اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRecord-High Proximity-Induced Anomalous Hall Effect in (Bi$_x$Sb$_{1-x}$)2Te$_3$ Thin Film Grown on CrGeTe$_3$ Substrate
88
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Quantum anomalous Hall effect(QAHE) can only be realized at extremely low temperatures in magnetically doped topological insulators(TIs) due to limitations inherent with the doping precess. In an effort to boost the quantization temperature of QAHE, magnetic proximity effect in magnetic insulator/TI heterostructures has been extensively investigated. However, the observed anomalous Hall resistance has never been more than several Ohms, presumably owing to the interfacial disorders caused by the structural and chemical mismatch. Here, we show that, by growing (BixSb1-x)2Te3(BST) thin films on structurally and chemically well-matched, ferromagnetic-insulating CeGeTe3(CGT) substrates, the proximity-induced anomalous Hall resistance can be enhanced by more than an order of magnitude. This sheds light on the importance of structural and chemical match for magnetic insulator/TI proximity systems.
قيم البحث
اقرأ أيضاً
We performed x-ray magnetic circular dichroism (XMCD) measurements on heterostructures comprising topological insulators (TIs) of the (Bi,Sb)$_2$(Se,Te)$_3$ family and the magnetic insulator EuS. XMCD measurements allow us to investigate element-sele
ctive magnetic proximity effects at the very TI/EuS interface. A systematic analysis reveals that there is neither significant induced magnetism within the TI nor an enhancement of the Eu magnetic moment at such interface. The induced magnetic moments in Bi, Sb, Te, and Se sites are lower than the estimated detection limit of the XMCD measurements of $sim!10^{-3}$ $mu_mathrm{B}$/at.
The influence of Sb content, substrate type and cap layers on the quantum anomalous Hall effect observed in V-doped (Bi,Sb)$_2$Te$_3$ magnetic topological insulators is investigated. Thin layers showing excellent quantization are reproducibly deposit
ed by molecular beam epitaxy at growth conditions effecting a compromise between controlled layer properties and high crystalline quality. The Sb content can be reliably determined from the in-plane lattice constant measured by X-ray diffraction, even in thin layers. This is the main layer parameter to be optimized in order to approach charge neutrality. Within a narrow range at about 80% Sb content, the Hall resistivity shows a maximum of about 10 k$Omega$ at 4 K and quantizes at mK temperatures. Under these conditions, thin layers grown on Si(111) or InP(111) and with or without a Te cap exhibit quantization. The quantization persists independently of the interfaces between cap, layer and substrate, the limited crystalline quality, and the degradation of the layer proving the robustness of the quantum anomalous Hall effect.
The Weyl antiferromagnet Mn$_3$Sn has recently attracted significant attention as it exhibits various useful functions such as large anomalous Hall effect that are normally absent in antiferromagnets. Here we report the thin film fabrication of the s
ingle phase of Mn$_3$Sn and the observation of the large anomalous Hall effect at room temperature despite its vanishingly small magnetization. Our work on the high-quality thin film growth of the Weyl antiferromagnet paves the path for developing the antiferromagnetic spintronics.
We electrically detect charge current induced spin polarization on the surface of molecular beam epitaxy grown Bi$_2$Te$_3$ thin film in a two-terminal device with a ferromagnetic MgO/Fe and a nonmagnetic Ti/Au contact. The two-point resistance, meas
ured in an applied magnetic field, shows a hysteresis tracking the magnetization of the Fe. A theoretical estimate is obtained for the change in resistance on reversing the magnetization direction of Fe from coupled spin-charge transport equations based on quantum kinetic theory. The order of magnitude and the sign of the hysteresis is consistent with spin-polarized surface state of Bi$_2$Te$_3$.
Alloys of Bi$_2$Te$_3$ and Sb$_2$Te$_3$ ((Bi$_{1-x}$Sb$_x$)$_2$Te$_3$) have played an essential role in the exploration of topological surface states, allowing us to study phenomena that would otherwise be obscured by bulk contributions to conductivi
ty. Thin films of these alloys have been particularly important for tuning the energy of the Fermi level, a key step in observing spin-polarized surface currents and the quantum anomalous Hall effect. Previous studies reported the chemical tuning of the Fermi level to the Dirac point by controlling the Sb:Bi composition ratio, but the optimum ratio varies widely across various studies with no consensus. In this work, we use scanning tunneling microscopy and Landau level spectroscopy, in combination with X-ray photoemission spectroscopy to isolate the effects of growth factors such as temperature and composition, and to provide a microscopic picture of the role that disorder and composition play in determining the carrier density of epitaxially grown (Bi,Sb)$_2$Te$_3$ thin films. Using Landau level spectroscopy, we determine that the ideal Sb concentration to place the Fermi energy to within a few meV of the Dirac point is $xsim 0.7$. However, we find that the post- growth annealing temperature can have a drastic impact on microscopic structure as well as carrier density. In particular, we find that when films are post-growth annealed at high temperature, better crystallinity and surface roughness are achieved; but this also produces a larger Te defect density, adding n-type carriers. This work provides key information necessary for optimizing thin film quality in this fundamentally and technologically important class of materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
