of the reflections can be used to determine the local gravitational acceleration. Further, a gravitationally sensitive atom interferometer was implemented using the suspended atoms, with packet coherence maintained for a similar time. These techniques could be useful for the precise measurement of gravity when it is impractical to allow atoms to fall freely over a large distance.
We show that properly detuning the carrier frequency of each of the criss-cross bichromatic waves from the transition frequency of the atom, it is possible to form a two-dimensional trap for atoms if the intensity of the waves is sufficiently large. For zero and near zero initial phases of waves, and also for $pi$ and near $pi$ phase shift between criss-cross waves a dynamic spatial structure of square cells with the side $lambda /sqrt{2}$ is formed. Numerical simulations are carried out for sodium atoms.
We trap a single cesium atom in a standing-wave optical dipole trap. Special experimental procedures, designed to work with single atoms, are used to measure the oscillation frequency and the atomic energy distribution in the dipole trap. These metho ds rely on unambiguously detecting presence or loss of the atom using its resonance fluorescence in the magneto-optical trap.
Besides being a source of energy, light can also cool gases of atoms down to the lowest temperatures ever measured, where atomic motion almost stops. The research field of cold atoms has emerged as a multidisciplinary one, highly relevant, e.g., for precision measurements, quantum gases, simulations of many-body physics, and atom optics. In this focus article, we present the field as seen in 2015, and emphasise the fundamental role in its development that has been played by mastering.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا