اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSpatial Integration by a Dielectric Slab Waveguide and its Planar Graphene-based Counterpart
346
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Motivated by the recent progress in analog computing [Science 343, 160 (2014)], a new approach to perform spatial integration is presented using a dielectric slab waveguide. Our approach is indeed based on the fact that the transmission coefficient of a simple dielectric slab waveguide at its mode excitation angle matches the Greens function of first order integration. Inspired by the mentioned dielectric-based integrator, we further demonstrate its graphene-based counterpart. The latter is not only reconfigurable but also highly miniaturized in contrast to the previously reported designs [Opt. Commun. 338, 457 (2015)]. Such integrators have the potential to be used in ultrafast analog computation and signal processing.
قيم البحث
اقرأ أيضاً
Sheets of slab waveguides with sharp corners are investigated. By means of rigorous numerical experiments, we look at oblique incidence of semi-guided plane waves. Radiation losses vanish beyond a certain critical angle of incidence. One can thus rea
lize lossless propagation through 90-degree corner configurations, where the remaining guided waves are still subject to pronounced reflection and polarization conversion. A system of two corners can be viewed as a structure akin to a Fabry-Perot-interferometer. By adjusting the distance between the two partial reflectors, here the 90-degree corners, one identifies step-like configurations that transmit the semi-guided plane waves without radiation losses, and virtually without reflections. Simulations of semi-guided beams with in-plane wide Gaussian profiles show that the effect survives in a true 3-D framework.
It has been proved that surface plasmon polariton (SPP) can well conserve and transmit the quantum nature of entangled photons. Therefore, further utilization and manipulation of such quantum nature of SPP in a plasmonic chip will be the next task fo
r scientists in this field. In quantum logic circuits, the controlled-NOT (CNOT) gate is the key building block. Here, we implement the first plasmonic quantum CNOT gate with several-micrometer footprint by utilizing a single polarization-dependent beam-splitter (PDBS) fabricated on the dielectric-loaded SPP waveguide (DLSPPW). The quantum logic function of the CNOT gate is characterized by the truth table with an average fidelity of. Its entangling ability to transform a separable state into an entangled state is demonstrated with the visibilities of and for non-orthogonal bases. The DLSPPW based CNOT gate is considered to have good integratability and scalability, which will pave a new way for quantum information science.
In this article, a 2D plasmonic waveguide loaded with all dielectric anisotropic metamaterial, consisting of alternative layers of Si-SiO2, has been theoretically proposed and numerically analyzed. Main characteristics of waveguide i.e. propagation c
onstant, propagation length and normalized mode area have been calculated for different values of ridge width and height at telecommunication wavelength. The respective 1D structure of the waveguide has been analytically solved for the anisotropic ridge as a single uniaxial medium with dielectric tensor defined by Effective Medium Theory (EMT). The 2D structure has been analyzed numerically through FEM simulation using Mode analysis module in Comsol Multiphysics. Both the EMT and real multilayer structure have been considered in numerical simulations. Such structure with all dielectric metamaterial provides an extra degree of freedom namely fill factor, fraction of Si layer in a Si-SiO2 unit cell, to tune the propagation characteristics compared to the conventional DLSSP waveguide. A wide range of variations in all the characteristics have been observed for different fill factor values. Besides, the effect of the first interface layer has also been considered. Though all dielectric metamaterial has already been utilized in photonic waveguide as cladding, the implementation in plasmonic waveguide has not been investigated yet to our best knowledge. The proposed device might be a potential in deep sub-wavelength optics, PIC and optoelectronics.
The problem of diffraction of a waveguide mode by a thin Neumann screen is considered. The incident mode is assumed to have frequency close to the cut-off. The problem is reduced to a propagation problem on a branched surface and then is considered i
n the parabolic approximation. Using the embedding formula approach, the reflection and transmission coefficients are expressed through the directivities of the edge Greens function of the propagation problem. The asymptotics of the directivities of the edge Greens functions are constructed for the case of small gaps between the screen and the walls of the waveguide. As the result, the reflection and transmission coefficients are found. The validity of known asymptotics of these coefficients is studied.
We analyze spectrum of waveguide modes of an arbitrary uniaxial anisotropic metamaterial slab with non-local electromagnetic response whose permittivity tensor could be described within Drude approximation. Spatial dispersion was introduced within th
e hydrodynamical model. Both anisotropy and spatial dispersion were considered as perturbations. This helps to distinguish their effect on the spectrum of the slab and to analyze lifting of the degeneracy of eigenmodes at plasma frequency in detail. Spatial dispersion is shown to result in break of the singularity in the den- sity of optical states in the hyperbolic regime and in suppression of negative dispersion induced by anisotropy. Mutual effect of spatial dispersion and anisotropy can bring light to a complete stop at certain frequencies.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
