اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCapability of detecting low energy events in JUNO Central Detector
68
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The Jiangmen Underground Neutrino Observatory (JUNO) is an experimental project designed to determine the neutrino mass ordering and probe the fundamental properties of the neutrino oscillations. The JUNO central detector is a spherical liquid scintillator detector with a diameter of 35.4 m and equipped with approximately 18,000 20-inch PMTs. A trigger threshold of 0.5 MeV can be easily achieved by using a common multiplicity trigger and can meet the requirements for measuring neutrino mass ordering. However, it is essential to further reduce the trigger threshold for detecting solar neutrinos and supernova neutrinos. A sophisticated trigger scheme is proposed to achieve a low energy threshold by reducing the level of low energy radioactivity and dark noise coincidence. With the new trigger scheme, the events rate of the central detector from different types of sources have been carefully studied by using a detailed detector simulation. It shows that the trigger threshold can be reduced to 0.2 MeV, or even 0.1 MeV, if the concentration of $^{14}$C in liquid scintillator can be well controlled.
قيم البحث
اقرأ أيضاً
The Jiangmen Underground Neutrino Observatory (JUNO) is a next-generation neutrino experiment under construction in China expected to be completed in 2022. As the main goal it aims to determine the neutrino mass ordering with 3-4 $sigma$ significance
using a 20 kton liquid scintillator detector. It will measure the oscillated energy spectrum of electron anti-neutrinos from two nuclear power plants at about 53 km baseline with an unprecedented energy resolution of 3% at 1 MeV. A requirement of the JUNO experiment is the knowledge of the energy non-linearity of the detector with a sub-percent precision. As the light yield of the liquid scintillator is not fully linear to the energy of the detected particle and dependent on the particle type, a model for this light yield is presented in this paper. Based on an energy non-linearity model of electrons, this article provides the conversion to the more complex energy response of positrons and gammas. This conversion uses a fast and simple algorithm to calculate the spectrum of secondary electrons generated by a gamma, which is introduced here and made open access to potential users. It is also discussed how the positron non-linearity can be obtained from the detector calibration with gamma sources using the results presented in this article.
The Jiangmen Underground Neutrino Observatory (JUNO) is a multi-purpose neutrino experiment designed to measure the neutrino mass hierarchy using a central detector (CD), which contains 20 kton liquid scintillator (LS) surrounded by about 17,000 phot
omultiplier tubes (PMTs). Due to the large fiducial volume and huge number of PMTs, the simulation of a muon particle passing through the CD with the Geant4 toolkit becomes an extremely computation-intensive task. This paper presents a fast simulation implementation using a so-called voxel method: for scintillation photons generated in a certain LS voxel, the PMTs response is produced beforehand with Geant4 and then introduced into the simulation at runtime. This parameterisation method successfully speeds up the most CPU consuming process, the optical photons propagation in the LS, by a factor of 50. In the paper, the comparison of physics performance between fast and full simulation is also given.
The Jiangmen Underground Neutrino Observatory (JUNO) is designed to study neutrino mass hierarchy and measure three of the neutrino oscillation parameters with high precision using reactor antineutrinos. It is also able to study many other physical p
henomena, including supernova neutrinos, solar neutrinos, geo-neutrinos, atmosphere neutrinos, and so forth. The central detector of JUNO contains 20,000~tons of liquid scintillator (LS) and about 18,000 20-inch photomultiplier tubes (PMTs), which is the largest liquid scintillator one under construction in the world up today. The energy resolution is expected to be 3%/$sqrt{E(MeV)}$. To meet the requirements of the experiment, an algorithm of vertex reconstruction, which takes into account time and charge information of PMTs, has been developed by deploying the maximum likelihood method and well understanding the complicated optical processes in the liquid scintillator.
A visualization method based on Unity engine is proposed for the Jiangmen Underground Neutrino Observatory (JUNO) experiment. The method has been applied in development of a new event display tool named ELAINA (Event Live Animation with unIty for Neu
trino Analysis), which provides an intuitive way for users to observe the detector geometry, to tune the reconstruction algorithm and to analyze the physics events. In comparison with the traditional ROOT-based event display, ELAINA provides better visual effects with the Unity engine. It is developed independently of the JUNO offline software but shares the same detector description and event data model in JUNO offline with interfaces. Users can easily download and run the event display on their local computers with different operation systems.
The Jiangmen Underground Neutrino Observatory (JUNO) is a multi-purpose neutrino experiment designed to measure the neutrino mass hierarchy using a central detector (CD), which contains 20 kton liquid scintillator (LS) surrounded by about 18,000 phot
omultiplier tubes (PMTs), located 700~m underground. The rate of cosmic muons reaching the JUNO detector is about 3~Hz and the muon induced neutrons and isotopes are major backgrounds for the neutrino detection. Reconstruction of the muon trajectory in the detector is crucial for the study and rejection of those backgrounds. This paper will introduce the muon tracking algorithm in the JUNO CD, with a least squares method of PMTs first hit time (FHT). Correction of the FHT for each PMT was found to be important to reduce the reconstruction bias. The spatial resolution and angular resolution are better than 3~cm and 0.4~degree, respectively, and the tracking efficiency is greater than 90% up to 16~m far from the detector center.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
