اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStrategy for accurate thermal biasing at the nanoscale
146
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We analyze the benefits and shortcomings of a thermal control in nanoscale electronic conductors by means of the contact heating scheme. Ideally, this straightforward approach allows one to apply a known thermal bias across nanostructures directly through metallic leads, avoiding conventional substrate intermediation. We show, by using the average noise thermometry and local noise sensing technique in InAs nanowire based devices, that a nanoscale metallic constriction on a SiO2 substrate acts like a diffusive conductor with negligible electron-phonon relaxation and non-ideal leads. The non-universal impact of the leads on the achieved thermal bias -- which depends on their dimensions, shape and material composition -- is hard to minimize, but is possible to accurately calibrate in a properly designed nano-device. Our results allow to reduce the issue of the thermal bias calibration to the knowledge of the heater resistance and pave the way for accurate thermoelectric or similar measurements at the nanoscale.
قيم البحث
اقرأ أيضاً
We study by scanning thermal microscopy the nanoscale thermal conductance of films (40 to 400 nm thick) of [1]benzothieno[3,2-b][1]benzothiophene (BTBT) and 2,7-dioctyl[1]benzothieno[3,2-b][1]benzothiophene (C8-BTBT-C8). We demonstrate that the out-o
f-plane thermal conductivity is significant along the interlayer direction, larger for BTBT (0.63 +/- 0.12 W m-1 K-1) compared to C8-BTBT-C8 (0.25 +/- 0.13 W m-1 K-1). These results are supported by molecular dynamics calculations (Approach to Equilibrium Molecular Dynamics method) performed on the corresponding molecular crystals. The calculations point to significant thermal conductivity (3D-like) values along the 3 crystalline directions, with anisotropy factors between the crystalline directions below 1.8 for BTBT and below 2.8 for C8-BTBT-C8, in deep contrast with the charge transport properties featuring a two-dimensional character for these materials. In agreement with the experiments, the calculations yield larger values in BTBT compared to C8-BTBT-C8 (0.6-1.3 W m-1 K-1 versus 0.3-0.7 W m-1 K-1, respectively). The weak thickness dependence of the nanoscale thermal resistance is in agreement with a simple analytical model.
The reduction of the thermal conductivity in nanostructures opens up the possibility of exploiting for thermoelectric purposes also materials such as silicon, which are cheap, available and sustainable but with a high thermal conductivity in their bu
lk form. The development of thermoelectric devices based on these innovative materials requires reliable techniques for the measurement of thermal conductivity on a nanometric scale. The approximations introduced by conventional techniques for thermal conductivity measurements can lead to unreliable results when applied to nanostructures, because heaters and temperature sensors needed for the measurement cannot have a negligible size, and therefore perturb the result. In this paper we focus on the 3$omega$ technique, applied to the thermal conductivity measurement of suspended silicon nanomembranes. To overcome the approximations introduced by conventional analytical models used for the interpretation of the 3$omega$ data, we propose to use a numerical solution, performed by means of finite element modeling, of the thermal and electrical transport equations. An excellent fit of the experimental data will be presented, discussed, and compared with an analytical model.
There is a growing effort in creating chiral transport of sound waves. However, most approaches so far are confined to the macroscopic scale. Here, we propose a new approach suitable to the nanoscale which is based on pseudomagnetic fields. These fie
lds are the analogon for sound of the pseudomagnetic field for electrons in strained graphene. In our proposal, they are created by simple geometrical modifications of an existing and experimentally proven phononic crystal design, the snowflake crystal. This platform is robust, scalable, and well-suited for a variety of excitation and readout mechanisms, among them optomechanical approaches.
Wettability is the affinity of a liquid for a solid surface. For energetic reasons, macroscopic drops of liquid are nearly spherical away from interfaces with solids, and any local deformations due to molecular-scale surface interactions are negligib
le. Studies of wetting phenomena, therefore, typically assume that a liquid on a surface adopts the shape of a spherical cap. The degree of wettability is then captured by the contact angle where the liquid-vapor interface meets the solid-liquid interface. As droplet volumes shrink to the scale of attoliters, however, surface interactions become significant, and droplets gradually assume distorted shapes that no longer comply with our conventional, macroscopic conception of a drop. In this regime, the contact angle becomes ambiguous, and it is unclear how to parametrize a liquids affinity for a surface. A scalable metric for quantifying wettability is needed, especially given the emergence of technologies exploiting liquid-solid interactions at the nanoscale. Here we combine nanoscale experiments with molecular-level simulation to study the breakdown of spherical droplet shapes at small length scales. We demonstrate how measured droplet topographies increasingly reveal non-spherical features as volumes shrink, in agreement with theoretical predictions. Ultimately, the nanoscale liquid flattens out to form layer-like molecular assemblies, instead of droplets, at the solid surface. For the lack of a consistent contact angle at small scales, we introduce a droplets adsorption energy density as a new metric for a liquids affinity for a surface. We discover that extrapolating the macroscopic idealization of a drop to the nanoscale, though it does not geometrically resemble a realistic droplet, can nonetheless recover its adsorption energy if line tension is properly included.
We have performed quantum Monte Carlo simulations measuring the finite size and temperature superfluid response of helium-4 to the linear and rotational motion of the walls of a nanopore. Within the two-fluid model, the portion of the normal liquid d
ragged along with the boundaries is dependent on the type of motion and the resulting anisotropic superfluid density saturates far below unity at T=0.5 K. The origin of the saturation is uncovered by computing the spatial distribution of superfluidity, with only the core of the nanopore exhibiting any evidence of phase coherence. The superfluid core displays scaling behavior consistent with Luttinger liquid theory, thereby providing an experimental test for the emergence of a one dimensional quantum liquid.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
