اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدInternal Dosimetry Assessment for Drinking the Groundwater of the Disi Aquifer
93
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The quest for a better understanding of the cancer risk associated with drinking the radium-contaminated groundwater of the Disi Aquifer in Jordan has become more urgent in recent years. To quantitively identify the health consequences attainable from the consumption of this groundwater source, internal dosimetry analysis was performed with emphasis on doses deliverable to bone surfaces. Moreover, the age-dependent dose calculations performed in this study show that the most critical group is those who are below the age of 15, where we predict an increase in the risk of cancer by up to a factor of 5 as compared to adults. It is also demonstrated that radium radioactivity remains relatively constant in the bone even 10 years after ingestion. The whole-body dose analysis concluded that it is a factor of 5 higher than what the WHO recommends as a limit.
قيم البحث
اقرأ أيضاً
Quantitative interpretation of the tidal response of water levels measured in wells has long been made either with a model for perfectly confined aquifers or with a model for purely unconfined aquifers. However, many aquifers may be neither totally c
onfined nor purely unconfined at the frequencies of tidal loading but behave somewhere between the two end members. Here we present a more general model for the tidal response of groundwater in aquifers with both horizontal and vertical flow. The model has three independent parameters: the transmissivity and storativity of the aquifer and the specific leakage of the leaking aquitard. If transmissivity and storativity are known independently, this model may be used to estimate aquitard leakage from the phase shift and amplitude ratio of water level in wells obtained from tidal analysis. We apply the model to interpret the tidal response of water level in a USGS deep monitoring well installed in the Arbuckle aquifer in Oklahoma, into which massive amount of wastewater co-produced from hydrocarbon exploration has been injected. The analysis shows that the Arbuckle aquifer is leaking significantly at this site. We suggest that the present method may be effectively and economically applied to monitor leakage in groundwater systems, which bears on the safety of water resources, the security of underground waste repositories, and the outflow of wastewater during deep injection and hydrocarbon extraction.
The purpose of this work is to develop viable procedures for verifying the applicability of personalized dosimetry in computed tomography (CT) using Monte Carlo-based simulations. Mobile equipment together with customized software was developed and u
sed for rapid, non-invasive determination of equivalent source models of CT scanners under clinical conditions. Standard and anthropomorphic CT dose phantoms equipped with real-time CT dose probes at five representative positions were scanned. The accumulated dose was measured during the scan at the five positions. ImpactMC, a Monte Carlo-based CT dose software program, was used to simulate the scan. The necessary inputs were obtained from the scan parameters, from the equivalent source models and from the material-segmented CT images of the phantoms. Post-scan 3D dose distributions in the phantoms were simulated and the dose values calculated at the five positions inside the phantom were compared to measured dose values. Initial results were obtained by means of a General Electric Optima CT 660 and a Toshiba (Canon) Aquilion ONE. In general, the measured and calculated dose values were within relative uncertainties that had been estimated to be less than 10%. The procedures developed, which allow the post-CT scan dose to be measured and calculated at five points inside anthropomorphic phantoms, were found to be viable and rapid. The procedures are applicable to any scanner type under clinical conditions. Results show that the procedures are well suited for verifying the applicability of personalized CT dosimetry based on post-scan Monte Carlo calculations.
First investigations regarding dosimetric properties of the hybrid, pixelated, photon-counting Dosepix detector in a pulsed photon field (RQR8) for the personal dose equivalent $Hmathrm{_p(10)}$ are presented. The influence quantities such as pulse d
uration and dose rate were varied, and their responses were compared to the legal limits provided in PTB-A 23.2. The variation of pulse duration at a nearly constant dose rate of 3.7$,$Sv/h shows a flat response around 1.0 from 3.6$,$s down to 2$,$ms. A response close to 1.0 is achieved for dose rates from 0.07$,$mSv/h to 35$,$Sv/h for both pixel sizes. Above this dose rate, the large pixels (220$,mathrm{mu}$m edge length) are below the lower limit. The small pixels (55$,mathrm{mu}$m edge length) stay within limits up to 704$,$Sv/h. The count rate linearity is compared to previous results, confirming the saturating count rate for high dose rates.
While spatial dose conformity delivered to a target volume has been pushed to its practical limits with advanced treatment planning and delivery, investigations in novel temporal dose delivery are unfolding new mechanisms. Recent advances in ultra-hi
gh dose radiotherapy, abbreviated as FLASH, indicate the potential for reduction in healthy tissue damage while preserving tumor control. FLASH therapy relies on very high dose rate of > 40Gy/sec with sub-second temporal beam modulation, taking a seemingly opposite direction from the conventional paradigm of fractionated therapy. FLASH brings unique challenges to dosimetry, beam control, and verification, as well as complexity of radiobiological effective dose through altered tissue response. In this review, we compare the dosimetric methods capable of operating under high dose rate environments. Due to excellent dose-rate independence, superior spatial (~<1 mm) and temporal (~ns) resolution achievable with Cherenkov and scintillation-based detectors, we show that luminescent detectors have a key role to play in the development of FLASH-RT, as the field rapidly progresses towards clinical adaptation. Additionally, we show that the unique ability of certain luminescence-based methods to provide tumor oxygenation maps in real-time with submillimeter resolution can elucidate the radiobiological mechanisms behind the FLASH effect. In particular, such techniques will be crucial for understanding the role of oxygen in mediating the FLASH effect.
Purpose: Beam range control is the essence of radiotherapy with heavy charged particles. In conventional broad-beam delivery, fine range adjustment is achieved by insertion of range shifting and compensating materials. In dosimetry, solid phantoms ar
e often used for convenience. These materials should ideally be equivalent to water. In this study, we evaluated dosimetric water equivalence of four common plastics, HDPE, PMMA, PET, and POM. Methods: Using the Bethe formula for energy loss, the Gottschalk formula for multiple scattering, and the Sihver formula for nuclear interactions, we calculated the effective densities of the plastics for these interactions. We experimentally measured variation of the Bragg peak of carbon-ion beams by insertion of HDPE, PMMA, and POM, which were compared with analytical model calculations. Results: The theoretical calculation resulted in slightly reduced multiple scattering and severely increased nuclear interactions for HDPE, compared to water and the other plastics. The increase in attenuation of carbon ions for 20-cm range shift was experimentally measured to be 8.9% for HDPE, 2.5% for PMMA, and 0.0% for POM while PET was theoretically estimated to be in between PMMA and POM. The agreement between the measurements and the calculations was about 1% or better. Conclusions: For carbon-ion beams, POM was dosimetrically indistinguishable from water and the best of the plastics examined in this study. The poorest was HDPE, which would reduce the Bragg peak by 0.45% per 1-cm range shift, although with marginal superiority for reduced multiple scattering. Between the two clear plastics, PET would be superior to PMMA in dosimetric water equivalence.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
