اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHot prominence detected in the core of a Coronal Mass Ejection: III. Plasma filling factor from UVCS Lyman-$alpha$ and Lyman-$beta$ observations
65
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This work deals with the study of an erupting prominence embedded in the core of a CME and focuses on the derivation of the prominence plasma filling factor. We explore two methods to measure the prominence plasma filling factor that are based on the combination of visible-light and ultraviolet spectroscopic observations. Theoretical relationships for resonant scattering and collisional excitation are used to evaluate the intensity of the H I Lyman-{alpha} and Lyman-{beta} lines, in two prominence points where simultaneous and cospatial LASCO-C2 and UVCS data were available. Thermodynamic and geometrical parameters assumed for the calculation are provided by both observations and the results of a detailed 1D non-LTE radiative-transfer model of the prominence, developed in our previous work (Heinzel 2016). The filling factor is derived from the comparison between the calculated and the measured intensities of the two lines. The results are then checked against the non-LTE model in order to verify the reliability of the methods. The resulting filling factors are consistent with the model in both the prominence points when the separation of the radiative and collisional components of the total intensity, required to estimate the filling factor, is performed using both the line intensities. An exploration of the parameter space shows that the results are weakly sensitive to the plasma velocity, but they depends more strongly on the assumed kinetic temperatures. The combination of visible-light and ultraviolet Lyman-{alpha} and Lyman-{beta} data can be used to approximately estimate the geometrical filling factor in erupting prominences, but the proposed techniques are reliable only for emission that is optically thin in the lines considered, condition that is not in general representative of prominence plasma.
قيم البحث
اقرأ أيضاً
Visible-light observations of Coronal Mass Ejections (CMEs) performed with coronagraphs and heliospheric imagers (in primis on board the SOHO and STEREO missions) have offered so far the best way to study the kinematics and geometrical structure of t
hese fundamental events. Nevertheless, it has been widely demonstrated that only combination of multi-wavelength data (including X-ray spectra, EUV images, EUV-UV spectra, and radio dynamic spectra) can provide complete information on the plasma temperature and density distributions, non-thermal motions, magnetic fields, and other physical parameters, for both CMEs and CME-related phenomena. In this work, we analyze three CMEs by combining simultaneous data acquired in the polarized visible light by the LASCO-C2 coronagraph and in the UV H I Lyman-$alpha$ line (1216 AA) by the UVCS spectrometer, in order to estimate the CME plasma electron density (using the polarization-ratio technique to infer the 3D structure of the CME) and temperature (from the comparison between the expected and measured Lyman-$alpha$ intensities) along the UVCS field of view. This analysis is primarily aimed at testing the diagnostic methods that will be applied to coronagraphic observations of CMEs delivered by the Metis instrument on board the next ESA-Solar Orbiter mission. We find that CME cores are usually associated with cooler plasma ($T sim 10^6$ K), and that a significant increase of the electron temperatures is observed from the core to the front of the CME (where $T > 10^{6.3}$ K), which seems to be correlated, in all cases, with the morphological structure of the CME as derived from visible-light images.
In this work UV and white light (WL) coronagraphic data are combined to derive the full set of plasma physical parameters along the front of a shock driven by a Coronal Mass Ejection. Pre-shock plasma density, shock compression ratio, speed and incli
nation angle are estimated from WL data, while pre-shock plasma temperature and outflow velocity are derived from UV data. The Rankine-Hugoniot (RH) equations for the general case of an oblique shock are then applied at three points along the front located between $2.2-2.6$ R$_odot$ at the shock nose and at the two flanks. Stronger field deflection (by $sim 46^circ$), plasma compression (factor $sim 2.7$) and heating (factor $sim 12$) occur at the nose, while heating at the flanks is more moderate (factor $1.5-3.0$). Starting from a pre-shock corona where protons and electrons have about the same temperature ($T_p sim T_e sim 1.5 cdot 10^6$ K), temperature increases derived with RH equations could better represent the protons heating (by dissipation across the shock), while the temperature increase implied by adiabatic compression (factor $sim 2$ at the nose, $sim 1.2-1.5$ at the flanks) could be more representative of electrons heating: the transit of the shock causes a decoupling between electron and proton temperatures. Derived magnetic field vector rotations imply a draping of field lines around the expanding flux rope. The shock turns out to be super-critical (sub-critical) at the nose (at the flanks), where derived post-shock plasma parameters can be very well approximated with those derived by assuming a parallel (perpendicular) shock.
Absorption between the rest-frame wavelengths of 973 and 1026 Angstroms in quasar spectra arises from two sources (apart from occasional metals): one is due to Lyman-alpha (Lya) absorption by materials at a low redshift, and the other from Lyman-beta
(Lyb) at a higher redshift. These two sources of absorption are to a good approximation uncorrelated because of their wide physical separation. Therefore, the two-point correlation of absorption in this region of quasar spectra neatly factorizes into two pieces: the Lyb correlation at high z, and the Lya correlation at low z. The latter can be independently measured from quasar spectra at lower redshifts using current techniques. A simple division then offers a way to statistically separate out the Lyb two-point correlation from the Lya correlation. Several applications of this technique are discussed. First, since the Lyb absorption cross-section is lower than Lya by about a factor of 5, the Lyb forest is a better probe of the intergalactic medium (IGM) at higher redshifts where Lya absorption is often saturated. Second, for the same reason, the Lyb forest allows a better measurement of the equation of state of the IGM at higher overdensities, yielding stronger constraints on its slope when used in conjunction with the Lya forest. Third, models of the Lya forest based on gravitational instability make unique predictions for the Lyb forest, which can be tested against observations. We briefly point out that feedback processes that affect higher density regions but leave low density structure intact may be better constrained by the Lyb forest.
We present a detailed three-dimensional (3D) view of a prominence eruption, coronal loop expansion, and coronal mass ejections (CMEs) associated with an M4.4 flare that occurred on 2011 March 8 in the active region NOAA 11165. Full-disk H$alpha$ imag
es of the flare and filament ejection were successfully obtained by the Flare Monitoring Telescope (FMT) following its relocation to Ica University, Peru. Multiwavelength observation around the H$alpha$ line enabled us to derive the 3D velocity field of the H$alpha$ prominence eruption. Features in extreme ultraviolet were also obtained by the Atmospheric Imager Assembly onboard the {it Solar Dynamic Observatory} and the Extreme Ultraviolet Imager on board the {it Solar Terrestrial Relations Observatory - Ahead} satellite. We found that, following collision of the erupted filament with the coronal magnetic field, some coronal loops began to expand, leading to the growth of a clear CME. We also discuss the succeeding activities of CME driven by multiple interactions between the expanding loops and the surrounding coronal magnetic field.
We perform a time-dependent ionization analysis to constrain plasma heating requirements during a fast partial halo coronal mass ejection (CME) observed on 2000 June 28 by the Ultraviolet Coronagraph Spectrometer (UVCS) aboard the Solar and Heliosphe
ric Observatory (SOHO). We use two methods to derive densities from the UVCS measurements, including a density sensitive O V line ratio at 1213.85 and 1218.35 Angstroms, and radiative pumping of the O VI 1032,1038 doublet by chromospheric emission lines. The most strongly constrained feature shows cumulative plasma heating comparable to or greater than the kinetic energy, while features observed earlier during the event show cumulative plasma heating of order or less than the kinetic energy. SOHO Michelson Doppler Imager (MDI) observations are used to estimate the active region magnetic energy. We consider candidate plasma heating mechanisms and provide constraints when possible. Because this CME was associated with a relatively weak flare, the contribution by flare energy (e.g., through thermal conduction or energetic particles) is probably small; however, the flare may have been partially behind the limb. Wave heating by photospheric motions requires heating rates significantly larger than those previously inferred for coronal holes, but the eruption itself could drive waves which heat the plasma. Heating by small-scale reconnection in the flux rope or by the CME current sheet is not significantly constrained. UVCS line widths suggest that turbulence must be replenished continually and dissipated on time scales shorter than the propagation time in order to be an intermediate step in CME heating.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
