ترغب بنشر مسار تعليمي؟ اضغط هنا

High-Frequency Gravitational-Wave Detection Using a Chiral Resonant Mechanical Element and a Short Unstable Optical Cavity

247   0   0.0 ( 0 )
 نشر من قبل Surjeet Rajendran
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Present gravitational wave detectors are based on the measurement of linear displacement in stable optical cavities. Here, we instead suggest the measurement of the twist of a chiral mechanical element induced by a gravitational wave. The induced twist rotates a flat optical mirror on top of this chiral element, leading to the deflection of an incident laser beam. This angle change is enhanced by multiple bounces of light between the rotating mirror and an originally parallel nearby fixed flat mirror. Based on detailed continuum-mechanics calculations, we present a feasible design for the chiral mechanical element including the rotating mirror. Our approach is most useful for signals in the frequency band 1 -- 100 kHz where we show that fundamental metrological limits would allow for smaller shot noise in this setup in comparison to the detection of linear displacement. We estimate a gravitational wave strain sensitivity between 10^{-21}/sqrt{Hz} and 10^{-23}/sqrt{Hz} at around 10 kHz frequency. When appropriately scaling the involved geometrical parameters, the strain sensitivity is proportional to frequency.



قيم البحث

اقرأ أيضاً

164 - Asuka Ito , Jiro Soda 2020
In order to detect high frequency gravitational waves, we need a new detection method. In this paper, we develop a formalism for a gravitational wave detector using magnons in a cavity. Using Fermi normal coordinates and taking the non-relativistic l imit, we obtain a Hamiltonian for magnons in gravitational wave backgrounds. Given the Hamiltonian, we show how to use the magnons for detecting high frequency gravitational waves. Furthermore, as a demonstration of the magnon gravitational wave detector, we give upper limits on GHz gravitational waves by utilizing known results of magnon experiments for an axion dark matter search.
This work describes the operation of a High Frequency Gravitational Wave detector based on a cryogenic Bulk Acoustic Wave (BAW) cavity and reports observation of rare events during 153 days of operation over two seperate experimental runs (Run 1 and Run 2). In both Run 1 and Run 2 two modes were simultaneously monitored. Across both runs, the 3rd overtone of the fast shear mode (3B) operating at 5.506 MHz was monitored, while in Run 1 the second mode was chosen to be the 5th OT of the slow shear mode (5C) operating at 8.392 MHz. However, in Run 2 the second mode was selected to be closer in frequency to the first mode, and chosen to be the 3rd overtone of the slow shear mode (3C) operating at 4.993 MHz. Two strong events were observed as transients responding to energy deposition within acoustic modes of the cavity. The first event occurred during Run 1 on the 12/05/2019 (UTC), and was observed in the 5.506 MHz mode, while the second mode at 8.392 MHz observed no event. During Run 2, a second event occurred on the 27/11/2019(UTC) and was observed by both modes. Timing of the events were checked against available environmental observations as well as data from other detectors. Various possibilities explaining the origins of the events are discussed.
A gravitational resonant bar detector with a large scale Fabry-Perot cavity as an optical read out and a mechanical displacement transformer is considered. We calculate, in a fully analytical way, the final receiver bandwidth in which the potential s ensitivity, limited only by the bar thermal noise, is maintained despite the additional thermal noise of the transformer and the additive noise of the optical readout. We discuss also an application to the OGRAN project, where the bar is instrumented with a 2m long FP cavity.
212 - Wei-Tou Ni 2020
A brief history and various themes of mid-frequency gravitational wave detection are presented more or less following historical order -- Laser Interferometry, Atom Interferometry (AI), Torsion Bar Antenna (TOBA), and Superconducting Omni-directional Gravitational Radiation Observatory (SOGRO). Both Earth-based and Space-borne concepts are reviewed with outlook on expected astrophysical sources
A recent proposal describes space based gravitational wave (GW) detection with optical lattice atomic clocks [Kolkowitz et. al., Phys. Rev. D 94, 124043 (2016)] [1]. Based on their setup, we propose a new measurement method for gravitational wave det ection in low frequency with optical lattice atomic clocks. In our method, n successive Doppler signals are collected and the summation for all these signals is made to improve the sensitivity of the low-frequency GW detection. In particular, the improvement is adjustable by the number of Doppler signals, which is equivalent to that the length between two atomic clocks is increased. Thus, the same sensitivity can be reached but with shorter distance, even though the acceleration noises lead to failing to achieve the anticipated improvement below the inflection point of frequency which is determined by the quantum projection noise. Our result is timely for the ongoing development of space-born observatories aimed at studying physical and astrophysical effects associated with low-frequency GW.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا