اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBand gap of two-dimensional materials: thorough assessment of modern exchange-correlation functionals
122
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The density functional theory (DFT) approximations that are the most accurate for the calculation of band gap of bulk materials are hybrid functionals like HSE06, the MBJ potential, and the GLLB-SC potential. More recently, generalized gradient approximations (GGA), like HLE16, or meta-GGAs, like (m)TASK, have proven to be also quite accurate for the band gap. Here, the focus is on 2D materials and the goal is to provide a broad overview of the performance of DFT functionals by considering a large test set of 298 layered systems. The present work is an extension of our recent studies [Rauch et al., Phys. Rev. B 101, 245163 (2020) and Patra et al., J. Phys. Chem. C 125, xxxxx (2021)]. Due to the lack of experimental results for the band gap of 2D systems, $G_{0}W_{0}$ results were taken as reference. It is shown that the GLLB-SC potential and mTASK functional provide the band gaps that are the closest to $G_{0}W_{0}$. Following closely, the local MBJ potential has a pretty good accuracy that is similar to the accuracy of the more expensive hybrid functional HSE06.
قيم البحث
اقرأ أيضاً
Low-dimensional materials differ from their bulk counterpart in many respects. In particular, the screening of the Coulomb interaction is strongly reduced, which can have important consequences such as the significant increase of exciton binding ener
gies. In bulk materials the binding energy is used as an indicator in optical spectra to distinguish different kinds of excitons, but this is not possible in low-dimensional materials, where the binding energy is large and comparable in size for excitons of very different localization. Here we demonstrate that the exciton band structure, which can be accessed experimentally, instead provides a powerful way to identify the exciton character. By comparing the ab initio solution of the many-body Bethe-Salpeter equation for graphane and single-layer hexagonal BN, we draw a general picture of the exciton dispersion in two-dimensional materials, highlighting the different role played by the exchange electron-hole interaction and by the electronic band structure. Our interpretation is substantiated by a prediction for phosphorene.
Identification and design of defects in two-dimensional (2D) materials as promising single photon emitters (SPE) requires a deep understanding of underlying carrier recombination mechanisms. Yet, the dominant mechanism of carrier recombination at def
ects in 2D materials has not been well understood, and some outstanding questions remain: How do recombination processes at defects differ between 2D and 3D systems? What factors determine defects in 2D materials as excellent SPE at room temperature? In order to address these questions, we developed first-principles methods to accurately calculate the radiative and non-radiative recombination rates at defects in 2D materials, using h-BN as a prototypical example. We reveal the carrier recombination mechanism at defects in 2D materials being mostly dominated by defect-defect state recombination in contrast to defect-bulk state recombination in most 3D semiconductors. In particular, we disentangle the non-radiative recombination mechanism into key physical quantities: zero-phonon line (ZPL) and Huang-Rhys factor. At the end, we identified strain can effectively tune the electron-phonon coupling at defect centers and drastically change non-radiative recombination rates. Our theoretical development serves as a general platform for understanding carrier recombination at defects in 2D materials, while providing pathways for engineering of quantum efficiency of SPE.
We have predicted a new phase of nitrogen with octagon structure in our previous study, which we referred to as octa-nitrogene (ON). In this work, we make further investigation on its electronic structure. The phonon band structure has no imaginary p
honon modes, which indicates that ON is dynamically stable. Using ab initio molecular dynamic simulations, the structure is found to stable up to 100K, and ripples that are similar to that of graphene is formed on the ON sheet. Based on DFT calculation on its band structure, single layer ON is a 2D large-gap semiconductor with a band gap of 4.7eV. Because of inter-layer interaction, stackings can decrease the band gap. Biaxial tensile strain and perpendicular electric field can greatly influence the band structure of ON, in which the gap decreases and eventually closes as the biaxial tensile strain or the perpendicular electric field increases. In other words, both biaxial tensile strain and perpendicular electric field can drive the insulator-to-metal transition, and thus can be used to engineer the band gap of ON. From our results, ON has potential applications in the electronics, semiconductors, optics and spintronics, and so on.
An analysis of the optical response of a triangular-shaped photonic band-gap prism is presented. Numerical simulations have been performed in the framework of multiple-scattering theory, which is applied considering spot illumination to avoid diffrac
tion effects. First of all, refractive properties in the frequency range below the first TM band-gap are analyzed and compared with the available experimental data. It validates the approach employed and supports the predictions obtained in the frequency range above the gap. At these high frequencies we found an unusual superprism effect characterized by an angle- and frequency-sensitivity of the intensity of outgoing beams. We report several representative examples that could be used in device applications. The results are interpreted in terms of the corresponding semi-infinite photonic crystal, through the analysis of the coupling between external radiation and bulk eigenmodes, using the 2D Layer- Korringa-Kohn-Rostoker method. The procedure presented here constitutes a simple but functional alternative to the methods used until now with the same purpose.
We report a strain-induced direct-to-indirect band gap transition in mechanically deformed WS2 monolayers (MLs). The necessary amount of strain is attained by proton irradiation of bulk WS2 and the ensuing formation of one-ML-thick, H2-filled domes.
The electronic properties of the curved MLs are mapped by spatially- and time-resolved micro-photoluminescence revealing the mechanical stress conditions that trigger the variation of the band gap character. This general phenomenon, also observed in MoS2 and WSe2, further increases our understanding of the electronic structure of transition metal dichalcogenide MLs and holds a great relevance for their optoelectronic applications.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
