اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدInfluence of the vicinal substrate miscut on the anisotropic two-dimensional electronic transport in Al2O3-SrTiO3 heterostructures
91
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The electrical resistance of the two-dimensional electron system (2DES) which forms at the interface of SrTiO3 (STO)-based heterostructures displays anisotropic transport with respect to the direction of current flow at low temperature. We have investigated the influence of terraces at the surface of STO substrates from which the 2DES are prepared. Such terraces are always present in commercially available STO substrates due to the tolerance of surface preparation which result in small miscut angles of the order of gamma ~ 0.1{deg} with respect to the surface normal. By a controlled increase of the substrate miscut we could systematically reduce the width of the terraces and thereby increase the density of substrate surface steps. The in-plane anisotropy of the electrical resistance was studied as a function of the miscut angle gamma and found to be mainly related to interfacial scattering arising from the substrate surface steps. However, the influence of gamma was notably reduced by the occurrence of step-bunching and lattice-dislocations in the STO substrate material. Magnetoresistance (MR) depends on the current orientation as well, reflecting the anisotropy of carrier mobility. For gamma >= 2{deg}, MR is substantially enhanced and shows the trend towards a linear field dependence which is typical for inhomogeneous conductors. From weak-antilocalization observed at small magnetic field we deduce information on inelastic scattering and spin-orbit coupling. While the field scale associated with a Rashba-type spin-orbit coupling in 2D weak-localization does not show a pronounced correlation with gamma, distinct changes of the scale are associated with inelastic scattering.
قيم البحث
اقرأ أيضاً
Transport measurements on the two dimensional electron system in Al2O3 SrTiO3 heterostructures indicate significant noncrystalline anisotropic behavior below T = 30 K. Lattice dislocations in SrTiO3 and interfacial steps are suggested to be the main
sources for electronic anisotropy. Anisotropic defect scattering likewise alters magnetoresistance at low temperature remarkably and influences spin-orbit coupling significantly by the Elliot Yafet mechanism of spin relaxation resulting in anisotropic weak localization. Applying a magnetic field parallel to the interface results in an additional field induced anisotropy of the conductance, which can be attributed to Rashba spin orbit interaction. Compared to LaAlO3 SrTiO3, Rashba coupling seems to be reduced indicating a weaker polarity in Al2O3 SrTiO3 heterostructures.
Herein, we reported giant tunability of the physical properties of 2DEGs at the spinel/perovskite interface of {gamma}-Al2O3/SrTiO3 (GAO/STO). By modulating the carrier density thus the band filling with ionic-liquid gating, the system experiences a
Lifshitz transition at a critical carrier density of 3E13 cm-2, where a remarkably strong enhancement of Rashba spin-orbit interaction and an emergence of Kondo effect at low temperatures are observed. Moreover, as the carrier concentration depletes with decreasing gating voltage, the electron mobility is enhanced by more than 6 times in magnitude, leading to the observation of clear quantum oscillations. The great tunability of GAO/STO interface by EDLT gating not only shows promise for design of oxide devices with on-demand properties, but also sheds new light on the electronic structure of 2DEG at the non-isostructural spinel/perovskite interface.
The relative importance of atomic defects and electron transfer in explaining conductivity at the crystalline LaAlO3/SrTiO3 interface has been a topic of debate. Metallic interfaces with similar electronic properties produced by amorphous oxide overl
ayers on SrTiO3 have called in question the original polarization catastrophe model. We resolve the issue by a comprehensive comparison of (100)-oriented SrTiO3 substrates with crystalline and amorphous overlayers of LaAlO3 of different thicknesses prepared under different oxygen pressures. For both types of overlayers, there is a critical thickness for the appearance of conductivity, but its value is always 4 unit cells (around 1.6 nm) for the oxygen-annealed crystalline case, whereas in the amorphous case, the critical thickness could be varied in the range 0.5 to 6 nm according to the deposition conditions. Subsequent ion milling of the overlayer restores the insulating state for the oxygen-annealed crystalline heterostructures but not for the amorphous ones. Oxygen post-annealing removes the oxygen vacancies, and the interfaces become insulating in the amorphous case. However, the interfaces with a crystalline overlayer remain conducting with reduced carrier density. These results demonstrate that oxygen vacancies are the dominant source of mobile carriers when the LaAlO3 overlayer is amorphous, while both oxygen vacancies and polarization catastrophe contribute to the interface conductivity in unannealed crystalline LaAlO3/SrTiO3 heterostructures, and the polarization catastrophe alone accounts for the conductivity in oxygen-annealed crystalline LaAlO3/SrTiO3 heterostructures. Furthermore, we find that the crystallinity of the LaAlO3 layer is crucial for the polarization catastrophe mechanism in the case of crystalline LaAlO3 overlayers.
Interface engineering is an extremely useful tool for systematically investigating materials and the various ways materials interact with each other. We describe different interface engineering strategies designed to reveal the origin of the electric
and magnetic dead-layer at La0.67Sr0.33MnO3 interfaces. La0.67Sr0.33MnO3 is a key example of a strongly correlated peroskite oxide material in which a subtle balance of competing interactions gives rise to a ferromagnetic metallic groundstate. This balance, however, is easily disrupted at interfaces. We systematically vary the dopant profile, the disorder and the oxygen octahedra rotations at the interface to investigate which mechanism is responsible for the dead layer. We find that the magnetic dead layer can be completely eliminated by compositional interface engineering such that the polar discontinuity at the interface is removed. This, however, leaves the electrical dead-layer largely intact. We find that deformations in the oxygen octahedra network at the interface are the dominant cause for the electrical dead layer.
Electronic transport near the insulator-metal transition is investigated in the molecular beam epitaxy-grown SrTiO3/Nd1-xTiO3/SrTiO3 heterostructures using temperature dependent magnetotransport measurements. It was found that Nd-vacancies introduce
localized electronic states resulting in the variable range hopping transport at low temperatures. At a fixed Nd-vacancies concentration, a crossover from Mott to Efros-Shklovskii (ES) variable range hopping transport was observed with decreasing temperature. With increasing disorder, a sign reversal of magnetoresistance from positive to negative was observed revealing interplay between intra-state interaction and the energy dependence of the localization length as a function of disorder. These findings highlight the important role of stoichiometry when exploring intrinsic effect using heterostructure and interfaces in addition to offering broad opportunity to tailor low temperature transport using non-stoichiometry defects.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
