اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOptimization of Undulator Parameters for 125 GeV Drive Beam
78
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In the baseline design of the International Linear Collider (ILC) an undulator-based source is foreseen for the positron source in order to match the physics requirements. The baseline parameters are optimized for the ILC at sqrt(s)=500 GeV, that means an electron drive beam of 250 GeV. Precision measurements in the Higgs sector, however, require measurements at sqrt(s)=250 GeV, i.e. running with the electron drive beam only at 125 GeV, which imposes a challenge for achieving a high yield. Therefore the baseline undulator parameters have to be optimized as much as possible within their technical performances. In this bachelor thesis we therefore present a theoretical study on the radiation spectra of a helical undulator, based on the equation for the radiated synchrotron energy spectral density per solid angle per electron in the relativistic, far-field and point-like charge approximation. From this starting point the following undulator properties are examined: the deposited power in the undulator vessel, which can disrupt the functionality of the undulator magnets, the protective property of a mask on this disturbances and the number of positrons produced by the synchrotron radiation in a Ti6Al4V target. Those quantities were evaluated for various values for parameters as undulator period, undulator length and magnetic flux in order to find optimal baseline parameter sets for sqrt(s)=250 GeV.
قيم البحث
اقرأ أيضاً
In the future the International Linear Collider (ILC), a helical undulator-based polarized positron source, is expected to be chosen. A high energy electron beam passes through a superconducting helical undulator in order to create circularly polariz
ed photons which will be directed to a conversion target, resulting in electron-positron pairs. The resulting positron beam is longitudinally polarized. Since the photons are produced with an opening angle and pass through a long superconducting helical undulator, some of these photons will strike the undulator walls. Therefore photon masks must be placed along the undulator line in order to keep the power deposited in the undulator walls below the acceptable limit of 1W/m. The baseline design of the ILC is focused on 250 GeV center-of-mass energy and upgrade to center-of-mass energies of 350 and 500 GeV is foreseen. This paper shows a detailed study of the ideal power deposited along the masks for both 350 and 500 GeV center-of-mass energies.
The undulator line of the Shanghai soft X-ray Free-electron Laser facility (SXFEL) has very tight tolerances on the straightness of the electron beam trajectory. However, the beam trajectory cannot meet the lasing requirements due to the influence of
beam position, launch angle and quadrupole offsets. Traditional mechanical alignment can only control the rms of offsets to about 100 $mu$m, which is far from reaching the requirement. Further orbit correction can be achieved by beam-based alignment (BBA) method based on electron energy variations. K modulation is used to determine whether the beam passes through the quadrupole magnetic center, and the Dispersion-Free Steering (DFS) method is used to calculate the offsets of quadrupole and BPM. In this paper, a detailed result of simulation is presented which demonstrates that the beam trajectory with rms and standard deviation ($sigma$) less than 10 $mu$m can be obtained.
Generally, turn-to-turn power fluctuations of incoherent spontaneous synchrotron radiation in a storage ring depend on the 6D phase-space distribution of the electron bunch. In some cases, if only one parameter of the distribution is unknown, this pa
rameter can be determined from the measured magnitude of these power fluctuations. In this Letter, we report an absolute measurement (no free parameters or calibration) of a small vertical emittance (5--15 nm rms) of a flat beam by this method, under conditions, when it is unresolvable by a conventional synchrotron light beam size monitor.
Solenoids are frequently used for focusing of the low energy electron beams. In this paper we focus on using these magnets as a nearly universal tool for measuring beam parameters including energy, emittance, and the beam position and angle with resp
ect to the solenoid axis. We describe in detail corresponding procedures as well as experimental results of such measurements.
As the second stage of the CEPC-SPPC project, SPPC (Super Proton-Proton Collider) aims at exploring new physics beyond the Standard Model. The key design goal for the SPPC accelerator complex is to reach 75 TeV in center of mass energy with a circumf
erence of 100 km for the collider and an injector chain of four accelerators in cascade to support the collider. As an important part of the SPPC conceptual study, the longitudinal beam dynamics was studied systematically, which includes the dynamics in the collider and its complex injector chain. First, the bunch filling scheme of the SPPC complex was designed on the basis of various constraints such as the technical challenges of the kicker magnets, limited extraction energy per injection and so on. Next, the study on the longitudinal dynamics in the collider focused on the RF scheme to meet the requirements for luminosity and mitigate relevant instabilities. A higher harmonic RF system (800 MHz) together with the basic RF system (400 MHz) to form a dual-harmonic RF system was employed to mitigate collective instabilities and increase the luminosity by producing shorter bunches. In addition, the longitudinal matchings between the bunches in the different accelerator stages were studied, with special attention to the space charge effects and the beam loading effect in the two lower energy rings (p-RCS and MSS), which result in an optimization of the RF schemes. A set of self-consistent beam and RF parameters for the SPPC complex was obtained. The collider and the three proton synchrotrons of the injector chain have unprecedented features, thus this study demonstrates how a future proton-proton collider complex looks like.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
