ترغب بنشر مسار تعليمي؟ اضغط هنا

LOCNES: Low Cost NIR Extended Solar Telescope

56   0   0.0 ( 0 )
 نشر من قبل Riccardo Claudi
 تاريخ النشر 2018
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

The search for telluric extrasolar planets with the Radial Velocity (RV) technique is intrinsically limited by the stellar jitter due to the activity of the star, because stellar surface inhomogeneities, including spots, plages and convective granules, induce perturbations hiding or even mimicking the planetary signal. This kind of noise is poorly understood in all the stars, but the Sun, due to their unresolved surfaces. For these reasons, the effects of the surface inhomogeneities on the measurement of the RV are very difficult to characterize. On the other hand, a better knowledge of these phenomena can allow us a step forward in our understanding of solar and stellar RV noise sources. This will allow to develop more tools for an optimal activity correction leading to more precise stellar RVs. Due to the high spatial resolution with which the Sun is observed, this noise is well known for it. Despite this, a link is lacking between the single observed photospheric phenomena and the behavior of the Sun observed as a star. LOCNES (Low Cost NIR Extended Solar Telescope) will allow to gather time series of RVs in order to disentangle the different contributions to the stellar (i.e., solar) RV jitter. Since July 2015, a Low Cost Solar Telescope (LCST) has been installed outside the TNG dome to feed solar light to the HARPS-N spectrograph (0.38-0.69 $mu$m; R=115000). The refurbishment of the Near Infrared (NIR) High Resolution Spectrograph GIANO (now GIANO-B) and the new observing mode GIARPS at TNG (simultaneous observations in visible with HARPS-N and in NIR with GIANO-B) is a unique opportunity to extend the wavelength range up to 2.4 $mu$m for measuring the RV time series of the Sun as a star. This paper outlines the LOCNES project and its scientific drivers.

قيم البحث

اقرأ أيضاً

105 - J.E. Grove , C.C. Cheung , M. Kerr 2020
We describe Glowbug, a gamma-ray telescope for bursts and other transients in the 30 keV to 2 MeV band. It was recently selected for funding by the NASA Astrophysics Research and Analysis program, with an expected launch in the early 2020s. Similar i n concept to the Fermi Gamma Burst Monitor (GBM) and with similar sensitivity, Glowbug will join and enhance future networks of burst telescopes to increase sky coverage to short Gamma-Ray Bursts (SGRBs) from binary neutron star (BNS) mergers, including possible SGRBs from NS-black hole mergers. With the recent discovery of the SGRB coincident with the gravitational wave transient GW170817, we know such events occur with reasonable frequency. Expanded sky coverage in gamma rays is essential, as more detections of gravitational waves are expected with the improved sensitivity of the upgraded ground-based interferometers in the coming years.
We present an overview of the ICE hardware and software framework that implements large arrays of interconnected FPGA-based data acquisition, signal processing and networking nodes economically. The system was conceived for application to radio, mill imeter and sub-millimeter telescope readout systems that have requirements beyond typical off-the-shelf processing systems, such as careful control of interference signals produced by the digital electronics, and clocking of all elements in the system from a single precise observatory-derived oscillator. A new generation of telescopes operating at these frequency bands and designed with a vastly increased emphasis on digital signal processing to support their detector multiplexing technology or high-bandwidth correlators---data rates exceeding a terabyte per second---are becoming common. The ICE system is built around a custom FPGA motherboard that makes use of an Xilinx Kintex-7 FPGA and ARM-based co-processor. The system is specialized for specific applications through software, firmware, and custom mezzanine daughter boards that interface to the FPGA through the industry-standard FMC specifications. For high density applications, the motherboards are packaged in 16-slot crates with ICE backplanes that implement a low-cost passive full-mesh network between the motherboards in a crate, allow high bandwidth interconnection between crates, and enable data offload to a computer cluster. A Python-based control software library automatically detects and operates the hardware in the array. Examples of specific telescope applications of the ICE framework are presented, namely the frequency-multiplexed bolometer readout systems used for the SPT and Simons Array and the digitizer, F-engine, and networking engine for the CHIME and HIRAX radio interferometers.
We describe the design, construction and commissioning of LOTUS; a simple, low-cost long-slit spectrograph for the Liverpool Telescope. The design is optimized for near-UV and visible wavelengths and uses all transmitting optics. It exploits the inst rument focal plane field curvature to partially correct axial chromatic aberration. A stepped slit provides narrow (2.5x95 arcsec) and wide (5x25 arcsec) options that are optimized for spectral resolution and flux calibration respectively. On sky testing shows a wavelength range of 3200-6300 Angstroms with a peak system throughput (including detector quantum efficiency) of 15 per cent and wavelength dependant spectral resolution of R=225-430. By repeated observations of the symbiotic emission line star AG Peg we demonstrate the wavelength stability of the system is less than 2 Angstroms rms and is limited by the positioning of the object in the slit. The spectrograph is now in routine operation monitoring the activity of comet 67P/Churyumov-Gerasimenko during its current post-perihelion apparition.
CubeSats are routinely used for low-cost photometry from space. Space-borne spectroscopy, however, is still the exclusive domain of much larger platforms. Key astrophysical questions in e.g. stellar physics and exoplanet research require uninterrupte d spectral monitoring from space over weeks or months. Such monitoring of individual sources is unfortunately not affordable with these large platforms. With CUBESPEC we plan to offer the astronomical community a low-cost CubeSat solution for near-UV/optical/near-IR spectroscopy that enables this type of observations. CUBESPEC is a generic spectrograph that can be configured with minimal hardware changes to deliver both low resolution (R=100) with very large spectral coverage (200-1000nm), as well as high resolution (R=30,000) over a selected wavelength range. It is built around an off-axis Cassegrain telescope and a slit spectrograph with configurable dispersion elements. CUBESPEC will use a compact attitude determination and control system for coarse pointing of the entire spacecraft, supplemented with a fine-guidance system using a fast steering mirror to center the source on the spectrograph slit and to cancel out satellite jitter. An extremely compact optical design allows us to house this instrument in a 6U CubeSat with a volume of only 10x20x30cm$^{3}$, while preserving a maximized entrance pupil of ca. 9x19cm$^{2}$. In this contribution, we give an overview of the CUBESPEC project, discuss its most relevant science cases, and present the design of the instrument.
74 - Rene Heller 2020
The solar photon pressure provides a viable source of thrust for spacecraft in the solar system. Theoretically it could also enable interstellar missions, but an extremely small mass per cross section area is required to overcome the solar gravity. W e identify aerographite, a synthetic carbon-based foam with a density of 0.18 kg/m^3 (15,000 times more lightweight than aluminum) as a versatile material for highly efficient propulsion with sunlight. A hollow aerographite sphere with a shell thickness eps_shl = 1 mm could go interstellar upon submission to the solar radiation in interplanetary space. Upon launch at 1 AU from the Sun, an aerographite shell with eps_shl = 0.5 mm arrives at the orbit of Mars in 60 d and at Plutos orbit in 4.3 yr. Release of an aerographite hollow sphere, whose shell is 1 micrometer thick, at 0.04 AU (the closest approach of the Parker Solar Probe) results in an escape speed of nearly 6900 km/s and 185 yr of travel to the distance of our nearest star, Proxima Centauri. The infrared signature of a meter-sized aerographite sail could be observed with JWST up to 2 AU from the Sun, beyond the orbit of Mars. An aerographite hollow sphere with eps_shl = 100 micrometer and a radius of 1 m (5 m) weighs 230 mg (5.7 g) and has a 2.2 g (55 g) mass margin for interstellar escape. The payload margin is ten times the mass of the spacecraft, whereas the payload on chemical interstellar rockets is typically a thousandth of the weight of the rocket. Simplistic communication would enable studies of the interplanetary medium and a search for the suspected Planet Nine, and would serve as a precursor mission to alpha Centauri. We estimate prototype developments costs of 1 million USD, a price of 1000 USD per sail, and a total of <10 million USD including launch for a piggyback concept with an interplanetary mission.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا