اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFull-Duplex Massive MIMO Relaying Systems with Low-Resolution ADCs
215
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This paper considers a multipair amplify-and-forward massive MIMO relaying system with low-resolution ADCs at both the relay and destinations. The channel state information (CSI) at the relay is obtained via pilot training, which is then utilized to perform simple maximum-ratio combining/maximum-ratio transmission processing by the relay. Also, it is assumed that the destinations use statistical CSI to decode the transmitted signals. Exact and approximated closed-form expressions for the achievable sum rate are presented, which enable the efficient evaluation of the impact of key system parameters on the system performance. In addition, optimal relay power allocation scheme is studied, and power scaling law is characterized. It is found that, with only low-resolution ADCs at the relay, increasing the number of relay antennas is an effective method to compensate for the rate loss caused by coarse quantization. However, it becomes ineffective to handle the detrimental effect of low-resolution ADCs at the destination. Moreover, it is shown that deploying massive relay antenna arrays can still bring significant power savings, i.e., the transmit power of each source can be cut down proportional to $1/M$ to maintain a constant rate, where $M$ is the number of relay antennas.
قيم البحث
اقرأ أيضاً
This paper considers a multipair amplify-and-forward massive MIMO relaying system with one-bit ADCs and one-bit DACs at the relay. The channel state information is estimated via pilot training, and then utilized by the relay to perform simple maximum
-ratio combining/maximum-ratio transmission processing. Leveraging on the Bussgang decomposition, an exact achievable rate is derived for the system with correlated quantization noise. Based on this, a closed-form asymptotic approximation for the achievable rate is presented, thereby enabling efficient evaluation of the impact of key parameters on the system performance. Furthermore, power scaling laws are characterized to study the potential energy efficiency associated with deploying massive one-bit antenna arrays at the relay. In addition, a power allocation strategy is designed to compensate for the rate degradation caused by the coarse quantization. Our results suggest that the quality of the channel estimates depends on the specific orthogonal pilot sequences that are used, contrary to unquantized systems where any set of orthogonal pilot sequences gives the same result. Moreover, the sum rate gap between the double-quantized relay system and an ideal non-quantized system is a moderate factor of $4/pi^2$ in the low power regime.
With the help of an in-band full-duplex relay station, it is possible to simultaneously transmit and receive signals from multiple users. The performance of such system can be greatly increased when the relay station is equipped with a large number o
f antennas on both transmitter and receiver sides. In this paper, we exploit the use of massive arrays to effectively suppress the loopback interference (LI) of a decode-and-forward relay (DF) and evaluate the performance of the end-to-end (e2e) transmission. This paper assumes imperfect channel state information is available at the relay and designs a minimum mean-square error (MMSE) filter to mitigate the interference. Subsequently, we adopt zero-forcing (ZF) filters for both detection and beamforming. The performance of such system is evaluated in terms of bit error rate (BER) at both relay and destinations, and an optimal choice for the transmission power at the relay is shown. We then propose a complexity efficient optimal power allocation (OPA) algorithm that, using the channel statistics, computes the minimum power that satisfies the rate constraints of each pair. The results obtained via simulation show that when both MMSE filtering and OPA method are used, better values for the energy efficiency are attained.
We consider a full-duplex decode-and-forward system, where the wirelessly powered relay employs the time-switching protocol to receive power from the source and then transmit information to the destination. It is assumed that the relay node is equipp
ed with two sets of antennas to enable full-duplex communications. Three different interference mitigation schemes are studied, namely, 1) optimal 2) zero-forcing and 3) maximum ratio combining/maximum ratio transmission. We develop new outage probability expressions to investigate delay-constrained transmission throughput of these schemes. Our analysis show interesting performance comparisons of the considered precoding schemes for different system and link parameters.
In-band full-duplex transmission allows a relay station to theoretically double its spectral efficiency by simultaneously receiving and transmitting in the same frequency band, when compared to the traditional half-duplex or out-of-band full-duplex c
ounterpart. Consequently, the induced self-interference suffered by the relay may reach considerable power levels, which decreases the signal-to-interference-plus-noise ratio (SINR) in a decode-and-forward (DF) relay, leading to a degradation of the relay performance. This paper presents a technique to cope with the problem of self-interference in broadband multiple-input multiple-output (MIMO) relays. The proposed method uses a time-domain cancellation in a DF relay, where a replica of the interfering signal is created with the help of a recursive least squares (RLS) algorithm that estimates the interference frequency-selective channel. Its convergence mean time is shown to be negligible by simulation results, when compared to the length of a typical orthogonal-frequency division multiplexing (OFDM) sequences. Moreover, the bit-error-rate (BER) and the SINR in a OFDM transmission are evaluated, confirming that the proposed method extends significantly the range of self-interference power to which the relay is resilient to, when compared with other mitigation schemes.
Hybrid analog-digital precoding architectures and low-resolution analog-to-digital converter (ADC) receivers are two solutions to reduce hardware cost and power consumption for millimeter wave (mmWave) multiple-input multiple-output (MIMO) communicat
ion systems with large antenna arrays. In this study, we consider a mmWave MIMO-OFDM receiver with a generalized hybrid architecture in which a small number of radio-frequency (RF) chains and low-resolution ADCs are employed simultaneously. Owing to the strong nonlinearity introduced by low-resolution ADCs, the task of data detection is challenging, particularly achieving a Bayesian optimal data detector. This study aims to fill this gap. By using generalized expectation consistent signal recovery technique, we propose a computationally efficient data detection algorithm that provides a minimum mean-square error estimate on data symbols and is extended to a mixed-ADC architecture. Considering particular structure of MIMO-OFDM channel matirx, we provide a lowcomplexity realization in which only FFT operation and matrixvector multiplications are required. Furthermore, we present an analytical framework to study the theoretical performance of the detector in the large-system limit, which can precisely evaluate the performance expressions such as mean-square error and symbol error rate. Based on this optimal detector, the potential of adding a few low-resolution RF chains and high-resolution ADCs for mixed-ADC architecture is investigated. Simulation results confirm the accuracy of our theoretical analysis and can be used for system design rapidly. The results reveal that adding a few low-resolution RF chains to original unquantized systems can obtain significant gains.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
