اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDigital Domain Power Division Multiplexed Dual Polarization Coherent Optical OFDM Transmission
171
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Capacity is the eternal pursuit for communication systems due to the overwhelming demand of bandwidth hungry applications. As the backbone infrastructure of modern communication networks, the optical fiber transmission system undergoes a significant capacity growth over decades by exploiting available physical dimensions (time, frequency, quadrature, polarization and space) of the optical carrier for multiplexing. For each dimension, stringent orthogonality must be guaranteed for perfect separation of independent multiplexed signals. To catch up with the ever-increasing capacity requirement, it is therefore interesting and important to develop new multiplexing methodologies relaxing the orthogonal constraint thus achieving better spectral efficiency and more flexibility of frequency reuse. Inspired by the idea of non-orthogonal multiple access (NOMA) scheme, here we propose a digital domain power division multiplexed (PDM) transmission technology which is fully compatible with current dual polarization (DP) coherent optical communication system. The coherent optical orthogonal frequency division multiplexing (CO-OFDM) modulation has been employed owing to its great superiority on high spectral efficiency, flexible coding, ease of channel estimation and robustness against fiber dispersion. And a PDM-DP-CO-OFDM has been theoretically and experimentally demonstrated with 100Gb/s wavelength division multiplexing (WDM) transmission over 1440km standard single mode fibers (SSMFs). Two baseband quadrature phase shift keying (QPSK) OFDM signals are overlaid together with different power levels. After IQ modulation, polarization multiplexing and long distance fiber transmission, the PDM-DP-CO-OFDM signal has been successfully recovered in the typical polarization diversity coherent receiver by successive interference cancellation (SIC) algorithm.
قيم البحث
اقرأ أيضاً
We present a comparative study of the influence of dispersion induced phase noise for CO-OFDM systems using Tx channel multiplexing and Rx matched filter (analogue hardware based); and FFT multiplexing/IFFT demultiplexing techniques (software based).
An RF carrier pilot tone is used to mitigate the phase noise influence. From the analysis, it appears that the phase noise influence for the two OFDM implementations is very similar. The software based system provides a method for a rigorous evaluation of the phase noise variance caused by Common Phase Error (CPE) and Inter-Carrier Interference (ICI) and this, in turns, leads to a BER specification. Numerical results focus on a CO-OFDM system with 1GS/s QPSK channel modulation. Worst case BER results are evaluated and compared to the BER of a QPSK system with the same capacity as the OFDM implementation. Results are evaluated as a function of transmission distance, and for the QPSK system the influence of equalization enhanced phase noise (EEPN) is included. For both types of systems, the phase noise variance increases significantly with increasing transmission distance. An important and novel observation is that the two types of systems have very closely the same BER as a function of transmission distance for the same capacity. For the high capacity QPSK implementation, the increase in BER is due to EEPN, whereas for the OFDM approach it is due to the dispersion caused walk-off of the RF pilot tone relative to the OFDM signal channels. For a total capacity of 400 Gb/s, the transmission distance to have the BER < 10-4 is less than 277 km.
Regular perturbation is applied to space-division multiplexing (SDM) on optical fibers and motivates a correlated rotation-and-additive noise (CRAN) model. For S spatial modes, or 2S complex-alphabet channels, the model has 4S(S+1) hidden independent
real Gauss-Markov processes, of which 2S model phase noise, 2S(2S-1) model spatial mode rotation, and 4S model additive noise. Achievable information rates of multi-carrier communication are computed by using particle filters. For S=2 spatial modes with strong coupling and a 1000 km link, joint processing of the spatial modes gains 0.5 bits/s/Hz/channel in rate and 1.4 dB in power with respect to separate processing of 2S complex-alphabet channels without considering CRAN.
The fifth generation (5G) wireless standard will support several new use cases and 10 to 100 times the performance of fourth generation (4G) systems. Because of the diverse applications for 5G, flexible solutions which can address conflicting require
ments will be needed. In this paper, we propose a solution which enables the use of discrete Fourier transform spread orthogonal frequency division multiplexing (DFT-s-OFDM) and OFDM, which address different requirements, using a common reference symbol (RS) design. In this solution, the DFT-s-OFDM symbol contains RSs in the frequency domain that may be shared by a subsequent OFDM symbol. The proposed scheme is generated by puncturing the output of a DFT-spread block and replacing the punctured samples with RSs in frequency. We prove that puncturing the interleaved samples at the output of the DFT-spread operation equivalently introduces a periodic interference to the data symbols at the input of the DFT-spread operation. We show that the interference due to the puncturing can be removed with a low-complexity receiver by exploiting the zeros inserted to certain locations before the DFT-spread block at the transmitter. Simulation results support that the proposed scheme removes the error floor caused by the puncturing and achieves lower peak-to-average-power ratio than OFDM.
The Reconfigurable Intelligent Surface (RIS) constitutes one of the prominent technologies for the next 6-th Generation (6G) of wireless communications. It is envisioned to enhance signal coverage in cases where obstacles block the direct communicati
on from Base Stations (BSs), and when high carrier frequencies are used that are sensitive to attenuation losses. In the literature, the exploitation of RISs is exclusively based on traditional coherent demodulation, which necessitates the availability of Channel State Information (CSI). Given the CSI, a multi-antenna BS or a dedicated controller computes the pre/post spatial coders and the RIS configuration. The latter tasks require significant amount of time and resources, which may not be affordable when the channel is time-varying or the CSI is not accurate enough. In this paper, we consider the uplink between a single-antenna user and a multi-antenna BS and present a novel RIS-empowered Orthogonal Frequency Division Multiplexing (OFDM) communication system based on the differential phase shift keying, which is suitable for high noise and/or mobility scenarios. Considering both an idealistic and a realistic channel model, analytical expressions for the Signal-to-Interference and Noise Ratio (SINR) and the Symbol Error Probability (SEP) of the proposed non-coherent RIS-empowered system are presented. Our extensive computer simulation results verify the accuracy of the presented analysis and showcase the proposed systems performance and superiority over coherent demodulation in different mobility and spatial correlation scenarios.
We present a study of the influence of dispersion induced phase noise for CO-OFDM systems using FFT multiplexing/IFFT demultiplexing techniques (software based). The software based system provides a method for a rigorous evaluation of the phase noise
variance caused by Common Phase Error (CPE) and Inter-Carrier Interference (ICI) including - for the first time to our knowledge - in explicit form the effect of equalization enhanced phase noise (EEPN). This, in turns, leads to an analytic BER specification. Numerical results focus on a CO-OFDM system with 10-25 GS/s QPSK channel modulation. A worst case constellation configuration is identified for the phase noise influence and the resulting BER is compared to the BER of a conventional single channel QPSK system with the same capacity as the CO-OFDM implementation. Results are evaluated as a function of transmission distance. For both types of systems, the phase noise variance increases significantly with increasing transmission distance. For a total capacity of 400 (1000) Gbit/s, the transmission distance to have the BER < 10^-2 for the worst case CO-OFDM design is less than 800 and 460 km, respectively, whereas for a single channel QPSK system it is less than 1400 and 560 km.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
