اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA Calibrated Digital Sideband Separating Spectrometer for Radio Astronomy Applications
204
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Dual sideband (2SB) receivers are well suited for the spectral observation of complex astronomical signals over a wide frequency range. They are extensively used in radio astronomy, their main advantages being to avoid spectral confusion and to diminish effective system temperature by a factor two with respect to double sideband (DSB) receivers. Using available millimeter-wave analog technology, wideband 2SB receivers generally obtain sideband rejections ratios (SRR) of 10-15dB, insufficient for a number of astronomical applications. We report here the design and implementation of an FPGA-based sideband separating FFT spectrometer. A 4GHz analog front end was built to test the design and measure sideband rejection. The setup uses a 2SB front end architecture, except that the mixer outputs are directly digitized before the IF hybrid, using two 8bits ADCs sampling at 1GSPS. The IF hybrid is implemented on the FPGA together with a set of calibration vectors that, properly chosen, compensate for the analog front end amplitude and phase imbalances. The calibrated receiver exhibits a sideband rejection ratio in excess of 40dB for the entire 2GHz RF bandwidth.
قيم البحث
اقرأ أيضاً
We have developed a two-beam waveguide-type dual-polarization sideband-separating SIS receiver system in the 100-GHz band for {it z}-machine on the 45-m radio telescope at the Nobeyama Radio Observatory. The receiver is intended for astronomical use
in searching for highly redshifted spectral lines from galaxies of unknown redshift. This receiver has two beams, which have 45$^{primeprime}$ of beam separation and allow for observation with the switch in the on-on position. The receiver of each beam is composed of an ortho-mode transducer and two sideband-separating SIS mixers, which are both based on a waveguide technique, and the receiver has four intermediate frequency bands of 4.0--8.0 GHz. Over the radio frequency range of 80--116 GHz, the single-sideband receiver noise temperature is lower than about 50 K, and the image rejection ratios are greater than 10 dB in most of the same frequency range. The new receiver system has been installed in the telescope, and we successfully observed a $^{12}$CO ({it J}=3--2) emission line toward a cloverleaf quasar at {it z} = 2.56, which validates the performance of the receiver system. The SSB noise temperature of the system, including the atmosphere, is typically 150--300 K at a radio frequency of 97 GHz. We have begun blind search of high-{it J} CO toward high-{it z} submillimeter galaxies.
We describe the technological concept and the first-light results of a 1024-channel spectrometer based on field programmable gate array (FPGA) hardware. This spectrometer is the prototype for the seven beam L-band receiver to be installed at the Effe
lsberg 100-m telescope in autumn 2005. Using of-the-shelf hardware and software products, we designed and constructed an extremely flexible Fast-Fourier-Transform (FFT) spectrometer with unprecedented sensitivity and dynamic range, which can be considered prototypical for spectrometer development in future radio astronomy.
The Deep Space Network (DSN) enables NASA to communicate with its spacecraft in deep space. By virtue of its large antennas, the DSN can also be used as a powerful instrument for radio astronomy. Specifically, Deep Space Station (DSS) 43, the 70 m an
tenna at the Canberra Deep Space Communications Complex (CDSCC) has a K-band radio astronomy system covering a 10 GHz bandwidth at 17 GHz to 27 GHz. This spectral range covers a number of atomic and molecular lines, produced in a rich variety of interstellar gas conditions. Lines include hydrogen radio recombination lines (RRLs), cyclopropenylidene, water masers, and ammonia. A new high-resolution spectrometer was deployed at CDSCC in November 2019 and connected to the K-band downconverter. The spectrometer has a total bandwidth of 16 GHz. Such a large total bandwidth enables, for example, the simultaneous observations of a large number of RRLs, which can be combined together to significantly improve the sensitivity of these observations. The system has two firmware modes: 1) A 65k-pt FFT to provide 32768 spectral channels at 30.5 kHz and 2) A 16k-pt polyphase filterbank (PFB) to provide 8192 spectral channels with 122 kHz resolution. The observation process is designed to maximize autonomy, from the Principle Investigators inputs to the output data in FITS file format. We present preliminary mapping observations of hydrogen RRLs in Orion KL mapping taken using the new spectrometer.
A large-N correlator that makes use of Field Programmable Gate Arrays and Graphics Processing Units has been deployed as the digital signal processing system for the Long Wavelength Array station at Owens Valley Radio Observatory (LWA-OV), to enable
the Large Aperture Experiment to Detect the Dark Ages (LEDA). The system samples a ~100MHz baseband and processes signals from 512 antennas (256 dual polarization) over a ~58MHz instantaneous sub-band, achieving 16.8Tops/s and 0.236 Tbit/s throughput in a 9kW envelope and single rack footprint. The output data rate is 260MB/s for 9 second time averaging of cross-power and 1 second averaging of total-power data. At deployment, the LWA-OV correlator was the largest in production in terms of N and is the third largest in terms of complex multiply accumulations, after the Very Large Array and Atacama Large Millimeter Array. The correlators comparatively fast development time and low cost establish a practical foundation for the scalability of a modular, heterogeneous, computing architecture.
Advances in astronomy are intimately linked to advances in digital signal processing (DSP). This special issue is focused upon advances in DSP within radio astronomy. The trend within that community is to use off-the-shelf digital hardware where poss
ible and leverage advances in high performance computing. In particular, graphics processing units (GPUs) and field programmable gate arrays (FPGAs) are being used in place of application-specific circuits (ASICs); high-speed Ethernet and Infiniband are being used for interconnect in place of custom backplanes. Further, to lower hurdles in digital engineering, communities have designed and released general-purpose FPGA-based DSP systems, such as the CASPER ROACH board, ASTRON Uniboard and CSIRO Redback board. In this introductory article, we give a brief historical overview, a summary of recent trends, and provide an outlook on future directions.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
