اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدGranular and Nano-Elasticity
144
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The modeling of the elastic properties of granular or nanoscale systems requires the foundations of the theory of elasticity to be revisited, as one explores scales at which this theory may no longer hold. The only cases for which a microscopic justification of elasticity exists are (nearly) uniformly strained lattices. A microscopic theory of elasticity, as well as simulations, reveal that standard continuum elasticity applies only at sufficiently large scales (typically 100 particle diameters). Interestingly, force chains, which have been observed in experiments on granular systems, and attributed to non-elastic effects, are shown to exist in systems composed of harmonically interacting constituents. The corresponding stress field, which is a continuum mechanical (averaged) entity, exhibits no chain structures even at near-microscopic resolutions, but it does reflect macroscopic anisotropy, when present.
قيم البحث
اقرأ أيضاً
The task of finding the smallest energy needed to bring a solid to its onset of mechanical instability arises in many problems in materials science, from the determination of the elasticity limit to the consistent assignment of free energies to mecha
nically unstable phases. However, unless the space of possible deformations is low-dimensional and a priori known, this problem is numerically difficult, as it involves minimizing a function under a constraint on its Hessian, which is computionally prohibitive to obtain in low symmetry systems, especially if electronic structure calculations are used. We propose a method that is inspired by the well-known dimer method for saddle point searches but that adds the necessary ingredients to solve for the lowest onset of mechanical instability. The method consists of two nested optimization problems. The inner one involves a dimer-like construction to find the direction of smallest curvature as well as the gradient of this curvature function. The outer optimization then minimizes energy using the result of the inner optimization problem to constrain the search to the hypersurface enclosing all points of zero minimum curvature. Example applications to both model systems and electronic structure calculations are given.
We analyze correlations in step-edge fluctuations using the Bortz-Kalos-Lebowitz kinetic Monte Carlo algorithm, with a 2-parameter expression for energy barriers, and compare with our VT-STM line-scan experiments on spiral steps on Pb(111). The scali
ng of the correlation times gives a dynamic exponent confirming the expected step-edge-diffusion rate-limiting kinetics both in the MC and in the experiments. We both calculate and measure the temperature dependence of (mass) transport properties via the characteristic hopping times and deduce therefrom the notoriously-elusive effective energy barrier for the edge fluctuations. With a careful analysis we point out the necessity of a more complex model to mimic the kinetics of a Pb(111) surface for certain parameter ranges.
We have made experimental observations of the force networks within a two-dimensional granular silo similar to the classical system of Janssen. Models like that of Janssen predict that pressure within a silo saturates with depth as the result of vert
ical forces being redirected to the walls of the silo where they can then be carried by friction. By averaging ensembles of experimentally-obtained force networks in different ways, we compare the observed behavior with various predictions for granular silos. We identify several differences between the mean behavior in our system and that predicted by Janssen-like models: We find that the redirection parameter describing how the force network transfers vertical forces to the walls varies with depth. We find that changes in the preparation of the material can cause the pressure within the silo to either saturate or to continue building with depth. Most strikingly, we observe a non-linear response to overloads applied to the top of the material in the silo. For larger overloads we observe the previously reported giant overshoot effect where overload pressure decays only after an initial increase [G. Ovarlez et al., Phys. Rev. E 67, 060302(R) (2003)]. For smaller overloads we find that additional pressure propagates to great depth. This effect depends on the particle stiffness, as given for instance by the Youngs modulus, E, of the material from which the particles are made. Important measures include E, the unscreened hydrostatic pressure, and the applied load. These experiments suggest that when the load and the particle weight are comparable, particle elasticity acts to stabilize the force network, allowing non-linear network effects to be seen in the mean behavior.
The terminology granular matter refers to systems with a large number of hard objects (grains) of mesoscopic size ranging from millimeters to meters. Geological examples include desert sand and the rocks of a landslide. But the scope of such systems
is much broader, including powders and snow, edible products such a seeds and salt, medical products like pills, and extraterrestrial systems such as the surface regolith of Mars and the rings of Saturn. The importance of a fundamental understanding for granular matter properties can hardly be overestimated. Practical issues of current concern range from disaster mitigation of avalanches and explosions of grain silos to immense economic consequences within the pharmaceutical industry. In addition, they are of academic and conceptual importance as well as examples of systems far from equilibrium. Under many conditions of interest, granular matter flows like a normal fluid. In the latter case such flows are accurately described by the equations of hydrodynamics. Attention is focused here on the possibility for a corresponding hydrodynamic description of granular flows. The tools of nonequilibrium statistical mechanics, developed over the past fifty years for fluids composed of atoms and molecules, are applied here to a system of grains for a fundamental approach to both qualitative questions and practical quantitative predictions. The nonlinear Navier-Stokes equations and expressions for the associated transport coefficients are obtained.
We demonstrate that a highly frustrated anisotropic Josephson junction array(JJA) on a square lattice exhibits a zero-temperature jamming transition, which shares much in common with those in granular systems. Anisotropy of the Josephson couplings al
ong the horizontal and vertical directions plays roles similar to normal load or density in granular systems. We studied numerically static and dynamic response of the system against shear, i. e. injection of external electric current at zero temperature. Current-voltage curves at various strength of the anisotropy exhibit universal scaling features around the jamming point much as do the flow curves in granular rheology, shear-stress vs shear-rate. It turns out that at zero temperature the jamming transition occurs right at the isotropic coupling and anisotropic JJA behaves as an exotic fragile vortex matter : it behaves as superconductor (vortex glass) into one direction while normal conductor (vortex liquid) into the other direction even at zero temperature. Furthermore we find a variant of the theoretical model for the anisotropic JJA quantitatively reproduces universal master flow-curves of the granular systems. Our results suggest an unexpected common paradigm stretching over seemingly unrelated fields - the rheology of soft materials and superconductivity.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
