اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدGiant Magnetoimpedance of Glass-Covered Amorphous Microwires of Co-Mn-Si-B and Co-Si-B
95
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A study of magnetic hysteresis and Giant magnetoimpedance (GMI) in amorphous glass covered Co-Si-B and Co-Mn-Si-B wires is presented. The wires, about 10 microns in diameter, were obtained by glass-coated melt spinning technique. Samples with positive magnetostriction (MS) have a rectangular bistable hysteresis loop. A smooth hysteresis loop is observed for wires with nearly zero MS. When MS is negative, almost no hysteresis is observed. The GMI was measured in the frequency range between 20 Hz and 30 MHz. The shapes of the impedance versus field curves are qualitatively similar to each other for both positive and zero MS samples. Impedance is maximum at zero field, and decreases sharply in the range 10-20 Oe. For the negative MS wires, when the driving current is small, the impedance is maximum at a finite external field. The position of the maximum approaches zero with increasing current. The contributions of the moment rotation and domain wall motion in the three cases are discussed.
قيم البحث
اقرأ أيضاً
We report the discovery of a new spin glass ground state in the transition metal monosilicides with the B20 crystallographic structure. Magnetic, transport, neutron and muon investigation of the solid solution Mn$_{1-x}$Co$_{x}$Si have revealed a new
dome in the phase diagram with evidence of antiferromagnetic interactions. For Mn rich compounds, a sharp decrease of the Curie temperature is observed upon Co doping and neutron elastic scattering shows that helimagnetic order of MnSi persists up to $x=0.05$ with a shortening of the helix period. For higher Co ($0.05<x<0.90$) concentrations, the Curie-Weiss temperature changes sign and the system enters a spin glass state upon cooling ($T_g=9$ K for $x_{Co}=0.50$), due to chemical disorder. In this doping range, a minimum appears in the resistivity, attributed to scattering of conduction electron by localized magnetic moments.
A remarkably strong dependence of magnetoimpedance (MI) on tensile stress has been observed in the microwave frequency range for thin CoMnSiB glass-coated microwires exposed to a special thermal treatment. The MI ratio runs into more than 100% at 0.5
-1.5 GHz when the tensile stress of 600 MPa is applied to the wire. It was demonstrated that a large MI change at such high frequencies is related predominantly with the dc magnetization orientation. A host of such microwires incorporated into a dielectric matrix may constitute a new sensing medium that is characterized by the stress-dependent effective permittivity. Such medium can be used for the microwave visualization of the stress distribution inside of a composite structure or on its surface.
Large thermal hysteresis in the MnFe(P, Si, B) system hinders the heat exchange rate and thus limits the magnetocaloric applications at high frequencies. Substitution of Mn by V in Mn1-xVxFe0.95P0.593Si0.33B0.077 and Mn1-xVxFe0.95P0.563Si0.36B0.077 a
lloys was found to reduce the thermal hysteresis due to a decrease in the latent heat. Introducing V increases both the field-induced transition temperature shift and the magnetic moment per formula unit. Thus, a decease in the thermal hysteresis is obtained without losing the giant magnetocaloric effect. In consequence, an ultralow hysteresis (0.7 K) and a giant adiabatic temperature change of 2.3 K were achieved, which makes these alloys promising candidates for commercial magnetic refrigerator using permanent magnets.
Magnetocaloric effect and magnetoresistance have been studied in Dy(Co1-xSix)2 [x=0, 0.075 and 0.15] compounds. Magnetocaloric effect has been calculated in terms of adiabatic temperatue change (Delta Tad) as well as isothermal magnetic entropy chang
e (Delta SM) using the heat capacity data. The maximum values of DeltaSM and DeltaTad for DyCo2 are found to be 11.4 JKg-1K-1 and 5.4 K, respectively. Both DSM and DTad decrease with Si concentration, reaching a value of 5.4 JKg-1K-1 and 3 K, respectively for x=0.15. The maximum magnetoresistance is found to about 32% in DyCo2, which decreases with increase in Si. These variations are explained on the basis of itinerant electron metamagnetism occurring in these compounds.
The T91 grade and similar 9Cr tempered-martensitic steels (also known as ferritic-martensitic) are leading candidate structural alloys for fast fission nuclear and fusion power reactors. At low temperatures (300 to 400 $^circ$C) neutron irradiation h
ardens and embrittles these steels, therefore it is important to investigate the origin of this mode of life limiting property degradation. T91 steel specimens were separately neutron irradiated to 2.14 dpa at 327 $^circ$C and 8.82 dpa at 377 $^circ$C in the Idaho National Laboratory Advanced Test Reactor. Atom probe tomography was used to investigate the segregation driven formation of Mn-Ni-Si-rich (MNSPs) and Cu-rich (CRP) co-precipitates. The precipitates increase in size and, slightly, in volume fraction at the higher irradiation temperature and dose, while their corresponding compositions were very similar, falling near the Si(Mn,Ni) phase field in the Mn-Ni-Si projection of the Fe-based quaternary phase diagram. While the structure of the precipitates has not been characterized, this composition range is distinctly different than that of the typically cited G-phase. The precipitates are composed of CRP with MNSP appendages. Such features are often observed in neutron irradiated reactor pressure vessel (RPV) steels. However, the Si, Ni, Mn, P and Cu solutes concentrations are lower in the T91 than in typical RPV steels. Thus, in T91 precipitation primarily takes place in solute segregated regions of line and loop dislocations. These results are consistent with the model for radiation induced segregation driven precipitation of MNSPs proposed by Ke et al. Cr-rich alpha prime ($alpha$) phase formation was not observed.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
