اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدConcurrency of anisotropy and spatial dispersion in low refractive index dielectric composites
133
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The article demonstrates uncommon manifestation of spatial dispersion in low refractive index contrast 3D periodic dielectric composites with periods of about one tenth of the wavelength. First principles simulations by the well established plane wave method reveal that spatial dispersion leads to appearance of additional optical axes and can compensate anisotropy in certain directions.
قيم البحث
اقرأ أيضاً
In this work, a refractive index (RI) sensor with an effective integration of colorimetric detection and optical sensing capabilities has been developed. Colorimetric detection relies on the sensitivity of the structural color of photonic crystal (PC
) substrates to the changes in background RI, while the optical sensing is performed by measuring the magnification abilities of the dielectric microspheres, which depends on the position of the photonic nanojet. Based on this concept, we have successfully assembled 35 {mu}m-diameter barium titanate glass microspheres, 4.9 {mu}m-diameter polystyrene and silica microsphere monolayers on 1D or 2D PC substrates to perform RI sensing in various liquids. In addition, the developed RI sensor is highly compatible with commercial optical microscopes and applicable for RI sensing in areas as small as tens of square microns.
We analyze spectrum of waveguide modes of an arbitrary uniaxial anisotropic metamaterial slab with non-local electromagnetic response whose permittivity tensor could be described within Drude approximation. Spatial dispersion was introduced within th
e hydrodynamical model. Both anisotropy and spatial dispersion were considered as perturbations. This helps to distinguish their effect on the spectrum of the slab and to analyze lifting of the degeneracy of eigenmodes at plasma frequency in detail. Spatial dispersion is shown to result in break of the singularity in the den- sity of optical states in the hyperbolic regime and in suppression of negative dispersion induced by anisotropy. Mutual effect of spatial dispersion and anisotropy can bring light to a complete stop at certain frequencies.
The use of relatively simple structures to achieve high performance refractive index sensors has always been urgently needed. In this work, we propose a lithography-free sensing platform based on metal-dielectric cavity, the sensitivity of our device
can reach 1456700 nm/RIU for solution and 1596700 nm/RIU for solid material, and the FOM can be up to 1234500 /RIU for solution and 1900800 /RIU for solid material, which both are much higher than most sensing methods. This sensor has excellent sensing performance in both TE and TM light, and suitable for integrated microfluidic channels. Our scheme uses a multi-layers structure with a 10 nm gold film sandwiched between prism and analyte, and shows a great potential for low-cost sensing with high performance.
In this research, we report the experimental evidence of the directional Fano resonances at the scattering of a plane, linearly polarized electromagnetic wave by a homogeneous dielectric sphere with high refractive index and low losses. We observe a
typical asymmetric Fano profile for the intensity scattered in, practically, any given direction, while the overall extinction cross section remains Lorentzian. The phenomenon is originated in the interference of the selectively excited electric dipolar and quadrupolar modes. The selectivity of the excitation is achieved by the proper choice of the frequency of the incident wave. Thanks to the scaling invariance of the Maxwell equations, in these experiments we mimic the scattering of the visible and near IR radiation by a nanoparticle made of common superconductor materials (Si, Ge, GaAs, GaP) by the equivalent scattering of a spherical particle of 18 mm in diameter in the microwave range. The theory developed to explain the experiments extends the conventional Fano approach to the case when both interfering partitions are resonant. The perfect agreement between the experiment and the theory is demonstrated.
Sub-wavelength diffractive optics, commonly known as metasurfaces, have recently garnered significant attention for their ability to create ultra-thin flat lenses with extremely short focal lengths. Several materials with different refractive indices
have been used to create metasurface lenses (metalenses). In this paper, we analyze the role of material refractive indices on the performance of these metalenses. We employ both forward and inverse design methodologies to perform our analysis. We found that, while high refractive index materials allow for extreme reduction of the focal length, for moderate focal lengths and numerical aperture (<0.6), there is no appreciable difference in focal spot-size and focusing efficiency for metalenses made of different materials with refractive indices ranging between n= 1.25 to n=3.5.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
