اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEvaluation of Mg compounds as coating materials in Mg batteries
112
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Mg batteries utilizing a Mg metal anode with a high-voltage intercalation cathode define a potential pathway toward energy storage with high energy density. However, the realization of Mg batteries is plagued by the instability of existing electrolytes against the Mg-metal anode and high-voltage cathode materials. One viable solution to this problem is the identification of protective coating materials that could effectively separate the distinct chemistries of the metal-anode and the cathode materials from the electrolyte. Using first-principles calculations we map the electrochemical stability windows for non-redox-active Mg binary and ternary compounds in order to identify potential coating materials for Mg batteries. Our results identify Mg-halides and Mg(BH$_4$)$_2$ as promising anode coating materials based on their significant reductive stability. On the cathode side, we single out MgF$_2$, Mg(PO$_3$)$_2$ and MgP$_4$O$_11$ as effective passivating agents.
قيم البحث
اقرأ أيضاً
Nitrides feature many interesting properties, such as a wide range of bandgaps suitable for optoelectronic devices including light-emitting diodes (LEDs), and piezoelectric response used in microelectromechanical systems (MEMS). Nitrides are also sig
nificantly underexplored compared to oxides and other chemistries, with many being thermochemically metastable, sparking interest from a basic science point of view. This paper reports on experimental and computational exploration of the Mg-Sb-N material system, featuring both metastable materials and interesting semiconducting properties. Using sputter deposition, we discovered a new Mg2SbN3 nitride with a wurtzite-derived crystal structure and synthesized the antimonide-nitride Mg3SbN with an antiperovskite crystal structure for the first time in thin film form. Theoretical calculations indicate that Mg2SbN3 is metastable and has properties relevant to LEDs and MEMS, whereas Mg3SbN has a large dielectric constant (28epsilon_0) and low hole effective masses (0.9m_0), of interest for photovoltaic solar cell absorbers. The experimental solar-matched 1.3 eV optical absorption onset of the Mg3SbN antiperovskite agrees with the theoretical prediction (1.3 eV direct, 1.1 eV indirect), and with the measurements of room-temperature near-bandgap photoluminescence. These results make an important contribution towards understanding semiconductor properties and chemical trends in the Mg-Sb-N materials system, paving the way to future practical applications of these novel materials.
The diversified essential properties of the stage-n graphite alkali-intercalation compounds are thoroughly explored by the first-principles calculations. According to their main features, the lithium and non-lithium materials might be quite different
from each other in stacking configurations, the intercalated alkali-atom concentrations, the free conduction electron densities, and the atom-dominated & (carbon, alkali)-co-dominated energy bands. The close relations between the alkali-doped metallic behaviors and the geometric symmetries will be clarified through the interlayer atomic interactions, in which the significant alkali-carbon chemical bondings are fully examined from the atom- and orbital-decomposed van Hove singularities. The blue shift of the Fermi level, the n-type doping, is clearly identified from the low-energy features of the density of states. This study is able to provide the partial information about anode of Li+-based battery. There are certain important differences between AC$_6$/AC$_8$ and Li$_8$Si$_4$O$_{12}$.
MgB2 samples prepared by solid-state reaction were investigated using high-resolution transmission electron microscopy (HREM), X-ray energy-dispersive spectroscopy (EDX), electron energy-loss spectroscopy (EELS), and energy-filtered imaging. Large am
ounts of coherent precipitates with a size range from about 5 nm up to about 100 nm were found in the MgB2 crystallite matrices. The precipitates are of different shapes including sphere, ellipsoid, and faceted polyhedron depending on the size of the precipitates. EDX and EELS analyses confirm that smaller precipitates contain magnesium, boron and oxygen while larger faceted precipitates contain mainly magnesium and oxygen, implying that the oxygen content increases with precipitate size. HREM and electron diffraction investigations found that the precipitates have the same crystal lattice structure as that of MgB2 but with various composition modulations depending on the composition of the precipitates. The precipitates transform to the MgO phase after long exposure to residual oxygen in flowing Ar gas at high temperatures. The effect of the precipitates in different size ranges on flux pinning is discussed.
We study the introduction of a third material, namely Zr, within a nanometric periodic Mg/Co structure designed to work as optical component in the extreme UV (EUV) spectral range. Mg/Co, Mg/Zr/Co, Mg/Co/Zr and Mg/Zr/Co/Zr multilayers are designed, t
hen characterized in terms of structural quality and optical performances through X-ray and EUV reflectometry measurements respectively. For the Mg/Co/Zr structure, the reflectance value is equal to 50% at 25.1 nm and 45deg of grazing incidence and reaches 51.3% upon annealing at 200deg C. Measured EUV reflectivity values of tri-layered systems are discussed in terms of material order within a period and compared to the predictions of the theoretical model of Larruquert. Possible applications are pointed out.
Close-packed chalcogenide spinels, such as MgSc$_2$Se$_4$, MgIn$_2$S$_4$ and MgSc$_2$S$_4$, show potential as solid electrolytes in Mg batteries, but are affected by non-negligible electronic conductivity, which contributes to self-discharge when use
d in an electrochemical storage device. Using first-principles calculations, we evaluate the energy of point defects as function of synthesis conditions and Fermi level to identify the origins of the undesired electronic conductivity. Our results suggest that Mg-vacancies and Mg-metal anti-sites (where Mg is exchanged with Sc or In) are the dominant point defects that can occur in the systems under consideration. While we find anion-excess conditions and slow cooling to likely create conditions for low electronic conductivity, the spinels are likely to exhibit significant $n$-type conductivity under anion-poor environments, which are often present during high temperature synthesis. Finally, we explore extrinsic aliovalent doping to potentially mitigate the electronic conductivity in these chalcogenide spinels. The computational strategy is general and can be easily extended to other solid electrolytes (and electrodes) to aid in the optimization of the electronic properties of the corresponding frameworks.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
