اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEstimating the Fuel Supply Rate on the Galactic Disk from High Velocity Clouds (HVCs) Infall
348
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Previous studies suggest that the estimated maximum accretion rate from approaching high velocity clouds (HVCs) on the Galactic disk can be up to ~ 0.4 solar mass per year. In this study, we point out that the hydrodynamic interaction between the HVCs and the Galactic disk is not considered in the traditional method of estimating the infall rate and therefore the true supply rate of fuel from HVCs can be different from the suggested value depending on the physical configurations of HVCs including density, velocity, and distance. We choose 11 HVC complexes and construct 4 different infall models in our simulations to give an idea of how the fuel supply rate could be different from the traditional infall rate. Our simulation results show that the fuel supply rate from HVC infall is overestimated in the traditional method and can be lowered by a factor of ~ 0.072 when the hydrodynamic interaction of the HVC complexes and the disk is considered.
قيم البحث
اقرأ أيضاً
Tantalizing evidence has been presented supporting the suggestion that a large population of extragalactic gas clouds permeates the Local Group, a population which has been associated with the Galactic High-Velocity Clouds (HVCs). We comment on both
the strengths and weaknesses of this suggestion, informally referred to as the Blitz/Spergel picture. Theoretical predictions for the spatial and kinematic distributions, metallicities, distances, and emission properties of Blitz/Spergel HVCs will be confronted with extant observational data.
Spiral galaxies are surrounded by a widely distributed hot coronal gas and seem to be fed by infalling clouds of neutral hydrogen gas with low metallicity and high velocities. We numerically study plasma waves produced by the collisions of these high
-velocity clouds (HVCs) with the hot halo gas and with the gaseous disk. In particular, we tackle two problems numerically: 1) collisions of HVCs with the galactic halo gas and 2) the dispersion relations to obtain the phase and group velocities of plasma waves from the equations of plasma motion as well as further important physical characteristics such as magnetic tension force, gas pressure, etc. The obtained results allow us to understand the nature of MHD waves produced during the collisions in galactic media and lead to the suggestion that these waves can heat the ambient halo gas. These calculations are aiming at leading to a better understanding of dynamics and interaction of HVCs with the galactic halo and of the importance of MHD waves as a heating process of the halo gas.
With the goal of understanding why X-rays have been reported near some high velocity clouds, we perform detailed 3 dimensional hydrodynamic and magnetohydrodynamic simulations of clouds interacting with environmental gas like that in the Galaxys thic
k disk/halo or the Magellanic Stream. We examine 2 scenarios. In the first, clouds travel fast enough to shock-heat warm environmental gas. In this scenario, the X-ray productivity depends strongly on the speed of the cloud and the radiative cooling rate. In order to shock-heat environmental gas to temperatures of > or = 10^6 K, cloud speeds of > or = 300 km/s are required. If cooling is quenched, then the shock-heated ambient gas is X-ray emissive, producing bright X-rays in the 1/4 keV band and some X-rays in the 3/4 keV band due to O VII and other ions. If, in contrast, the radiative cooling rate is similar to that of collisional ionizational equilibrium plasma with solar abundances, then the shocked gas is only mildly bright and for only about 1 Myr. The predicted count rates for the non-radiative case are bright enough to explain the count rate observed with XMM-Newton toward a Magellanic Stream cloud and some enhancement in the ROSAT 1/4 keV count rate toward Complex C, while the predicted count rates for the fully radiative case are not. In the second scenario, the clouds travel through and mix with hot ambient gas. The mixed zone can contain hot gas, but the hot portion of the mixed gas is not as bright as those from the shock-heating scenario.
In order to determine if the material ablated from high-velocity clouds (HVCs) is a significant source of low-velocity high ions (C IV, N V, and O VI) such as those found in the Galactic halo, we simulate the hydrodynamics of the gas and the time-dep
endent ionization evolution of its carbon, nitrogen, and oxygen ions. Our suite of simulations examines the ablation of warm material from clouds of various sizes, densities, and velocities as they pass through the hot Galactic halo. The ablated material mixes with the environmental gas, producing an intermediate-temperature mixture that is rich in high ions and that slows to the speed of the surrounding gas. We find that the slow mixed material is a significant source of the low-velocity O VI that is observed in the halo, as it can account for at least ~1/3 of the observed O VI column density. Hence, any complete model of the high ions in the halo should include the contribution to the O VI from ablated HVC material. However, such material is unlikely to be a major source of the observed C IV, presumably because the observed C IV is affected by photoionization, which our models do not include. We discuss a composite model that includes contributions from HVCs, supernova remnants, a cooling Galactic fountain, and photoionization by an external radiation field. By design, this model matches the observed O VI column density. This model can also account for most or all of the observed C IV, but only half of the observed N V.
High-velocity clouds (HVCs) are neutral or ionised gas clouds in the vicinity of the Milky Way that are characterised by high radial velocities inconsistent with participation in the regular rotation of the Galactic disc. Previous attempts to create
a homogeneous all-sky HI map of HVCs have been hampered by a combination of poor angular resolution, limited surface brightness sensitivity and suboptimal sampling. Here, a new and improved HI map of Galactic HVCs based on the all-sky HI4PI survey is presented. The new map is fully sampled and provides significantly better angular resolution (16.2 versus 36 arcmin) and column density sensitivity (2.3 versus 3.7 * 10^18 cm^-2 at the native resolution) than the previously available LAB survey. The new HVC map resolves many of the major HVC complexes in the sky into an intricate network of narrow HI filaments and clumps that were not previously resolved by the LAB survey. The resulting sky coverage fraction of high-velocity HI emission above a column density level of 2 * 10^18 cm^-2 is approximately 15 per cent, which reduces to about 13 per cent when the Magellanic Clouds and other non-HVC emission are removed. The differential sky coverage fraction as a function of column density obeys a truncated power law with an exponent of -0.93 and a turnover point at about 5 * 10^19 cm^-2. HI column density and velocity maps of the HVC sky are made publicly available as FITS images for scientific use by the community.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
