ﻻ يوجد ملخص باللغة العربية
The upper critical field Hc2 anisotropy of Ca10(PtnAs8)(Fe2-xPtxAs2)5 (n = 3, 4) single crystals with long FeAs interlayer distance (d) was studied by angular dependent resistivity measurements. A scaling of the angular dependent resistivity was realized for both single crystals using the anisotropic Ginzburg-Landau (AGL) approach with an appropriate anisotropy parameter {gamma}. The AGL scaling parameter {gamma} increases with decreasing temperature and reaches a value of about 10 at 0.8Tc for both single crystals. These values are much larger than those of other iron-based superconductors (FeSCs). Remarkably, the values of {gamma}2 show an almost linear increase with the FeAs/FeSe interlayer distance d for FeSCs. Compared to cuprates, FeSCs are less anisotropic, indicating that two dimensionality of the superconductivity is intrinsically weak.
Ever since the discovery of high-Tc superconductivity in layered cuprates, the roles that individual layers play have been debated, due to difficulty in layer-by-layer characterization. While there is similar challenge in many Fe-based layered superc
We report a structural transition found in Ca10(Ir4As8)(Fe2-xIrxAs2)5, which exhibits superconductivity at 16 K, with a layer of divalent iridium coordinated by arsenic in between Fe2As2 layers. The c-axis parameter is doubled below a structural tran
Single crystals of SrFe2-xPtxAs2 (0 < x < 0.36) were grown using the self flux solution method and characterized using x-ray crystallography, electrical transport, magnetic susceptibility, and specific heat measurements. The magnetic/structural trans
We report a structural transition found in Ca10(Ir4As8)(Fe2-xIrxAs2)5, which exhibits superconductivity at 16 K. The c-axis parameter is doubled below a structural transition temperature of approximately 100 K, while the tetragonal symmetry with spac
The newly discovered iron-based superconductors have stimulated enormous interests in the field of superconductivity. Since the new superconductor is a layered system, the anisotropy is a parameter with the first priority to know. Meanwhile any relev