اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدLabOSat as a versatile payload for small satellites: first 100days in LEO orbit
115
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this work the first results obtained by LabOSat-01 platform are presented. This platform was designed for testing custom devices on board of small satellites. Two LabOSat-01 type boards were launched and placed into Low Earth Orbit (LEO) on May 30, 2016. We present here an analysis of data collected by one of these boards during the first days of mission. Total Ionization Dose results are compared with data acquired by LabOSat-01`s predecessor board, MeMOSat-01, launched in 2014.
قيم البحث
اقرأ أيضاً
Recently CMOS (complementary metal-oxide semiconductor) sensors have progressed to a point where they may offer improved performance in imaging x-ray detection compared to the CCDs often used in x-ray satellites. We demonstrate x-ray detection in the
soft x-ray band (250-1700 eV) by a commercially available back-illuminated Sony IMX290LLR CMOS sensor using the Advanced Photon Source at the Argonne National Laboratory. While operating the device at room temperature, we measure energy resolutions (FWHM) of 48 eV at 250 eV and 83 eV at 1700 eV which are comparable to the performance of the Chandra ACIS and the Suzaku XIS. Furthermore, we demonstrate that the IMX290LLR can withstand radiation up to 17.1 krad, making it suitable for use on spacecraft in low earth orbit.
The Modular X- and Gamma-ray Sensor (MXGS) is an imaging and spectral X- and Gamma-ray instrument mounted on the starboard side of the Columbus module on the International Space Station. Together with the Modular Multi-Spectral Imaging Assembly (MMIA
) (Chanrion et al. this issue) MXGS constitutes the instruments of the Atmosphere-Space Interactions Monitor (ASIM) (Neubert et al. this issue). The main objectives of MXGS are to image and measure the spectrum of X- and $gamma$-rays from lightning discharges, known as Terrestrial Gamma-ray Flashes (TGFs), and for MMIA to image and perform high speed photometry of Transient Luminous Events (TLEs) and lightning discharges. With these two instruments specifically designed to explore the relation between electrical discharges, TLEs and TGFs, ASIM is the first mission of its kind.
Neutron scattering techniques offer a unique combination of structural and the dynamic information of atomic and molecular systems over a wide range of distances and times. The increasing complexity in science investigations driven by technological a
dvances is reflected in the studies of neutron scattering science, which enforces a diversification and an improvement of experimental tools, from the instrument design to the detector performance. It calls as well for more advanced data analysis and modelling. The improvements in resolution, count rate and signal-to-background ratio, achievable with the new instrumentations, also drive the research of alternative technologies to replace the 3He-based detector technology unable to fulfil the requirement of increasing performance. Two solution have been studied: a boron-10-based gaseous detector, the Multi-Blade and a solid-state Si-Gd detector. Both solution are suitable alternatives for neutron detection, able to meet the demands of high performance. It has been shown not only the technical characteristic of the devices, but how the science can profit from the better performance of these new detector technologies in real experimental condition.
We present a new model, developed with the Serpent Monte Carlo code, for neutronics simulation of the TRIGA Mark II reactor of Pavia (Italy). The complete 3D geometry of the reactor core is implemented with high accuracy and detail, exploiting all th
e available information about geometry and materials. The Serpent model of the reactor is validated in the fresh fuel configuration, through a benchmark analysis of the first criticality experiments and control rods calibrations. The accuracy of simulations in reproducing the reactivity difference between the low power (10 W) and full power (250 kW) reactor condition is also tested. Finally, a direct comparison between Serpent and MCNP simulations of the same reactor configurations is presented.
We present a viewport for use in Ultra-high vacuum (UHV) based upon the preflattened solder seal design presented in earlier work, Cox et al. Rev. Sci. Inst. 74, 3185 (2003). The design features significant modifications to improve long term performa
nce. The windows have been leak tested to less than 10^-10 atm cm^3/s . From atom number measurements in an optical dipole trap loaded from a vapor cell magneto-optical trap (MOT) inside a vacuum chamber accommodating these viewports, we measure a trap lifetime of 9.5s suggesting a pressure of around 10^-10 Torr limited by background Rubidium vapor pressure. We also present a simplified design where the UHV seal is made directly to a vacuum pipe
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
