اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBeirut explosion: Energy yield from the fireball time evolution in the first 230 milliseconds
75
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The evolution of the fireball resulting from the August 2020 Beirut explosion is traced using amateur footage taken during the first $sim$ 230 $ms$ after the detonation. 38 frames separated by $sim$ 16.66 - 33.33 $ms$ are extracted from 6 different videos located precisely on the map. Measurements of the time evolution of the radius $R_{t}$ of the shock wave are traced by the fireball at consecutive time sequence $t$. Pixel scales for the videos are calibrated by de-projecting the existing grains silos building for which accurate drawings are available and by defining the line of sight incident angles. The energy available to drive the shock wave at early times can be calculated through $E = 10^{2b} K rho_{o}$ where $b$ is a fitted parameter dependant on the relation between $R_t$ and $t$. $K$ is a constant depending on the ratio of specific heats of the atmosphere and $rho_0$ is the undisturbed gas density. A total energy yield of $E approx 1.3times 10^{12}$ Joules with a lower bound of $9.8times 10^{11}$ and an upper bound of $sim 1.7times 10^{12}$ or the equivalent of $sim 310_{235}^{405}$ tons of T.N.T. is found. Our energy yields are different from other published studies using the same method. This can present an argument that if the compound that exploded is fuel rich ammonium nitrate (ANFO), then the actual mass that detonated is less than officially claimed.
قيم البحث
اقرأ أيضاً
We identify the major physics milestones in the development of strange hadrons as an observable for both the formation of quark-gluon plasma, and of the ensuing explosive disintegration of deconfined matter fireball formed in relativistic heavy ion c
ollisions at 160--20A GeV. We describe the physical properties of QGP phase and show agreement with the expectations based on an analysis of hadron abundances. We than also demonstrate that the m_t shape of hadron spectra is in qualitative agreement with the sudden breakup of a supercooled QGP fireball.
A simple analytical/numerical model has been developed for computing the evolution, over periods of up to a few hours, of the current and temperature profile in the upper layer of the ocean. The model is based upon conservation laws for heat and mome
ntum, and employs an eddy diffusion parameterisation which is dependent on both the wind speed and the wind stress applied at the sea surface. Other parameters such as the bulk-skin surface temperature difference and CO$_2$ flux are determined by application of the Molecular Oceanic Boundary Layer Model (MOBLAM) of Schluessel and Soloviev. A similar model, for the current profile only, predicts a temporary increase in wave breaking intensity and decrease in wave height under conditions where the wind speed increases suddenly, such as, for example, during gusts and squalls. The model results are compared with measurements from the lagrangian Skin Depth Experimental Profiler (SkinDeEP) surface profiling instrument made during the 1999 MOCE-5 field experiment in the waters around Baja California. SkinDeEP made repeated profiles of temperature within the upper few metres of the water column. Given that no tuning was performed in the model, and that the model does not take account of stratification, the results of the model runs are in rather good agreement with the observations. The model may be suitable as an interface between time-independent models of processes very near the surface, and larger-scale three-dimensional time-dependent ocean circulation models. A straightforward extension of the model should also be suitable for making time-dependent computations of gas concentration in the near-surface layer of the ocean.
4D acoustic imaging via an array of 32 sources / 32 receivers is used to monitor hydraulic fracture propagating in a 250~mm cubic specimen under a true-triaxial state of stress. We present a method based on the arrivals of diffracted waves to reconst
ruct the fracture geometry (and fluid front when distinct from the fracture front). Using Bayesian model selection, we rank different possible fracture geometries (radial, elliptical, tilted or not) and estimate model error. The imaging is repeated every 4 seconds and provide a quantitative measurement of the growth of these low velocity fractures. We test the proposed method on two experiments performed in two different rocks (marble and gabbro) under experimental conditions characteristic respectively of the fluid lag-viscosity (marble) and toughness (gabbro) dominated hydraulic fracture propagation regimes. In both experiments, about 150 to 200 source-receiver combinations exhibit clear diffracted wave arrivals. The results of the inversion indicate a radial geometry evolving slightly into an ellipse towards the end of the experiment when the fractures feel the specimen boundaries. The estimated modelling error with all models is of the order of the wave arrival picking error. Posterior estimates indicate an uncertainty of the order of a millimeter on the fracture front location for a given acquisition sequence. The reconstructed fracture evolution from diffracted waves is shown to be consistent with the analysis of $90^{circ}$ incidence transmitted waves across the growing fracture.
We consider the long-time evolution of pulses in the Korteweg-de Vries equation theory for initial distributions which produce no soliton, but instead lead to the formation of a dispersive shock wave and of a rarefaction wave. An approach based on Wh
itham modulation theory makes it possible to obtain an analytic description of the structure and to describe its self-similar behavior near the soliton edge of the shock. The results are compared with numerical simulations.
In each rowing sport, the oars have their very own characteristics most of the time selected through a long time experience. Here we address experimentally and theoretically the problem of rowing efficiency as function of row lengths and blades sizes
. In contrast with previous studies which consider imposed kinematics, we set an imposed force framework which is closer to human constraints. We find that optimal row lengths and blades sizes depend on sports and athletes strength, and provide an optimisation scheme.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
