اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUnsupervised Disaggregation of PhotoVoltaic Production from Composite Power Flow Measurements of Heterogeneous Prosumers
77
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We consider the problem of estimating the unobserved amount of photovoltaic (PV) generation and demand in a power distribution network starting from measurements of the aggregated power flow at the point of common coupling (PCC) and local global horizontal irradiance (GHI). The estimation principle relies on modeling the PV generation as a function of the measured GHI, enabling the identification of PV production patterns in the aggregated power flow measurements. Four estimation algorithms are proposed: the first assumes that variability in the aggregated PV generation is given by variations of PV generation, the next two use a model of the demand to improve estimation performance, and the fourth assumes that, in a certain frequency range, the aggregated power flow is dominated by PV generation dynamics. These algorithms leverage irradiance transposition models to explore several azimuth/tilt configurations and explain PV generation patterns from multiple plants with non-uniform installation characteristics. Their estimation performance is compared and validated with measurements from a real-life setup including 4 houses with rooftop PV installations and battery systems for PV self-consumption.
قيم البحث
اقرأ أيضاً
We analyzed the cross-correlation of Photovoltaic (PV) output fluctuation for the actual PV output time series data in both the Tokyo area and the whole of Japan using the principal component analysis with the random matrix theory. Based on the obtai
ned cross-correlation coefficients, the forecast error for PV output was estimated with/without considering the cross-correlations. Then operation schedule of thermal plants is calculated to integrate PV output using our unit commitment model with the estimated forecast error. The cost for grid integration of PV system was also estimated. Finally, validity of the concept of local production for local consumption of renewable energy and alternative policy implications were also discussed.
This paper studies the problem of estimation from relative measurements in a graph, in which a vector indexed over the nodes has to be reconstructed from pairwise measurements of differences between its components associated to nodes connected by an
edge. In order to model heterogeneity and uncertainty of the measurements, we assume them to be affected by additive noise distributed according to a Gaussian mixture. In this original setup, we formulate the problem of computing the Maximum-Likelihood (ML) estimates and we design two novel algorithms, based on Least Squares regression and Expectation-Maximization (EM). The first algorithm (LS- EM) is centralized and performs the estimation from relative measurements, the soft classification of the measurements, and the estimation of the noise parameters. The second algorithm (Distributed LS-EM) is distributed and performs estimation and soft classification of the measurements, but requires the knowledge of the noise parameters. We provide rigorous proofs of convergence of both algorithms and we present numerical experiments to evaluate and compare their performance with classical solutions. The experiments show the robustness of the proposed methods against different kinds of noise and, for the Distributed LS-EM, against errors in the knowledge of noise parameters.
Due to the increasing proportion of distributed photovoltaic (PV) production in the generation mix, the knowledge of the PV generation capacity has become a key factor. In this work, we propose to compute the PV plant maximum power starting from the
indirectly-estimated irradiance. Three estimators are compared in terms of i) ability to compute the PV plant maximum power, ii) bandwidth and iii) robustness against measurements noise. The approaches rely on measurements of the DC voltage, current, and cell temperature and on a model of the PV array. We show that the considered methods can accurately reconstruct the PV maximum generation even during curtailment periods, i.e. when the measured PV power is not representative of the maximum potential of the PV array. Performance evaluation is carried out by using a dedicated experimental setup on a 14.3 kWp rooftop PV installation. Results also proved that the analyzed methods can outperform pyranometer-based estimations, with a less complex sensing system. We show how the obtained PV maximum power values can be applied to train time series-based solar maximum power forecasting techniques. This is beneficial when the measured power values, commonly used as training, are not representative of the maximum PV potential.
The Jacobian matrix is the core part of power flow analysis, which is the basis for power system planning and operations. This paper estimates the Jacobian matrix in high dimensional space. Firstly, theoretical analysis and model-based calculation of
the Jacobian matrix are introduced to obtain the benchmark value. Then, the estimation algorithms based on least-squared errors and the deviation estimation based on the neural network are studied in detail, including the theories, equations, derivations, codes, advantages and disadvantages, and application scenes. The proposed algorithms are data-driven and sensitive to up-to-date topology parameters and state variables. The efforts are validate by comparing the results to benchmark values.
In this paper, we consider the problem of optimally coordinating the response of a group of distributed energy resources (DERs) in distribution systems by solving the so-called optimal power flow (OPF) problem. The OPF problem is concerned with deter
mining an optimal operating point, at which some cost function, e.g., generation cost or power losses, is minimized, and operational constraints are satisfied. To solve the OPF problem, we propose distributed algorithms that are able to operate over time-varying communication networks and have geometric convergence rate. We solve the second-order cone program (SOCP) relaxation of the OPF problem for radial distribution systems, which is formulated using the so-called DistFlow model. Theoretical results are further supported by the numerical simulations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
