اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدImpact of V substitution on the physical properties of Ni-Zn-Co ferrites: structural, magnetic, dielectric and electrical properties
66
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have investigated the Vanadium- (V) substituted Ni-Zn-Co ferrites where the samples were prepared using solid-state reaction technique. The impact of V5+ substitution on the structural, magnetic, dielectric and electrical properties of Ni-Zn-Co ferrites has been studied. XRD analysis confirmed the formation of a single-phase cubic spinel structure. The lattice constants have been calculated both theoretically and experimentally along with other structural parameters such as bulk density, X-ray density and porosity. The FESEM images are taken to study the surface morphology. FTIR measurement is also performed which confirms spinel structure formation. The saturation magnetization (Ms), coercive field (Hc) and Bohr magneton (B) were calculated from the obtained M-H loops. The temperature dependent permeability is studied to obtain the Curie temperature. Frequency and composition dependence of permeability was also analyzed. Dielectric behavior and ac resistivity are also subjected to investigate the frequency dependency. An inverse relationship was observed between the composition dependence of dielectric constant and ac resistivity. The obtained results such as the electrical resistivity, dielectric constants and magnetic properties suggest the appropriateness of the studied ferrites in microwave device applications.
قيم البحث
اقرأ أيضاً
[Co/Ni] multilayers with perpendicular magnetic anisotropy (PMA) have been researched and applied in various spintronic applications. Typically the seed layer material is studied to provide the desired face-centered cubic (textit{fcc}) texture to the
[Co/Ni] to obtain PMA. The integration of [Co/Ni] in back-end-of-line (BEOL) processes also requires the PMA to survive post-annealing. In this paper, the impact of NiCr, Pt, Ru, and Ta seed layers on the structural and magnetic properties of [Co(0.3 nm)/Ni(0.6 nm)] multilayers is investigated before and after annealing. The multilayers were deposited textit{in-situ} on different seeds via physical vapor deposition at room temperature. The as-deposited [Co/Ni] films show the required textit{fcc}(111) texture on all seeds, but PMA is only observed on Pt and Ru. In-plane magnetic anisotropy (IMA) is obtained on NiCr and Ta seeds, which is attributed to strain-induced PMA loss. PMA is maintained on all seeds after post-annealing up to 400$^{circ}$C. The largest effective perpendicular anisotropy energy ($K_U^{mathrm{eff}}approx 2times10^5$J/m$^3$) after annealing is achieved on NiCr seed. The evolution of PMA upon annealing cannot be explained by further crystallization during annealing or strain-induced PMA, nor can the observed magnetization loss and the increased damping after annealing. Here we identify the diffusion of the non-magnetic materials from the seed into [Co/Ni] as the major driver of the changes in the magnetic properties. By selecting the seed and post-annealing temperature, the [Co/Ni] can be tuned in a broad range for both PMA and damping.
Polycrystalline Yb substituted NiZn nanoferrites with the compositions of Ni0.5Zn0.5YbxFe2-xO4 (x= 0.00, 0.04, 0.08, 0.12, 0.16 and 0.20) have been synthesized using sol gel auto combustion technique. Single phase cubic spinel structure has been conf
irmed by the X ray diffraction (XRD) patterns. Larger lattice constants of the compositions are found with increasing Yb3+ concentration while the average grain size (52 to 18 nm) has noticeable decrease as Yb3+ content is increased. The presence of all existing elements as well as the purity of the samples has also been confirmed from energy dispersive X ray spectroscopic (EDS) analysis. Frequency dependent dielectric constant, dielectric loss, dielectric relaxation time, AC and DC resistivity of the compositions have also been examined at room temperature. The DC resistivity value is found in the order of 10 to power 10 (omega-cm) which is at least four orders greater than the ferrites prepared by conventional method. This larger value of resistivity attributes due to very small grain size and successfully explained using the Verwey and deBoer hopping conduction model. The contribution of grain and grain boundary resistance has been elucidated using Cole Cole plot. The study of temperature dependent DC resistivity confirms the semiconducting nature of all titled compositions wherein bandgap (optical) increases from 2.73 eV to 3.25 eV with the increase of Yb content. The high value of resistivity is of notable achievement for the compositions that make them a potential candidate for implication in the high frequency applications where reduction of eddy current loss is highly required.
Cubic spinel CoCr2O4 has attained recent attention due to its multiferroic properties. However, the Co site substitution effect on the structural and magnetic properties has rarely been studied in thin film form. In this work, the structural and magn
etic properties of Co1-xNixCr2O4 (x = 0, 0.5) epitaxial thin films deposited on MgAl2O4 (100) and MgO (100) substrates to manipulate the nature of strain in the films using pulsed laser deposition (PLD) technique are presented. The epitaxial nature of the films was confirmed through X-ray diffraction (XRD) and Rutherford backscattering spectrometry (RBS) measurements. Raman measurements revealed a disappearance of characteristic A1g and F2g modes of the CoCr2O4 with increase in the Ni content. Atomic force microscopy (AFM) studies show a modification of the surface morphology upon Ni substitution. Magnetic measurements disclose that the ferrimagnetic Curie temperature (Tc) of the CoCr2O4 in thin film grown on MgAl2O4 (100) and MgO (100) substrates were found to be 100.6 +/- 0.5 K and 93.8 +/- 0.2 K, respectively. With Ni substitution the transition temperatures significantly get enhanced from that of CoCr2O4. X-ray photoelectron spectroscopy (XPS) suggests Cr3+ oxidation states in the films, while Co ions are present in a mixed Co2+/Co3+ oxidation state. The substitution of Ni at Co site significantly modifies the line shape of the core level as well as the valence band. Ni ions are also found to be in a mixed 2+/3+ oxidation state. O 1s core level display asymmetry related to possible defects like oxygen vacancies in the films.
YBaCuFeO5 is one of the interesting multiferroic compounds, which exhibits magnetic ordering and dielectric anomaly above 200 K. Partial substitution of Fe with other magnetic and non-magnetic ion affects the magnetic and the structural properties of
the system. We report detailed investigation of structural, magnetic and dielectric properties of YBaCuFe0.85M0.15O5 (M=Co, Ni and Ga). We observed that the partial replacement of Ni and Co in place of Fe, results in magnetic dilution and broadening of the magnetic transition and shifting towards lower temperature. The replacement of Fe with non-magnetic Ga also results in shifting of the magnetic transition to the lower temperature side. The observed dielectric relaxation behavior in these compounds is due to the charge carrier hoping. This study highlights the impacts of magnetic and non-magnetic doping at the magnetic site on magnetic and dielectric properties in layered perovskite compound YBaCuFeO5.
We report on detailed structural, electronic and magnetic studies of GdMn$_{1-x}$Cr$_x$O$_3$ for Cr doping levels 0 $le$ $x$ $le$ 1. In the solid solutions, the Jahn-Teller distortion associated with Mn$^{3+}$ ions gives rise to major changes in the
${bc}$-plane sub-lattice and also the effective orbital ordering in the ${ab}$-plane, which persist up to the compositions $x$ $sim$ 0.35. These distinct features in the lattice and orbital degrees of freedom are also correlated with $bc$-plane anisotropy of the local Gd environment. A gradual evolution of electronic states with doping is also clearly seen in O $K$-edge x-ray absorption spectra. Evidence of magnetization reversal in field-cooled-cooling mode for $x$ $ge$ 0.35 coinciding the Jahn-Teller crossover, suggests a close correlation between magnetic interaction and structural distortion. These observations indicate a strong entanglement between lattice, spin, electronic and orbital degrees of freedom. The nonmonotonic variation of remnant magnetization can be explained by doping induced modification of magnetic interactions. Density functional theory calculations are consistent with a layer-by-layer type doping with ferromagnetic (antiferomagnetic) coupling between Mn (Cr) ions for intermediate compound ($x$ = 0.5), which is distinct from that observed for the end members GMnO$_3$ and GdCrO$_3$.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
