اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSpecific Heat Anomalies in Solids Described by a Multilevel Model
327
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Specific heat measurements constitute one of the most powerful experimental methods to probe fundamental excitations in solids. After the proposition of Einsteins model, more than one century ago (Annalen der Physik textbf{22}, 180 (1907)), several theoretical models have been proposed to describe experimental results. Here we report on a detailed analysis of the two-peak specific heat anomalies observed in several materials. Employing a simple multilevel model, varying the spacing between the energy levels $Delta_i$ = $(E_i$ $-$ $E_{0})$ and the degeneracy of each energy level $g_i$, we derive the required conditions for the appearance of such anomalies. Our findings indicate that a ratio of $Delta_2$/$Delta_1$ $thickapprox$ 10 between the energy levels and a high degeneracy of one of the energy levels define the two-peaks regime in the specific heat. Our approach accurately matches recent experimental results. Furthermore, using a mean-field approach we calculate the specific heat of a degenerate Schottky-like system undergoing a ferromagnetic (FM) phase transition. Our results reveal that as the degeneracy is increased the Schottky maximum in the specific heat becomes narrow while the peak associated with the FM transition remains unaffected.
قيم البحث
اقرأ أيضاً
Using ferromagnetic-resonance spectroscopy (FMR), we investigate the anisotropic properties of epitaxial 3 nmPt/2 nmAg/10 nmFe/10 nmAg/GaAs(001) films in fully saturated meta-stable states at temperatures ranging from 70 K to 280 K. By comparison to
spin-wave theory calculations, we identify the role of thermal fluctuation of magnons in overcoming the energy barrier associated with these meta-stable states. We show that the energy associated with the size of the barrier that bounds the meta-stable regime is proportional to the heat stored in the magnonic bath. Our findings offer the possibility to measure the magnonic contribution to the heat capacity by FMR, independent of other contributions at temperatures ranging from 0 K to ambient temperature and above. The only requirement being that the selected sample exhibits magnetic anisotropy, here, magnetocrystalline anisotropy.
Specific heat measurements were used to study the magnetic phase transition in Ga1-xMnxAs. Two different types of Ga1-xMnxAs samples have been investigated. The sample with a Mn concentration of 1.6% shows insulating behavior, and the sample with a M
n concentration of 2.6% is metallic. The temperature dependence of the specific heat for both samples reveals a pronounced lambda-shaped peak near the Curie temperature, which indicates a second-order phase transition in these samples. The critical behavior of the specific heat for Ga1-xMnxAs samples is consistent with the mean-field behavior with Gaussian fluctuations of the magnetization in the close vicinity of TC.
A novel macroscopically degenerate state called kagome ice, which was recently found in a spin ice compound Dy2Ti2O7 in a magnetic field applied along the [111] direction of the cubic unit cell, is studied by specific heat measurements. The residual
entropy of the kagome ice is estimated to be 0.65 J/K mol Dy, which is nearly 40 % of that for the tetrahedral spin ice obtained in a zero field (1.68 J/K mol Dy) and is in good agreement with a theoretical prediction. It is also reported that the kagom ice state, which is stabilized at a range of magnetic field of 0.3 ~ 0.6 T, is a gas phase and condenses into a liquid phase with nearly zero entropy at a critical field of 1 T.
We measure the local yield stress, at the scale of small atomic regions, in a deeply quenched two-dimensional glass model undergoing shear banding in response to athermal quasistatic (AQS) deformation. We find that the occurrence of essentially a sin
gle plastic event suffices to bring the local yield stress distribution to a well-defined value for all strain orientations, thus essentially erasing the memory of the initial structure. It follows that in a well-relaxed sample, plastic events cause the abrupt (nucleation-like) emergence of a local softness contrast and thus precipitate the formation of a band, which, in its early stages, is measurably softer than the steady-state flow. Moreover, this postevent yield stress ensemble presents a mean value comparable to that of the inherent states of a supercooled liquid around the mode-coupling temperature $T_{rm MCT}$. This, we argue, explains that the transition between brittle and ductile yielding in amorphous materials occurs around a comparable parent temperature. Our data also permit to capture quantitatively the contributions of pressure and density changes and demonstrate unambiguously that they are negligible compared with the changes of softness caused by structural rejuvenation.
We extend recent textit{ab initio} calculations of the electronic band structure and the phonon dispersion relations of rhombohedral GeTe to calculations of the density of phonon states and the temperature dependent specific heat. The results are com
pared with measurements of the specific heat. It is discovered that the specific heat depends on hole concentration, not only in the very low temperature region (Sommerfeld term) but also at the maximum of $C_p/T^3$ (around 16 K). To explain this phenomenon, we have performed textit{ab initio} lattice dynamical calculations for GeTe rendered metallic through the presence of a heavy hole concentration ($p$ $sim$ 2$times$ 10$^{21}$ cm$^{-3}$). They account for the increase observed in the maximum of $C_p/T^3$.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
