اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn the Power Leakage Problem in Millimeter-Wave Massive MIMO with Lens Antenna Arrays
124
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The emerging millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) with lens antenna arrays, which is also known as beamspace MIMO, can effectively reduce the required number of power-hungry radio frequency (RF) chains. Therefore, it has been considered as a promising technique for the upcoming 5G communications and beyond. However, most current studies on beamspace MIMO have not taken into account the important power leakage problem in beamspace channels, which possibly leads to a significant degradation in the signal-to-noise ratio (SNR) and the system sum-rate. To this end, we propose a beam aligning precoding method to handle the power leakage problem in this paper. Firstly, a phase shifter network (PSN) structure is proposed, which enables each RF chain in beamspace MIMO to select multiple beams to collect the leakage power. Then, a rotation-based precoding algorithm is designed based on the proposed PSN structure, which aligns the channel gains of the selected beams towards the same direction for maximizing the received SNR at each user. Furthermore, we reveal some system design insights by analyzing the sum-rate and energy efficiency (EE) of the proposed beam aligning precoding method. In simulations, the proposed approach is found to achieve the near-optimal sum-rate performance compared with the ideal case of no power leakage, and obtains a higher EE than the existing schemes with either a linear or planar array.
قيم البحث
اقرأ أيضاً
Millimeter-wave massive MIMO with lens antenna array can considerably reduce the number of required radio-frequency (RF) chains by beam selection. However, beam selection requires the base station to acquire the accurate information of beamspace chan
nel. This is a challenging task, as the size of beamspace channel is large while the number of RF chains is limited. In this paper, we investigate the beamspace channel estimation problem in mmWave massive MIMO systems with lens antenna array. Specifically, we first design an adaptive selecting network for mmWave massive MIMO systems with lens antenna array, and based on this network, we further formulate the beamspace channel estimation problem as a sparse signal recovery problem. Then, by fully utilizing the structural characteristics of mmWave beamspace channel, we propose a support detection (SD)-based channel estimation scheme with reliable performance and low pilot overhead. Finally, the performance and complexity analyses are provided to prove that the proposed SD-based channel estimation scheme can estimate the support of sparse beamspace channel with comparable or higher accuracy than conventional schemes. Simulation results verify that the proposed SD-based channel estimation scheme outperforms conventional schemes and enjoys satisfying accuracy, even in the low SNR region as the structural characteristics of beamspace channel can be exploited.
Millimeter wave (mmWave) communication by utilizing lens antenna arrays is a promising technique for realizing cost-effective 5G wireless systems with large MIMO (multiple-input multiple-output) but only limited radio frequency (RF) chains. This pape
r studies an uplink multi-user mmWave single-sided lens MIMO system, where only the base station (BS) is equipped with a full-dimensional (FD) lens antenna array with both elevation and azimuth angle resolution capabilities, and each mobile station (MS) employs the conventional uniform planar array (UPA) without the lens. By exploiting the angle-dependent energy focusing property of the lens antenna array at the BS as well as the multi-path sparsity of mmWave channels, we propose a low-complexity path division multiple access (PDMA) scheme, which enables virtually interference-free multi-user communications when the angle of arrivals (AoAs) of all MS multi-path signals are sufficiently separable at the BS. To this end, a new technique called path delay compensation is proposed at the BS to effectively transform the multi-user frequency-selective MIMO channels to parallel frequency-flat small-size MIMO channels for different MSs, for each of which the low-complexity single-carrier(SC) transmission is applied. For general scenarios with insufficient AoA separations, analog beamforming at the MSs and digital combining at the BS are jointly designed to maximize the achievable sum-rate of the MSs based on their effective MIMO channels resulting from path delay compensation. In addition, we propose a new and efficient channel estimation scheme tailored for PDMA, which requires negligible training overhead in practical mmWave systems and yet leads to comparable performance as that based on perfect channel state information (CSI).
Millimeter wave (mmWave) communication is a promising technology for the fifth-generation (5G) wireless system. However, the large number of antennas used and the wide signal bandwidth in mmWave systems render the conventional multi-antenna technique
s increasingly costly in terms of signal processing complexity, hardware implementation, and power consumption. In this article, we investigate cost-effective mmWave communications by first providing an overview of the main existing techniques that offer different trade-offs between performance and cost, and then focusing our discussion on a promising new technique based on the advanced lens antenna array. It is revealed that by exploiting the angle-dependent energy focusing property of lens arrays, together with the angular sparsity of the mmWave channels, mmWave lens-antenna system is able to achieve the capacity-optimal performance with very few radio-frequency (RF) chains and using the low-complexity single-carrier transmission, even for wide-band frequency-selective channels. Numerical results show that the lens-based system significantly outperforms the state-of-the-art designs for mmWave systems in both spectrum efficiency and energy efficiency.
The recent concept of beamspace multiple input multiple output (MIMO) can significantly reduce the number of required radio-frequency (RF) chains in millimeter-wave (mmWave) massive MIMO systems without obvious performance loss. However, the fundamen
tal limit of existing beamspace MIMO is that, the number of supported users cannot be larger than the number of RF chains at the same time-frequency resources. To break this fundamental limit, in this paper we propose a new spectrum and energy efficient mmWave transmission scheme that integrates the concept of non-orthogonal multiple access (NOMA) with beamspace MIMO, i.e., beamspace MIMO-NOMA. By using NOMA in beamspace MIMO systems, the number of supported users can be larger than the number of RF chains at the same time-frequency resources. Particularly, the achievable sum rate of the proposed beamspace MIMO-NOMA in a typical mmWave channel model is analyzed, which shows an obvious performance gain compared with the existing beamspace MIMO. Then, a precoding scheme based on the principle of zero-forcing (ZF) is designed to reduce the inter-beam interferences in the beamspace MIMO-NOMA system. Furthermore, to maximize the achievable sum rate, a dynamic power allocation is proposed by solving the joint power optimization problem, which not only includes the intra-beam power optimization, but also considers the inter-beam power optimization. Finally, an iterative optimization algorithm with low complexity is developed to realize the dynamic power allocation. Simulation results show that the proposed beamspace MIMO-NOMA can achieve higher spectrum and energy efficiency compared with existing beamspace MIMO.
The densely packed antennas of millimeter-Wave (mmWave) MIMO systems are often blocked by the rain, snow, dust and even by fingers, which will change the channels characteristics and degrades the systems performance. In order to solve this problem, w
e propose a cross-entropy inspired antenna array diagnosis detection (CE-AAD) technique by exploiting the correlations of adjacent antennas, when blockages occur at the transmitter. Then, we extend the proposed CE-AAD algorithm to the case, where blockages occur at transmitter and receiver simultaneously. Our simulation results show that the proposed CE-AAD algorithm outperforms its traditional counterparts.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
