اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSustained coherent spin wave emission using frequency combs
67
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We demonstrate sustained coherent emission of spin waves in NiFe films using rapid demagnetization from high repetition rate femtosecond laser pulse trains. As the pulse separation is shorter than the magnon decay time, magnons having a frequency equal to a multiple of the 1 GHz repetition-rate are coherently amplified. Using scanning micro-Brillouin Light Scattering (BLS) we observe this coherent amplification as strong peaks spaced 1 GHz apart. The BLS counts vs. laser power exhibit a stronger than parabolic dependence consistent with counts being proportional to the square of the magnetodynamic amplitude, and the demagnetization pulse strength being described by a Bloch law. Spatial spin wave mapping demonstrates how both localized and propagating spin waves can be excited, and how the propagation direction can be directly controlled. Our results demonstrate the versatility of BLS spectroscopy for rapid demagnetization studies and enable a new platform for photo-magnonics where sustained coherent spin waves can be utilized.
قيم البحث
اقرأ أيضاً
By their very nature, voltage/current excited Spin Waves (SWs) propagate through waveguides without consuming noticeable power. If SW excitation is performed by the continuous application of voltages/currents to the input, which is usually the case,
the overall energy consumption is determined by the transducer power and the circuit critical path delay, which leads to high energy consumption because of SWs slowness. However, if transducers are operated in pulses the energy becomes circuit delay independent and it is mainly determined by the transducer power and delay, thus pulse operation should be targeted. In this paper, we utilize a 3-input Majority gate (MAJ) to investigate the Continuous Mode Operation (CMO), and Pulse Mode Operation (PMO). Moreover, we validate CMO and PMO 3-input Majority gate by means of micromagnetic simulations. Furthermore, we evaluate and compare the CMO and PMO Majority gate implementations in term of energy. The results indicate that PMO diminishes MAJ gate energy consumption by a factor of 18. In addition, we describe how PMO can open the road towards the utilization of the Wave Pipelining (WP) concept in SW circuits. We validate the WP concept by means of micromagnetic simulations and we evaluate its implications in term of throughput. Our evaluation indicates that for a circuit formed by four cascaded MAJ gates WP increases the throughput by 3.6x.
Spin Waves(SWs) enable the realization of energy efficient circuits as they propagate and interfere within waveguides without consuming noticeable energy. However, SW computing can be even more energy efficient by taking advantage of the approximate
computing paradigm as many applications are error-tolerant like multimedia and social media. In this paper we propose an ultra-low energy novel Approximate Full Adder(AFA) and a 2-bit inputs Multiplier(AMUL). We validate the correct functionality of our proposal by means of micromagnetic simulations and evaluate the approximate FA figure of merit against state-of-the-art accurate SW, 7nmCMOS, Spin Hall Effect(SHE), Domain Wall Motion(DWM), accurate and approximate 45nmCMOS, Magnetic Tunnel Junction(MTJ), and Spin-CMOS FA implementations. Our results indicate that AFA consumes 43% and 33% less energy than state-of-the-art accurate SW and 7nmCMOS FA, respectively, and saves 69% and 44% when compared with accurate and approximate 45nm CMOS, respectively, and provides a 2 orders of magnitude energy reduction when compared with accurate SHE, accurate and approximate DWM, MTJ, and Spin-CMOS, counterparts. In addition, it achieves the same error rate as approximate 45nmCMOS and Spin-CMOS FA whereas it exhibits 50% less error rate than the approximate DWM FA. Furthermore, it outperforms its contenders in terms of area by saving at least 29% chip real-estate. AMUL is evaluated and compared with state-of-the-art accurate SW and 16nm CMOS accurate and approximate state-of-the-art designs. The evaluation results indicate that it saves at least 2x and 5x energy in comparison with the state-of-the-art SW designs and 16nm CMOS accurate and approximate designs, respectively, and has an average error rate of 10%, while the approximate CMOS MUL has an average error rate of 13%, and requires at least 64% less chip real-estate.
Spin Waves (SWs) propagate through magnetic waveguides and interfere with each other without consuming noticeable energy, which opens the road to new ultra-low energy circuit designs. In this paper we build upon SW features and propose a novel energy
efficient Full Adder (FA) design consisting of The FA 1 Majority and 2 XOR gates, which outputs Sum and Carry-out are generated by means of threshold and phase detection, respectively. We validate our proposal by means of MuMax3 micromagnetic simulations and we evaluate and compare its performance with state-of-the-art SW, 22nm CMOS, Magnetic Tunnel Junction (MTJ), Spin Hall Effect (SHE), Domain Wall Motion (DWM), and Spin-CMOS implementations. Our evaluation indicates that the proposed SW FA consumes 22.5% and 43% less energy than the direct SW gate based and 22nm CMOS counterparts, respectively. Moreover it exhibits a more than 3 orders of magnitude smaller energy consumption when compared with state-of-the-art MTJ, SHE, DWM, and Spin-CMOS based FAs, and outperforms its contenders in terms of area by requiring at least 22% less chip real-estate.
Frequency combs, broadband light sources whose spectra consist of coherent, discrete modes, have become essential in many fields. Miniaturizing frequency combs would be a significant advance in these fields, enabling the deployment of frequency-comb
based devices for diverse measurement and spectroscopy applications. We demonstrate diode-laser based frequency comb generators. These laser diodes are simple, electrically pumped, inexpensive and readily manufactured. Each chip contains several dozen diode-laser combs. We measure the time-domain output of a diode frequency comb to reveal the underlying frequency dynamics responsible for the comb spectrum, conduct dual comb spectroscopy of a molecular gas with two devices on the same chip, and demonstrate that these combs can be battery powered.
Insulating antiferromagnets are efficient and robust conductors of spin current. To realise the full potential of these materials within spintronics, the outstanding challenges are to demonstrate scalability down to nanometric lengthscales and the tr
ansmission of coherent spin currents. Here, we report the coherent transfer of spin angular momentum by excitation of evanescent spin waves of GHz frequency within antiferromagnetic NiO at room temperature. Using element-specific and phase-resolved x-ray ferromagnetic resonance, we probe the injection and transmission of ac spin current, and demonstrate that insertion of a few nanometre thick epitaxial NiO(001) layer between a ferromagnet and non-magnet can even enhance the flow of spin current. Our results pave the way towards coherent control of the phase and amplitude of spin currents at the nanoscale, and enable the realization of spin-logic devices and spin current amplifiers that operate at GHz and THz frequencies.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
