اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPerfect proton selectivity in ion transport through two-dimensional crystals
242
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Defect-free monolayers of graphene and hexagonal boron nitride were previously shown to be surprisingly permeable to thermal protons, despite being completely impenetrable to all gases. It remains untested whether small ions can permeate through the two-dimensional crystals. Here we show that mechanically exfoliated graphene and hexagonal boron nitride exhibit perfect Nernst selectivity such that only protons can permeate through, with no detectable flow of counterions. In the experiments, we used suspended monolayers that had few if any atomic-scale defects, as shown by gas permeation tests, and placed them to separate reservoirs filled with hydrochloric acid solutions. Protons accounted for all the electrical current and chloride ions were blocked. This result corroborates the previous conclusion that thermal protons can pierce defect-free two-dimensional crystals. Besides importance for theoretical developments, our results are also of interest for research on various separation technologies based on two-dimensional materials.
قيم البحث
اقرأ أيضاً
Proton radiation damage is an important failure mechanism for electronic devices in near-Earth orbits, deep space and high energy physics facilities. Protons can cause ionizing damage and atomic displacements, resulting in device degradation and malf
unction. Shielding of electronics increases the weight and cost of the systems but does not eliminate destructive single events produced by energetic protons. Modern electronics based on semiconductors - even those specially designed for radiation hardness - remain highly susceptible to proton damage. Here we demonstrate that room temperature (RT) charge-density-wave (CDW) devices with quasi-two-dimensional (2D) 1T-TaS2 channels show remarkable immunity to bombardment with 1.8 MeV protons to a fluence of at least 10^14 H+cm^2. Current-voltage I-V characteristics of these 2D CDW devices do not change as a result of proton irradiation, in striking contrast to most conventional semiconductor devices or other 2D devices. Only negligible changes are found in the low-frequency noise spectra. The radiation immunity of these all-metallic CDW devices can be attributed to their two-terminal design, quasi-2D nature of the active channel, and high concentration of charge carriers in the utilized CDW phases. Such devices, capable of operating over a wide temperature range, can constitute a crucial segment of future electronics for space, particle accelerator and other radiation environments.
Measuring heat flow through nanoscale systems poses formidable practical difficulties as there is no `ampere meter for heat. We propose to overcome this problem by realizing heat transport through a chain of trapped ions. Laser cooling the chain edge
s to different temperatures induces a current of local vibrations (vibrons). We show how to efficiently control and measure this current, including fluctuations, by coupling vibrons to internal ion states. This demonstrates that ion crystals provide a suitable platform for studying quantum transport, e.g., through thermal analogues of quantum wires and quantum dots. Notably, ion crystals may give access to measurements of the elusive large fluctuations of bosonic currents and the onset of Fouriers law. These results are supported by numerical simulations for a realistic implementation with specific ions and system parameters.
Electrical generation of polarized spins in nonmagnetic materials is of great interest for the underlying physics and device potential. One such mechanism is chirality-induced spin selectivity (CISS), with which structural chirality leads to differen
t electric conductivities for electrons of opposite spins. The resulting effect of spin filtering has been reported for a number of chiral molecules. However, the microscopic mechanism and manifestation of CISS in practical device structures remain controversial; in particular, the Onsager relation is understood to preclude linear-response detection of CISS by a ferromagnet. Here, we report direct evidence of CISS in two-terminal devices of chiral molecules on the magnetic semiconductor (Ga,Mn)As: In vertical heterojunctions of (Ga,Mn)As/AHPA-L molecules/Au, we observed characteristic linear- and nonlinear-response magnetoconductance, which directly verifies spin filtering by the AHPA-L molecules and spin detection by the (Ga,Mn)As. The results constitute definitive signature of CISS-induced spin valve effect, a core spintronic functionality, in apparent violation of the Onsager reciprocity. The results present a promising route to semiconductor spintronics free of any magnetic material.
Two-dimensional (2D) materials with narrow band gaps (~0.3 eV) are of great importance for realizing ambipolar transistors and mid-infrared (MIR) detection. However, most of the 2D materials studied so far have band gaps that are too large. A few of
them with suitable band gaps are not stable under ambient conditions. In this study, the layered Nb$_{2}$SiTe$_{4}$ is shown to be a stable 2D material with a band gap of 0.39 eV. Field-effect transistors based on few-layer Nb$_2$SiTe$_4$ show ambipolar transport with similar magnitude of electron and hole current and high charge-carrier mobility of ~ 100 cm$^{2}$V$^{-1}$s$^{-1}$ at room temperature. Optoelectronic measurements of the devices show clear response to MIR wavelength of 3.1 $mathrmmu$m with a high responsivity of ~ 0.66 AW$^{-1}$. These results establish Nb$_{2}$SiTe$_{4}$ as a good candidate for ambipolar devices and MIR detection.
While digital electronics has become entirely ubiquitous in todays world and appears in the limelight, analogue electronics is still playing a crucial role in many devices and applications. Current analogue circuits are mostly manufactured using sili
con as active material, but the ever present demand for improved performance, new devices and flexible integration has - similar to their digital counterparts - pushed for research into alternative materials. In recent years two-dimensional materials have received considerable research interest, fitting their promising properties for future electronics. In this work we demonstrate an operational amplifier - a basic building block of analogue electronics - using a two-dimensional semiconductor, namely molybdenum disulfide, as active material. Our device is capable of stable operation with good performance, and we demonstrate its use in feedback circuits such as inverting amplifiers, integrators, log amplifiers, and transimpedance amplifiers.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
