اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn the Elastic Anisotropy of the Entropy-Stabilized Oxide (Mg, Co, Ni, Cu, Zn)O
77
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this paper, we study the elastic properties of the entropy-stabilized oxide (Mg, Co, Ni, Cu, Zn)O, using experimental and first principles techniques. Our measurements of the indentation modulus on grains with a wide range of crystallographic orientations of the entropy-stabilized oxide revealed a high degree of elastic isotropy at ambient conditions. First principles calculations predict mild elastic anisotropy for the paramagnetic structure, which decreases when the system is considered to be non-magnetic. When the antiferromagnetic state of CoO, CuO and NiO is accounted for in the calculations, a slight increase in the elastic anisotropy is observed, suggesting a coupling between magnetic ordering and the orientation dependent elastic properties. Furthermore, an examination of the local structure reveals that the isotropy is favored through local ionic distortions of Cu and Zn - due to their tendency to form tenorite and wurtzite phases. The relationships between the elastic properties of the multicomponent oxide and those of its constituent binary oxides are reviewed. These insights open up new avenues for controlling isotropy for technological applications through tuning composition and structure in the entropy-stabilized oxide or the high entropy compounds in general.
قيم البحث
اقرأ أيضاً
For the first time, this study shows that distortion in a crystal structure due to magnetic effect is possible in a lattice with extreme chemical disorder. The multicomponent equimolar transition metal oxide (ME TMO), (Co,Cu,Mg,Ni,Zn)O, which is a hi
gh entropy oxide, has been attracting a lot of attention due to its unique application potential in many fields including electrochemical energy storage. In the present investigation, nanocrystalline ME TMO was synthesised by three bottom up methods. The presence of distortion in the rocksalt crystal structure, revealed by X ray diffraction and Raman spectroscopy, and correlated with magnetic measurements from SQUID and EPR studies could be attributed to the additive effects of exchange striction (from the magnetic constituents) and magnetic anisotropy (from the decreased crystallite size). For the first time, iron has been doped into ME TMO, to show that a higher amount of magnetic constituent increases the distortion in the lattice. Nanocrystalline ME TMO also showed a core shell magnetic behavior below the bifurcation temperature arising from the uncompensated or canted spin at the surface. Neel temperature of the nanocrystalline ME TMO is reported for first time to be as high as 700 K. This study helps unravel the structure and magnetic properties of such high entropy materials, and augurs a definite scope for better understanding of the factors influencing the crystal structure in high entropy oxides.
We demonstrate by means of fully relativistic first principles calculations that, by substitution of Fe by Cr, Mn, Co, Ni or Cu in FePt-L10 bulk alloys, with fixed Pt content, it is possible to tune the magnetocrystalline anisotropy energy by adjusti
ng the content of the non-magnetic species in the material. The changes in the geometry due to the inclusion of each element induces different values of the tetragonality and hence changes in the magnetic anisotropy and in the net magnetic moment. The site resolved magnetic moments of Fe increase with the X content whilst those of Pt and X are simultaneously reduced. The calculations are in good quantitative agreement with experimental data and demonstrate that models with fixed band structure but varying numbers of electrons per unit cell are insufficient to describe the experimental data for doped FePt-L10 alloys.
Using the spectroscopies based upon x-ray absorption, we have studied the structural and magnetic properties of Zn$_{1-x}$Co$_{x}$O films ($x$ = 0.1 and 0.25) produced by reactive magnetron sputtering. These films show ferromagnetism with a Curie tem
perature $T_{mathrm{C}}$ above room temperature in bulk magnetization measurements. Our results show that the Co atoms are in a divalent state and in tetrahedral coordination, thus substituting Zn in the wurtzite-type structure of ZnO. However, x-ray magnetic circular dichroism at the Co textit{L}$_{2,3}$ edges reveals that the Co 3textit{d} sublattice is paramagnetic at all temperatures down to 2 K, both at the surface and in the bulk of the films. The Co 3textit{d} magnetic moment at room temperature is considerably smaller than that inferred from bulk magnetisation measurements, suggesting that the Co 3textit{d} electrons are not directly at the origin of the observed ferromagnetism.
We present a spectroscopic study of (Zn,Co)O layers grown by molecular beam epitaxy on sapphire substrates. (Zn,Co)O is commonly considered as a promising candidate for being a Diluted Magnetic Semiconductor ferromagnetic at room temperature. We perf
ormed magneto-optical spectroscopy in the Faraday configuration, by applying a magnetic field up to 11 T, at temperatures down to 1.5 K. For very dilute samples (less than 0.5% Co), the giant Zeeman splitting of the A and B excitons is observed at low temperature. It is proportional to the magnetization of isolated Co ions, as calculated using the anisotropy and g-factor deduced from the spectroscopy of the d-d transitions. This demonstrates the existence of spin-carrier coupling. Electron-hole exchange within the exciton has a strong effect on the giant Zeeman splitting observed on the excitons. From the effective spin-exciton coupling, <N0(Alpha-Beta)>_X=0.4 eV, we estimate the difference of the exchange integrals for free carriers, N0|Alpha-Beta|=0.8 eV. The magnetic circular dichroism observed near the energy gap was found to be proportional to the paramagnetic magnetization of anisotropic Co ions even for higher Co contents.
The existence of the miscibility gap in the Cu-Ni system has been an issue in both computational and experimental discussions for half a century [Chakrabarti et al., Phase diagrams of binary nickel alloys, ASM, 1991]. Here we propose a new miscibilit
y gap in the Cu-Ni system measured in nano-layered thin films by Secondary Neutral Mass Spectrometry. The maximum of the symmetrical miscibility curve is around 800~K at Cu50%Ni50%. To our best knowledge, this is the first experiment determining the miscibility from the measurement of the atomic fraction of Copper and Nickel in the whole composition range. Needless to say that Ni, Cu and its alloys are important in various fields, accordingly this result affects different areas to understand materials sciences.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
