ترغب بنشر مسار تعليمي؟ اضغط هنا

Transport and field emission properties of buckypapers obtained from aligned carbon nanotubes

159   0   0.0 ( 0 )
 نشر من قبل Filippo Giubileo Dr
 تاريخ النشر 2017
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We produce 120 um thick buckypapers from aligned carbon nanotubes. Transport characteristics evidence ohmic behavior in a wide temperature range, non linearity appearing in the current-voltage curves only close to 4.2 K. The temperature dependence of the conductance shows that transport is mostly due to thermal fluctuation induced tunneling, although to explain the whole temperature range from 4.2 K to 430 K a further linear contribution is necessary. The field emission properties are measured by means of a nanocontrolled metallic tip acting as collector electrode to access local information about buckypaper properties from areas as small as 1 um2. Emitted current up to 10-5A and turn-on field of about 140V/um are recorded. Long operation, stability and robustness of emitters have been probed by field emission intensity monitoring for more than 12 hours at pressure of 10-6 mbar. Finally, no tuning of the emitted current was observed for in plane applied currents in the buckypaper.



قيم البحث

اقرأ أيضاً

76 - S. Krompiewski 2004
Carbon nanotubes (CNT) belong to the most promising new materials which can in the near future revolutionize the conventional electronics. When sandwiched between ferromagnetic electrodes, the CNT behaves like a spacer in conventional spin-valves, le ading quite often to a considerable giant magneto-resistance effect (GMR). This paper is devoted to reviewing some topics related to electron correlations in CNT. The main attention however is directed to the following effects essential for electron transport through nanotubes: (i) nanotube/electrode coupling and (ii) inter-tube interactions.It is shown that these effects may account for some recent experimental reports on GMR, including those on negative (inverse) GMR.
Using large-scale DFT calculations, we have investigated the structural and electronic properties of both armchair and zigzag graphdiyne nanotubes as a function of size. To provide insight in these properties, we present new detailed calculations of the structural relaxation energy, effective electron/hole mass, and size-scaling of the bandgap as a function of size and chirality using accurate screened-exchange DFT calculations. These calculations provide a systematic evaluation of the structural and electronic properties of the largest graphdiyne nanotubes to date - up to 1,296 atoms and 23,328 basis functions. Our calculations find that zigzag graphdiyne nanotubes (GDNTs) are structurally more stable compared to armchair GDNTs of the same size. Furthermore, these large-scale calculations allow us to present simple analytical formulae to guide future experimental efforts for estimating the fundamental bandgaps of these unique nanotubes as a function of chirality and diameter. While the bandgaps for both the armchair and zigzag GDNTs can be tuned as a function of size, the conductivity in each of these two different chiralities is markedly different. Zigzag GDNTs have wider valence and conduction bands and are expected to have a higher electron- and hole-mobility than their armchair counterparts.
We have investigated excitons in highly-aligned single-walled carbon nanotubes (SWCNTs) through optical spectroscopy at low temperature (1.5 K) and high magnetic fields ($textbf{textit{B}}$) up to 55 T. SWCNT/polyacrylic acid films were stretched, gi ving SWCNTs that are highly aligned along the direction of stretch ($hat{n}$). Utilizing two well-defined measurement geometries, $hat{n}paralleltextbf{textit{B}}$ and $hat{n}perptextbf{textit{B}}$, we provide unambiguous evidence that the photoluminescence energy and intensity are only sensitive to the $textbf{textit{B}}$-component parallel to the tube axis. A theoretical model of one-dimensional magneto-excitons, based on exchange-split `bright and `dark exciton bands with Aharonov-Bohm-phase-dependent energies, masses, and oscillator strengths, successfully reproduces our observations and allows determination of the splitting between the two bands as $sim4.8$ meV for (6,5) SWCNTs.
A method is introduced to isolate and measure the electrical transport properties of individual single-walled carbon nanotubes (SWNTs) aligned on an ST-cut quartz, from room temperature down to 2 K. The diameter and chirality of the measured SWNTs ar e accurately defined from Raman spectroscopy and atomic force microscopy (AFM). A significant up-shift in the G-band of the resonance Raman spectra of the SWNTs is observed, which increases with increasing SWNTs diameter, and indicates a strong interaction with the quartz substrate. A semiconducting SWNT, with diameter 0.84 nm, shows Tomonaga-Luttinger liquid and Coulomb blockade behaviors at low temperatures. Another semiconducting SWNT, with a thinner diameter of 0.68 nm, exhibits a transition from the semiconducting state to an insulating state at low temperatures. These results elucidate some of the electrical properties of SWNTs in this unique configuration and help pave the way towards prospective device applications.
We study theoretically the impact of Zener tunneling on the charge-transport properties of quasi-metallic (Qm) carbon nanotubes (characterized by forbidden band gaps of few tens of meV). We also analyze the interplay between Zener tunneling and elast ic scattering on defects. To this purpose we use a model based on the master equation for the density matrix, that takes into account the inter-band Zener transitions induced by the electric field (a quantum mechanical effect), the electron-defect scattering and the electron-phonon scattering. In presence of Zener tunnelling the Qm tubes support an electrical current even when the Fermi energy lies in the forbidden band gap. In absence of elastic scattering (in high quality samples), the small size of the band gap of Qm tubes enables Zener tunnelling for realistic values of the the electric field (above $sim$ 1 V/mu m). The presence of a strong elastic scattering (in low quality samples) further decreases the values of the field required to observe Zener tunnelling. Indeed, for elastic-scattering lengths of the order of 50 nm, Zener tunnelling affects the current/voltage characteristic already in the linear regime. In other words, in quasi-metallic tubes, Zener tunneling is made more visible by defects.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا