ترغب بنشر مسار تعليمي؟ اضغط هنا

3D convection simulations of the outer layers of the Sun using realistic physics

44   0   0.0 ( 0 )
 نشر من قبل Linghuai Li
 تاريخ النشر 2002
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

This paper describes a series of 3D simulations of shallow inefficient convection in the outer layers of the Sun. The computational domain is a closed box containing the convection-radiation transition layer, located at the top of the solar convection zone. The most salient features of the simulations are that: i)The position of the lower boundary can have a major effect on the characteristics of solar surface convection (thermal structure, kinetic energy and turbulent pressure). ii)The width of the box has only a minor effect on the thermal structure, but a more significant effect on the dynamics (rms velocities). iii)Between the surface and a depth of 1 Mm, even though the density and pressure increase by an order of magnitude, the vertical correlation length of vertical velocity is always close to 600 km. iv) In this region the vertical velocity cannot be scaled by the pressure or the density scale height. This casts doubt on the applicability of the mixing length theory, not only in the superadiabatic layer, but also in the adjacent underlying layers. v) The final statistically steady state is not strictly dependent on the initial atmospheric stratification.

قيم البحث

اقرأ أيضاً

Compared to the Sun, the atmospheric structure and convective flow in Procyon A exhibit the following characteristics: (1) the highly superadiabatic transition layer (SAL) is located at much shallower optical depth; it is in a dynamically active regi on, and its outer region is located part of the time in the optically thin atmosphere; (2) the outer region of the SAL moves from an optically thin region to thick region and back again over a time of 20-30 minutes. This motion, which is driven by the granulation, takes place in a time approximately half the turnover time of the largest granules; The main reason for the radically different radiative-convective behaviour in Procyon A compared to the Sun is the role played by turbulent eddies in determining the overall flow/thermal structure. The turbulent pressure and turbulent kinetic energy can exceed 50 % of the local gas pressure (compared to about 10-20 % in the Sun). The Procyon A simulation thus reveals two distinct timescales - the autocorrelation time of the vertical velocity and the characteristic timescale of the SAL which is tied to granulation. Just below the surface the autocorrelation decay time is about 5 minutes in Procyon A, and the SAL motion timescale is 20-30 mins. When the SAL penetrates the optically thin region there are efficient radiative losses and the peak of the SAL is low. We speculate that these losses damp out the relative amplitudes in luminosity (temperature fluctuations) compared to velocity (Doppler). Although this will not affect the frequencies of the peaks in the power spectrum, it will probably lower the average amplitude of the peaks relative to the noise background.
66 - Kaloyan Penev 2006
The development of 2D and 3D simulations of solar convection has lead to a picture of convection quite unlike the usually assumed Kolmogorov spectrum turbulent flow. We investigate the impact of this changed structure on the dissipation properties of the convection zone, parametrized by an effective viscosity coefficient. We use an expansion treatment developed by Goodman & Oh 1997, applied to a numerical model of solar convection (Robinson et al. 2003) to calculate an effective viscosity as a function of frequency and compare this to currently existing prescriptions based on the assumption of Kolmogorov turbulence (Zahn 1966, Goldreich & Keeley 1977). The results match quite closely a linear scaling with period, even though this same formalism applied to a Kolmogorov spectrum of eddies gives a scaling with power-law index of 5/3.
The partial ionization of the solar plasma causes several nonideal effects such as the ambipolar diffusion, the Hall effect, and the Biermann battery effect. Here we report on the first three-dimensional realistic simulations of solar local dynamo wh ere all three effects were taken into account. The simulations started with a snapshot of already saturated battery-seeded dynamo, where two new series were developed: one with solely ambipolar diffusion and another one also taking into account the Hall term in the generalized Ohms law. The simulations were then run for about 4 hours of solar time to reach the stationary regime and improve the statistics. In parallel, a purely MHD dynamo simulation was also run for the same amount of time. The simulations are compared in a statistical way. The results show that, with the inclusion of the ambipolar diffusion, the amplitudes of the incompressible perturbations related to Alfven waves are reduced, and the Poynting flux is absorbed, with a frequency dependence. The Hall effect causes the opposite action: significant excess of incompressible perturbations is generated and an excess of the Poynting flux is observed in the chromospheric layers. The model with ambipolar diffusion shows, on average, sharper current sheets and slightly more abundant fast magneto-acoustic shocks in the chromosphere. The model with the Hall effect has higher temperatures at the lower chromosphere and stronger and more vertical magnetic field concentrations all over the chromosphere. The study of high-frequency waves reveals that significant power of incompressible perturbations is associated with areas with intense and more vertical magnetic fields and larger temperatures. We find a positive correlation between the magnitude of the ambipolar heating and the temperature increase at the same location after a characteristic time of 10^2 sec.
The solar atmosphere is extremely dynamic, and many important phenomena develop on small scales that are unresolved in observations with the Helioseismic and Magnetic Imager (HMI) instrument on the Solar Dynamics Observatory (SDO). For correct calibr ation and interpretation of the observations, it is very important to investigate the effects of small-scale structures and dynamics on the HMI observables, such as Doppler shift, continuum intensity, spectral line depth, and width. We use 3D radiative hydrodynamics simulations of the upper turbulent convective layer and the atmosphere of the Sun, and a spectro-polarimetric radiative transfer code to study observational characteristics of the Fe I 6173A line observed by HMI in quiet-Sun regions. We use the modeling results to investigate the sensitivity of the line Doppler shift to plasma velocity, and also sensitivities of the line parameters to plasma temperature and density, and determine effective line formation heights for observations of solar regions located at different distances from the disc center. These estimates are important for the interpretation of helioseismology measurements. In addition, we consider various center-to-limb effects, such as convective blue-shift, variations of helioseismic travel-times, and the concave Sun effect, and show that the simulations can qualitatively reproduce the observed phenomena, indicating that these effects are related to a complex interaction of the solar dynamics and radiative transfer.
We analyze the evolution of shock waves in high-resolution 3D radiative MHD simulations of the quiet Sun and their synthetic emission characteristics. The simulations model the dynamics of a 12.8x12.8x15.2 Mm quiet-Sun region (including a 5.2 Mm laye r of the upper convection zone and a 10 Mm atmosphere from the photosphere to corona) with an initially uniform vertical magnetic field of 10 G, naturally driven by convective flows. We synthesize the Mg II and C II spectral lines observed by the IRIS satellite and EUV emission observed by the SDO/AIA telescope. Synthetic observations are obtained using the RH1.5D radiative transfer code and temperature response functions at both the numerical and instrumental resolutions. We found that the Doppler velocity jumps of the C II 1334.5 A IRIS line and a relative enhancement of the emission in the 335 A SDO/AIA channel are the best proxies for the enthalpy deposited by shock waves into the corona (with Kendalls $tau$ correlation coefficients of 0.59 and 0.38, respectively). The synthetic emission of the lines and extreme ultraviolet passbands are correlated with each other during the shock wave propagation. All studied shocks are mostly hydrodynamic (i.e., the magnetic energy carried by horizontal fields is $leq{}$2.6% of the enthalpy for all events) and have Mach numbers > 1.0-1.2 in the low corona. The study reveals the possibility of diagnosing energy transport by shock waves into the solar corona, as well as their other properties, by using IRIS and SDO/AIA sensing observations.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا