اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDynamics of thermal and wetting footprint of a volatile droplet during Leidenfrost transition
167
0
0.0
(
0
)
تأليف
Vikash Kumar
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The levitation of a volatile droplet on a highly superheated surface is known as the Leidenfrost effect. Wetting state during transition from full wetting of a surface by a droplet at room temperature to Leidenfrost bouncing, i.e., zero-wetting at high superheating, is not fully understood. Here, visualizations of droplet thermal and wetting footprint in the Leidenfrost transition state are presented using two optical techniques: mid-infrared thermography and wetting sensitive total internal reflection imaging under carefully selected experimental conditions, impact Weber number < 10 and droplet diameter < capillary length, using an indium-tin-oxide coated sapphire heater. The experimental regime was designed to create relatively stable droplet dynamics, where the effects of oscillatory and capillary instabilities were minimized. The thermography for ethanol droplet in Leidenfrost transition state (superheat range of 82K-97K) revealed thermal footprint with a central hot zone surrounded by a cooler periphery, indicative of a partial wetting state during Leidenfrost transition. High-speed total internal reflection imaging also confirmed the partial wetting footprint such that there are wetting areas around a central non-wetting zone. Result presented here using ethanol as a test fluid shed light on the geometry and dynamics of a volatile droplet footprint in Leidenfrost transition state.
قيم البحث
اقرأ أيضاً
Volatile drops deposited on a hot solid can levitate on a cushion of their own vapor, without contacting the surface. We propose to understand the onset of this so-called Leidenfrost effect through an analogy to non-equilibrium systems exhibiting a d
irected percolation phase transition. When performing impacts on superheated solids, we observe a regime of spatiotemporal intermittency in which localized wet patches coexist with dry regions on the substrate. We report a critical surface temperature, which marks the upper bound of a large range of temperatures in which levitation and contact coexist. In this range, with decreasing temperature, the equilibrium wet fraction increases continuously from zero to one. Also, the statistical properties of the spatio-temporally intermittent regime are in agreement with that of the directed percolation universality class. This analogy allows us to redefine the Leidenfrost temperature and shed light on the physical mechanisms governing the transition to the Leidenfrost state.
Modification and control over the vaporization kinetics of microfluidic droplets may have strong utilitarian implications in several scientific and technological applications. The article reports the control over the vaporization kinetics of pendent
droplets under the influence of competing internal electrohydrodynamic and ferrohydrodynamic advection. Experimental and theoretical studies are performed and the morphing of vaporization kinetics of electrically conducting and paramagnetic fluid droplets using orthogonal electric and magnetic stimuli is established. Analysis of the observations reveals that the electric field has a domineering influence compared to the magnetic field. While the magnetic field is noted to aid the vaporization rates, the electric field is observed to decelerate the same. Neither the vapour diffusion dominated kinetics nor the field induced modified surface tension can explain the observed vaporization behaviours. Velocimetry within the droplet shows largely modified internal ferro and electrohydrodynamic advection, which is noted to be the crux of the mechanism towards modified vaporization rates. A mathematical treatment is proposed and takes into account the roles played by the governing Hartmann, electrohydrodynamic, interaction, the thermal and solutal Marangoni, and the electro and magneto Prandtl and Schmidt numbers. It is observed that the morphing of the thermal and solutal Marangoni numbers by the electromagnetic interaction number plays the dominant role towards morphing the advection dynamics. The model is able to predict the internal advection velocities accurately. The findings may hold significant promise towards smart control and tuning of vaporization kinetics in microhydrodynamics transport paradigms.
Droplet migration in a Hele--Shaw cell is a fundamental multiphase flow problem which is crucial for many microfluidics applications. We focus on the regime at low capillary number and three-dimensional direct numerical simulations are performed to i
nvestigate the problem. In order to reduce the computational cost, an adaptive mesh is employed and high mesh resolution is only used near the interface. Parametric studies are performed on the droplet horizontal radius and the capillary number. For droplets with an horizontal radius larger than half the channel height the droplet overfills the channel and exhibits a pancake shape. A lubrication film is formed between the droplet and the wall and particular attention is paid to the effect of the lubrication film on the droplet velocity. The computed velocity of the pancake droplet is shown to be lower than the average inflow velocity, which is in agreement with experimental measurements. The numerical results show that both the strong shear induced by the lubrication film and the three-dimensional flow structure contribute to the low mobility of the droplet. In this low-migration-velocity scenario the interfacial flow in the droplet reference frame moves toward the rear on the top and reverses direction moving to the front from the two side edges. The velocity of the pancake droplet and the thickness of the lubrication film are observed to decrease with capillary number. The droplet velocity and its dependence on capillary number cannot be captured by the classic Hele--Shaw equations, since the depth-averaged approximation neglects the effect of the lubrication film.
To understand the behavior of composite fluid particles such as nucleated cells and double-emulsions in flow, we study a finite-size particle encapsulated in a deforming droplet under shear flow as a model system. In addition to its concentric partic
le-droplet configuration, we numerically explore other eccentric and time-periodic equilibrium solutions, which emerge spontaneously via supercritical pitchfork and Hopf bifurcations. We present the loci of these solutions around the codimenstion-two point. We adopt a dynamical system approach to model and characterize the coupled behavior of the two bifurcations. By exploring the flow fields and hydrodynamic forces in detail, we identify the role of hydrodynamic particle-droplet interaction which gives rise to these bifurcations.
A liquid droplet, immersed into a Newtonian fluid, can be propelled solely by internal flow. In a simple model, this flow is generated by a collection of point forces, which represent externally actuated devices or model autonomous swimmers. We work
out the general framework to compute the self-propulsion of the droplet as a function of the actuating forces and their positions within the droplet. A single point force, F with general orientation and position, r_0, gives rise to both, translational and rotational motion of the droplet. We show that the translational mobility is anisotropic and the rotational mobility can be nonmonotonic as a function of | r_0|, depending on the viscosity contrast. Due to the linearity of the Stokes equation, superposition can be used to discuss more complex arrays of point forces. We analyse force dipoles, such as a stresslet, a simple model of a biflagellate swimmer and a rotlet, representing a helical swimmer, driven by an external magnetic field. For a general force distribution with arbitrary high multipole moments the propulsion properties of the droplet depend only on a few low order multipoles: up to the quadrupole for translational and up to a special octopole for rotational motion. The coupled motion of droplet and device is discussed for a few exemplary cases. We show in particular that a biflagellate swimmer, modeled as a stresslet, achieves a steady comoving state, where the position of the device relative to the droplet remains fixed. In fact there are two fixpoints, symmetric with respect to the center of the droplet. A tiny external force selects one of them and allows to switch between forward and backward motion.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
