اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDetection mechanism in highly sensitive ZnO nanowires network gas sensors
145
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Metal-oxide nanowires are showing a great interest in the domain of gas sensing due to their large response even at a low temperature, enabling low-power gas sensors. However their response is still not fully understood, and mainly restricted to the linear response regime, which limits the design of appropriate sensors for specific applications. Here we analyse the non-linear response of a sensor based on ZnO nanowires network, both as a function of the device geometry and as a response to oxygen exposure. Using an appropriate model, we disentangle the contribution of the nanowire resistance and of the junctions between nanowires in the network. The applied model shows a very good consistency with the experimental data, allowing us to demonstrate that the response to oxygen at room temperature is dominated by the barrier potential at low bias voltage, and that the nanowire resistance starts to play a role at higher bias voltage. This analysis allows us to find the appropriate device geometry and working point in order to optimize the sensitivity. Such analysis is important for providing design rules, not only for sensing devices, but also for applications in electronics and opto-electronics using nanostructures networks with different materials and geometries.
قيم البحث
اقرأ أيضاً
The synthesis, morphology and magneto-transport properties of nanostructure-engineered charge-ordered Pr0.5Ca0.5MnO3 grown on ZnO nanowires are reported. The stability of the charge-ordering can be tuned, but more interestingly the sign of the magnet
oresistance is inverted at low temperatures. Coexistence of ferromagnetic clusters on the surface and antiferromagnetic phase in the core of the grains were considered in order to understand these features. This work suggests that such a process of growing on nanowires network can be readily extended to other transition metal oxides and open doors towards tailoring their functionalities.
Mycotoxins comprise a frequent type of toxins present in food and feed. The problem of mycotoxin contamination has been recently aggravated due to the increased complexity of the farm-to-fork chains, resulting in negative effects on human and animal
health and, consequently, economics. The easy-to-use, on-site, on-demand, and rapid monitoring of mycotoxins in food/feed is highly desired. In this work, we report on an advanced bioelectronic mycotoxin sensor based on graphene field-effect transistors integrated on a silicon chip. A specific aptamer for Ochratoxin A (OTA) was attached to graphene through covalent bonding with the pyrene-based linker, which was deposited with an electric field stimulation to increase the surface coverage. This graphene/aptamer sensor demonstrates high sensitivity to OTA with the lowest detection limit of 1.4 pM within a response time of 10 s which is superior to any other reported aptamer-based methods.
We simulated and experimentally investigated the sputter yield of ZnO and GaAs nanowires, which were implanted with energetic Mn ions at room temperature. The resulting thinning of the nanowires and the dopant concentration with increasing Mn ion flu
ency were measured by accurate scanning electron microscopy (SEM) and nano-X-Ray Fluorescence (nanoXRF) quantification, respectively. We observed a clear enhanced sputter yield for the irradiated nanowires compared to bulk, which is also corroborated by iradina simulations. These show a maximum if the ion range matches the nanowire diameter. As a consequence of the erosion thinning of the nanowire, the incorporation of the Mn dopants is also enhanced and increases non-linearly with increasing ion fluency.
The optical properties of a stack of GaN/AlN quantum discs (QDiscs) in a GaN nanowire have been studied by spatially resolved cathodoluminescence (CL) at the nanoscale (nanoCL) using a Scanning Transmission Electron Microscope (STEM) operating in spe
ctrum imaging mode. For the electron beam excitation in the QDisc region, the luminescence signal is highly localized with spatial extension as low as 5 nm due to the high band gap difference between GaN and AlN. This allows for the discrimination between the emission of neighbouring QDiscs and for evidencing the presence of lateral inclusions, about 3 nm thick and 20 nm long rods (quantum rods, QRods), grown unintentionally on the nanowire sidewalls. These structures, also observed by STEM dark-field imaging, are proven to be optically active in nanoCL, emitting at similar, but usually shorter, wavelengths with respect to most QDiscs.
We have studied the electronic structure and the magnetism of Cu-doped ZnO nanowires, which have been reported to show ferromagnetism at room temperature [G. Z. Xing ${et}$ ${al}$., Adv. Mater. {bf 20}, 3521 (2008).], by x-ray photoemission spectrosc
opy (XPS), x-ray absorption spectroscopy (XAS) and x-ray magnetic circular dichroism (XMCD). From the XPS and XAS results, we find that the Cu atoms are in the Cu$^{3+}$ state with mixture of Cu$^{2+}$ in the bulk region ($sim$ 100 nm), and that Cu$^{3+}$ ions are dominant in the surface region ($sim$ 5 nm), i.e., the surface electronic structure of the surface region differs from the bulk one. From the magnetic field and temperature dependences of the XMCD intensity, we conclude that the ferromagnetic interaction in ZnO:Cu NWs comes from the Cu$^{2+}$ and Cu$^{3+}$ states in the bulk region, and that most of the doped Cu ions are magnetically inactive probably because they are antiferromagnetically coupled with each other.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
