اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBackward wave oscillator with resonator made of metal foils (photonic BWO)
106
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Numerical and experimental analysis of high power microwave generation in photonic BWO, which uses foil photonic crystal, is presented. Single frequency excitation of the below cutoff modes in the photonic BWO is analyzed and demonstrated.
قيم البحث
اقرأ أيضاً
A 325MHz beta=0.14 superconducting half wave resonator(HWR) prototype has been developed at the Institute of High Energy Physics(IHEP), which can be applied in continuous wave (CW) high beam proton accelerators. In this paper, the electromagnetic (EM
) design, multipacting simulation, mechanical optimization, and fabrication are introduced in details. In vertical test at 4.2K, the cavity reached Eacc=7MV/m with Q0=1.4*10^9 and Eacc=15.9MV/m with Q0=4.3*10^8.
Transverse mode-coupling instability (TMCI) with a high-frequency resonator wake is examined by the Nested Head-Tail Vlasov solver (NHT), where a Gaussian bunch in a parabolic potential (GP model) is represented by concentric rings in the longitudina
l phase space. It is shown that multiple mode couplings and decouplings make impossible an unambiguous definition of the threshold, unless Landau damping is taken into account. To address this problem, instead of a single instability threshold, an interval of thresholds is suggested, bounded by the low and high intensity ones. For the broadband impedance model, the high intensity threshold is shown to follow Zotters scaling, but smaller by about a factor of two. The same scaling, this time smaller than Zotters by a factor of four, is found for the ABS model (Air Bag Square well).
A 162.5 MHz superconducting half-wave resonator (HWR) with geometry beta of 0.09 is being developed for Injector II of China Accelerator Driven Sub-critical System (CADS) Project at the Institute of Modern Physics (IMP). The HWR section composed of 1
6 HWR cavities will accelerate the proton beam from 2.1 MeV to 10 MeV. The RF and mechanical coupled analysis are essential in geometry design in order to predict the deformation of the cavity walls and the frequency shift caused by the deformation. In this paper, the detuning caused by both bath helium pressure and Lorentz force is analysed and a tuning system has been investigated and designed to compensate the detuning by deforming the cavity along the beam axis. The simulations performed with ANSYS code show that the tuning system can adjust and compensate the frequency drift due to external vibrations and helium pressure fluctuation during operation.
Charge-exchange injection by means of carbon foils is a widely used method in accelerators. This paper discusses two critical issues concerning the use of carbon foils: efficiency and lifetime. An energy scaling of stripping efficiency was suggested
and compared with measurements. Several factors that determine the foil lifetime - energy deposition, heating, stress and buckling - were studied by using the simulation codes MARS and ANSYS.
Two superconducting quarter-wave resonator (QWR) prototypes have been fabricated and tested. They operate at 80.5 MHz and 161 MHz and are optimised for beta = 0.085 and beta = 0.16, respectively. The prototypes are simplifie
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
