اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAlgebraic Solution for Beamforming in Two-Way Relay Systems with Analog Network Coding
56
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We reduce the problem of optimal beamforming for two-way relay (TWR) systems with perfect channel state infomation (CSI) that use analog network coding (ANC) to a pair of algebraic equations in two variables that can be solved inexpensively using numerical methods. The solution has greatly reduced complexity compared to previous exact solutions via semidefinite programming (SDP). Together with the linearized robust solution described in (Aziz and Thron, 2014), it provides a high-performance, low-complexity robust beamforming solution for 2-way relays.
قيم البحث
اقرأ أيضاً
In this paper, we adopt the relay selection (RS) protocol proposed by Bletsas, Khisti, Reed and Lippman (2006) with Enhanced Dynamic Decode-and-Forward (EDDF) and network coding (NC) system in a two-hop two-way multi-relay network. All nodes are sing
le-input single-output (SISO) and half-duplex, i.e., they cannot transmit and receive data simultaneously. The outage probability is analyzed and we show comparisons of outage probability with various scenarios under Rayleigh fading channel. Our results show that the relay selection with EDDF and network coding (RS-EDDF&NC) scheme has the best performance in the sense of outage probability upon the considered decode-and-forward (DF) relaying if there exist sufficiently relays. In addition, the performance loss is large if we select a relay at random. This shows the importance of relay selection strategies.
In this paper, we consider a reconfigurable intelligent surface (RIS)-assisted two-way relay network, in which two users exchange information through the base station (BS) with the help of an RIS. By jointly designing the phase shifts at the RIS and
beamforming matrix at the BS, our objective is to maximize the minimum signal-to-noise ratio (SNR) of the two users, under the transmit power constraint at the BS. We first consider the single-antenna BS case, and propose two algorithms to design the RIS phase shifts and the BS power amplification parameter, namely the SNR-upper-bound-maximization (SUM) method, and genetic-SNR-maximization (GSM) method. When there are multiple antennas at the BS, the optimization problem can be approximately addressed by successively solving two decoupled subproblems, one to optimize the RIS phase shifts, the other to optimize the BS beamforming matrix. The first subproblem can be solved by using SUM or GSM method, while the second subproblem can be solved by using optimized beamforming or maximum-ratio-beamforming method. The proposed algorithms have been verified through numerical results with computational complexity analysis.
The exponential growth in data generation and large-scale data analysis creates an unprecedented need for inexpensive, low-latency, and high-density information storage. This need has motivated significant research into multi-level memory systems tha
t can store multiple bits of information per device. Although both the memory state of these devices and much of the data they store are intrinsically analog-valued, both are quantized for use with digital systems and discrete error correcting codes. Using phase change memory as a prototypical multi-level storage technology, we herein demonstrate that analog-valued devices can achieve higher capacities when paired with analog codes. Further, we find that storing analog signals directly through joint-coding can achieve low distortion with reduced coding complexity. By jointly optimizing for signal statistics, device statistics, and a distortion metric, finite-length analog encodings can perform comparable to digital systems with asymptotically infinite large encodings. These results show that end-to-end analog memory systems have not only the potential to reach higher storage capacities than discrete systems, but also to significantly lower coding complexity, leading to faster and more energy efficient storage.
Reconfigurable intelligent surfaces (RISs) are able to provide passive beamforming gain via low-cost reflecting elements and hence improve wireless link quality. This work considers two-way passive beamforming design in RIS-aided frequency division d
uplexing (FDD) systems where the RIS reflection coefficients are the same for downlink and uplink and should be optimized for both directions simultaneously. We formulate a joint optimization of the transmit/receive beamformers at the base station (BS) and the RIS reflection coefficients. The objective is to maximize the weighted sum of the downlink and uplink rates, where the weighting parameter is adjustable to obtain different achievable downlink-uplink rate pairs. We develop an efficient manifold optimization algorithm to obtain a stationary solution. For comparison, we also introduce two heuristic designs based on one-way optimization, namely, time-sharing and phase-averaging. Simulation results show that the proposed manifold-based two-way optimization design significantly enlarges the achievable downlink-uplink rate region compared with the two heuristic designs. It is also shown that phase-averaging is superior to time-sharing when the number of RIS elements is large.
This paper investigates the information freshness of two-way relay networks (TWRN) operated with physical-layer network coding (PNC). Information freshness is quantified by age of information (AoI), defined as the time elapsed since the generation ti
me of the latest received information update. PNC reduces communication latency of TWRNs by turning superimposed electromagnetic waves into network-coded messages so that end users can send update packets to each other via the relay more frequently. Although sending update packets more frequently is potential to reduce AoI, how to deal with packet corruption has not been well investigated. Specifically, if old packets are corrupted in any hop of a TWRN, one needs to decide the old packets to be dropped or to be retransmitted, e.g., new packets have recent information, but may require more time to be delivered. We study the average AoI with and without ARQ in PNC-enabled TWRNs. We first consider a non-ARQ scheme where old packets are always dropped when corrupted, referred to once-lost-then-drop (OLTD), and a classical ARQ scheme with no packet lost, referred to as reliable packet transmission (RPT). Interestingly, our analysis shows that neither the non-ARQ scheme nor the pure ARQ scheme achieves good average AoI. We then put forth an uplink-lost-then-drop (ULTD) protocol that combines packet drop and ARQ. Experiments on software-defined radio indicate that ULTD significantly outperforms OLTD and RPT in terms of average AoI. Although this paper focuses on TWRNs, we believe the insight of ULTD applies generally to other two-hop networks. Our insight is that to achieve high information freshness, when packets are corrupted in the first hop, new packets should be generated and sent (i.e., old packets are discarded); when packets are corrupted in the second hop, old packets should be retransmitted until successful reception.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
