ترغب بنشر مسار تعليمي؟ اضغط هنا

Effect of lattice distortions on the electron and thermal transport properties of transparent oxide semiconductor Ba1-xSrxSnO3 solid solution films

64   0   0.0 ( 0 )
 نشر من قبل Mian Wei Miss
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

La-doped ASnO3 (A = Ba, Sr) have great potential as advanced transparent oxide semiconductors due to their large optical bandgap and relatively high electron mobility. The bandgap of Ba1-xSrxSnO3 solid solution increases from 3.2 eV (BaSnO3) to 4.6 eV (SrSnO3) with x. However, the increase in the bandgap is accompanied by reductions in the electrical conductivity. The versatility in the changes in the electrical properties are not trivial, and the property optimization has been challenging. Here we propose a simple metric for quantifying the transport properties of ASnO3. We investigated the electron/thermal transport properties of Ba1-xSrxSnO3 solid solution films and their relationship with the lattice distortion. The results suggest that the all transport properties of Ba1-xSrxSnO3 are dominated by the lattice distortion. This phenomenon is attributed to the distortions in the SnO6 octahedron, which consists the conduction band.



قيم البحث

اقرأ أيضاً

SrVO3 thin films with a high figure of merit for applications as transparent conductors were crystallized from amorphous layers using solid phase epitaxy (SPE). Epitaxial SrVO3 films crystallized on SrTiO3 using SPE exhibit a room temperature resisti vity of 2.5 x 10-5 Ohms cm, a residual resistivity ratio of 3.8, and visible light transmission above 0.5 for a 60 nm-thick film. SrVO3 layers were deposited at room temperature using radio-frequency sputtering in an amorphous form and subsequently crystallized by heating in controlled gas environment. The lattice parameters and mosaic angular width of x-ray reflections from the crystallized films are consistent with partial relaxation of the strain resulting from the epitaxial mismatch between SrVO3 and SrTiO3. A reflection high-energy electron diffraction study of the kinetics of SPE indicates that crystallization occurs via the thermally activated propagation of the crystalline/amorphous interface, similar to SPE phenomena in other perovskite oxides. Thermodynamic calculations based on density functional theory predict the temperature and oxygen partial pressure conditions required to produce the SrVO3 phase and are consistent with the experiments. The separate control of deposition and crystallization conditions in SPE presents new possibilities for the crystallization of transparent conductors in complex geometries and over large areas.
Material properties depend sensitively on picometer scale atomic displacements introduced by local chemical fluctuations. Direct real-space, high spatial-resolution measurements of this compositional variation and corresponding distortion can provide new insights into materials behavior at the atomic scale. Using aberration corrected scanning transmission electron microscopy combined with advanced imaging methods, we observed atom column specific, picometer-scale displacements induced by local chemistry in a complex oxide solid solution. Displacements predicted from density functional theory were found to correlate with the observed experimental trends. Further analysis of bonding and charge distribution were used to clarify the mechanisms responsible for the detected structural behavior. By extending the experimental electron microscopy measurements to previously inaccessible length scales, we identified correlated atomic displacements linked to bond differences within the complex oxide structure.
We report the electrical resistivity, thermoelectric power, and thermal conductivity of single-crystalline and sintered samples of the 5d pyrochlore oxide CsW2O6. The electrical resistivity of the single crystal is 3 mohm cm at 295 K and gradually in creases with decreasing temperature above 215 K (Phase I). The thermoelectric power of the single-crystalline and sintered samples shows a constant value of approximately -60 uV K-1 in Phase I. These results reflect that the electron conduction by W 5d electrons in Phase I is incoherent and in the hopping regime, although a band gap does not open at the Fermi level. The thermal conductivity in Phase I of both samples is considerably low, which might be due to the rattling of Cs+ ions. In Phase II below 215 K, the electrical resistivity and the absolute value of thermoelectric power of both samples strongly increase with decreasing temperature, corresponding to a transition to a semiconducting state with a band gap open at the Fermi level, while the thermal conductivity in Phase II is smaller than that in Phase I.
Contrary to the common belief that electron-electron interaction (EEI) should be negligible in s-orbital-based conductors, we demonstrated that the EEI effect could play a significant role on electronic transport leading to the misinterpretation of t he Hall data. We show that the EEI effect is primarily responsible for an increase in the Hall coefficient in the La-doped SrSnO3 films below 50 K accompanied by an increase in the sheet resistance. The quantitative analysis of the magnetoresistance (MR) data yielded a large phase coherence length of electrons exceeding 450 nm at 1.8 K and revealed the electron-electron interaction being accountable for breaking of electron phase coherency in La-doped SrSnO3 films. These results while providing critical insights into the fundamental transport behavior in doped stannates also indicate the potential applications of stannates in quantum coherent electronic devices owing to their large phase coherence length.
The effect of pressure on the thermal expansion of solid CH$_4$ is calculated for the low temperature region where the contributions from phonons and librons can be neglected and only the rotational tunnelling modes are essential. The effect of press ure is shown to increase the magnitude of the peaks of the negative thermal expansion and shifts the positions of the peaks to the low-temperature region, which goes asymptotically to zero temperature with increasing pressure. The Gruneisen thermodynamical parameter for the rotational tunnelling modes is calculated. It is large, negative, and increases in magnitude with rising pressure.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا