ترغب بنشر مسار تعليمي؟ اضغط هنا

High-fidelity spatial mode transmission through a 1-km-long multimode fiber via vectorial time reversal

113   0   0.0 ( 0 )
 نشر من قبل Yiyu Zhou
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

The large number of spatial modes supported by standard multimode fibers is a promising platform for boosting the channel capacity of quantum and classical communications by orders of magnitude. However, the practical use of long multimode fibers is severely hampered by modal crosstalk and polarization mixing. To overcome these challenges, we develop and experimentally demonstrate a vectorial time reversal technique, which is accomplished by digitally pre-shaping the wavefront and polarization of the forward-propagating signal beam to be the phase conjugate of an auxiliary, backward-propagating probe beam. Here, we report an average modal fidelity above 80% for 210 Laguerre-Gauss and Hermite-Gauss modes by using vectorial time reversal over an unstabilized 1-km-long fiber. We also propose a practical and scalable spatial-mode-multiplexed quantum communication protocol over long multimode fibers to illustrate potential applications that can be enabled by our technique.



قيم البحث

اقرأ أيضاً

The orbital angular momentum (OAM) of photons presents a degree of freedom for enhancing the secure key rate of free-space quantum key distribution (QKD) through mode-division multiplexing (MDM). However, atmospheric turbulence can lead to substantia l modal crosstalk, which is a long-standing challenge to MDM for free-space QKD. Here, we show that the digital generation of time-reversed wavefronts for multiple probe beams is an effective method for mitigating atmospheric turbulence. We experimentally characterize seven OAM modes after propagation through a 340-m outdoor free-space link and observe an average modal crosstalk as low as 13.2% by implementing real-time time reversal. The crosstalk can be further reduced to 3.4% when adopting a mode spacing $Delta ell$ of 2. We implement a classical MDM system as a proof-of-principle demonstration, and the bit error rate is reduced from $3.6times 10^{-3}$ to be less than $1.3times 10^{-7}$ through the use of time reversal. We also propose a practical and scalable scheme for high-speed, mode-multiplexed QKD through a turbulent link. The modal crosstalk can be further reduced by using faster equipment. Our method can be useful to various free-space applications that require crosstalk suppression.
We introduce a system capable of focusing light through a multimode fiber in 37ms, one order of magnitude faster than demonstrated in previous reports. As a result, the focus spot can be maintained during significant bending of the fiber, opening num erous opportunities for endoscopic imaging and energy delivery applications. We measure the transmission matrix of the fiber by projecting binary-amplitude computer generated holograms using a digital micromirror device and a field programmable gate array controller. The system shows two orders of magnitude enhancements of the focus spot relative to the background.
A laser is based on the electromagnetic modes of its resonator, which provides the feedback required for oscillation. Enormous progress has been made in controlling the interactions of longitudinal modes in lasers with a single transverse mode. For e xample, the field of ultrafast science has been built on lasers that lock many longitudinal modes together to form ultrashort light pulses. However, coherent superposition of many longitudinal and transverse modes in a laser has received little attention. The multitude of disparate frequency spacings, strong dispersions, and complex nonlinear interactions among modes greatly favor decoherence over the emergence of order. Here we report the locking of multiple transverse and longitudinal modes in fiber lasers to generate ultrafast spatiotemporal pulses. We construct multimode fiber cavities using graded-index multimode fiber (GRIN MMF). This causes spatial and longitudinal mode dispersions to be comparable. These dispersions are counteracted by strong intracavity spatial and spectral filtering. Under these conditions, we achieve spatiotemporal, or multimode (MM), mode-locking. A variety of other multimode nonlinear dynamical processes can also be observed. Multimode fiber lasers thus open new directions in studies of three-dimensional nonlinear wave propagation. Lasers that generate controllable spatiotemporal fields, with orders-of-magnitude increases in peak power over existing designs, should be possible. These should increase laser utility in many established applications and facilitate new ones.
Light storage in an optical fiber is an attractive component in quantum optical delay line technologies. Although silica-core optical fibers are excellent in transmitting broadband optical signals, it is challenging to tailor their dispersive propert y to slow down a light pulse or store it in the silica-core for a long delay time. Coupling a dispersive and coherent medium with an optical fiber is promising in supporting long optical delay. Here, we load cold Rb atomic vapor into an optical trap inside a hollow-core photonic crystal fiber, and store the phase of the light in a long-lived spin-wave formed by atoms and retrieve it after a fully controllable delay time using electromagnetically-induced-transparency (EIT). We achieve over 50 ms of storage time and the result is equivalent to 8.7x10^-5 dB s^-1 of propagation loss in an optical fiber. Our demonstration could be used for buffering and regulating classical and quantum information flow between remote networks.
Multimode optical fibres are enjoying a renewed attention, boosted by the urgent need to overcome the current capacity crunch of single-mode fibre systems and by recent advances in multimode complex nonlinear optics [1-13]. In this work, we demonstra te that standard multimode fibres can be used as ultrafast all-optical tool for transverse beam manipulation of high power laser pulses. Our experimental data show that the Kerr effect in a graded-index multimode fibre is the driving mechanism for overcoming speckle distortions, leading to a somewhat counter-intuitive effect resulting in a spatially clean output beam robust against fibre bending. Our observations demonstrate that nonlinear beam reshaping into the fundamental mode of a multimode fibre can be achieved even in the absence of a dissipative process such as stimulated scattering (Raman or Brillouin) [14,15].
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا