اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSPH Simulations of Accretion Flows onto the Supermassive Binary Black Holes from the Circumbinary Disks
232
0
0.0
(
0
)
تأليف
Kimitake Hayasaki
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We investigate the accretion flows onto the supermassive binary black holes (SMBBHs) from the circumbinary disk with the equal mass, eccentric binary on the subparsec scale, using Smoothed Particle Hydrodynamics (SPH) code. We find that the material can be supplied from circumbinary disk, which leads to the formation of two accretion disks around the SMBBHs. The mass accretion rates significantly modulate with the binary orbital motion. These could provide the observable diagnosis of the existence of the supermassive binary black holes (e.g. OJ287) on the subparsec scale in merged galactic nuclei.
قيم البحث
اقرأ أيضاً
As 2 black holes bound to each other in a close binary approach merger their inspiral time becomes shorter than the characteristic inflow time of surrounding orbiting matter. Using an innovative technique in which we represent the changing spacetime
in the region occupied by the orbiting matter with a 2.5PN approximation and the binary orbital evolution with 3.5PN, we have simulated the MHD evolution of a circumbinary disk surrounding an equal-mass non-spinning binary. Prior to the beginning of the inspiral, the structure of the circumbinary disk is predicted well by extrapolation from Newtonian results. The binary opens a low-density gap whose radius is roughly two binary separations, and matter piles up at the outer edge of this gap as inflow is retarded by torques exerted by the binary; nonetheless, the accretion rate is diminished relative to its value at larger radius by only about a factor of 2. During inspiral, the inner edge of the disk at first moves inward in coordination with the shrinking binary, but as the orbital evolution accelerates, the rate at which the inner edge moves toward smaller radii falls behind the rate of binary compression. In this stage, the rate of angular momentum transfer from the binary to the disk slows substantially, but the net accretion rate decreases by only 10-20%. When the binary separation is tens of gravitational radii, the rest-mass efficiency of disk radiation is a few percent, suggesting that supermassive binary black holes in galactic nuclei could be very luminous at this stage of their evolution. If the luminosity were optically thin, it would be modulated at a frequency that is a beat between the orbital frequency of the disks surface density maximum and the binary orbital frequency. However, a disk with sufficient surface density to be luminous should also be optically thick; as a result, the periodic modulation may be suppressed.
We use global three dimensional radiation magneto-hydrodynamical simulations to study accretion disks onto a $5times 10^8M_{odot}$ black hole with accretion rates varying from $sim 250L_{Edd}/c^2$ to $1500 L_{Edd}/c^2$. We form the disks with torus c
entered at $50-80$ gravitational radii with self-consistent turbulence initially generated by the magneto-rotational instability. We study cases with and without net vertical magnetic flux. The inner regions of all disks have radiation pressure $sim 10^4-10^6$ times the gas pressure. Non-axisymmetric density waves that steepen into spiral shocks form as gas flows towards the black hole. In simulations without net vertical magnetic flux, Reynolds stress generated by the spiral shocks are the dominant mechanism to transfer angular momentum. Maxwell stress from MRI turbulence can be larger than the Reynolds stress only when net vertical magnetic flux is sufficiently large. Outflows are formed with speed $sim 0.1-0.4c$. When the accretion rate is smaller than $sim 500 L_{Edd}/c^2$, outflows start around $10$ gravitational radii and the radiative efficiency is $sim 5%-7%$ with both magnetic field configurations. With accretion rate reaching $1500 L_{Edd}/c^2$, most of the funnel region close to the rotation axis becomes optically thick and the outflow only develops beyond $50$ gravitational radii. The radiative efficiency is reduced to $1%$. We always find the kinetic energy luminosity associated with the outflow is only $sim 15%-30%$ of the radiative luminosity. The mass flux lost in the outflow is $sim 15%-50%$ of the net mass accretion rates. We discuss implications of our simulation results on the observational properties of these disks.
We use global three dimensional radiation magneto-hydrodynamic simulations to study the properties of inner regions of accretion disks around a 5times 10^8 solar mass black hole with mass accretion rates reaching 7% and 20% of the Eddington value. Th
is region of the disk is supported by magnetic pressure with surface density significantly smaller than the values predicted by the standard thin disk model but with a much larger disk scale height. The disks do not show any sign of thermal instability over many thermal time scales. More than half of the accretion is driven by radiation viscosity in the optically thin corona region for the lower accretion rate case, while accretion in the optically thick part of the disk is driven by the Maxwell and Reynolds stresses from MRI turbulence. Coronae with gas temperatures > 10^8 K are generated only in the inner approx 10 gravitational radii in both simulations, being more compact in the higher accretion rate case. In contrast to the thin disk model, surface density increases with increasing mass accretion rate, which causes less dissipation in the optically thin region and a relatively weaker corona. The simulation results may explain the formation of X-ray coronae in Active Galactic Nuclei (AGNs), the compact size of such coronae, and the observed trend of optical to X-ray luminosity with Eddington ratio for many AGNs.
Nonlinear time-dependent calculations are being carried out in order to study the evolution of vertically-integrated models of non-selfgravitating, transonic accretion discs around black holes. In this paper we present results from a new calculation
for a high-alpha model similar to one studied previously by Honma, Matsumoto and Kato who found evidence for limit-cycle behaviour connected with thermal instability. Our results are in substantial agreement with theirs but, in our calculation, the disc material does not always remain completely optically thick and we include a suitable treatment for this. We followed the evolution for several cycles and determined the period of the cycle as being about 780 seconds. Advective cooling is dominant in the region just behind the outward-moving peak of surface density. The behaviour of this model is significantly different from what we saw earlier for low-alpha models (which we discussed in a previous paper) and we contrast and compare the two situations.
These notes resulted from a series of lectures at the IAC winter school. They are designed to help students, especially those just starting in subject, to get hold of the fundamental tools used to study accretion powered sources. As such, the referen
ces give a place to start reading, rather than representing a complete survey of work done in the field. I outline Compton scattering and blackbody radiation as the two predominant radiation mechanisms for accreting black holes, producing the hard X-ray tail and disc spectral components, respectively. The interaction of this radiation with matter can result in photo-electric absorption and/or reflection. While the basic processes can be found in any textbook, here I focus on how these can be used as a toolkit to interpret the spectra and variability of black hole binaries (hereafter BHB) and Active Galactic Nuclei (AGN). I also discuss how to use these to physically interpret real data using the publicly available XSPEC spectral fitting package (Arnaud et al 1996), and how this has led to current models (and controversies) of the accretion flow in both BHB and AGN.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
