ترغب بنشر مسار تعليمي؟ اضغط هنا

Band edge noise spectroscopy of a magnetic tunnel junction

111   0   0.0 ( 0 )
 نشر من قبل Juan Pedro Cascales Mr
 تاريخ النشر 2015
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We propose a conceptually new way to gather information on the electron bands of buried metal(semiconductor)/insulator interfaces. The bias dependence of low frequency noise in Fe$_{1-x}$V$_{x}$/MgO/Fe (0 $<$ x $<$ 0.25) tunnel junctions show clear anomalies at specific applied voltages, reflecting electron tunneling to the band edges of the magnetic electrodes. The change in magnitude of these noise anomalies with the magnetic state allows evaluating the degree of spin mixing between the spin polarized bands at the ferromagnet/insulator interface. Our results are in qualitative agreement with numerical calculations.



قيم البحث

اقرأ أيضاً

137 - J. Gabelli , B. Reulet 2007
We report the first measurement of the emph{dynamical response} of shot noise (measured at frequency $omega$) of a tunnel junction to an ac excitation at frequency $omega_0$. The experiment is performed in the quantum regime, $hbaromegasimhbaromega_0 gg k_BT$ at very low temperature T=35mK and high frequency $omega_0/2pi=6.2$ GHz. We observe that the noise responds in phase with the excitation, but not adiabatically. The results are in very good agreement with a prediction based on a new current-current correlator.
Atomically thin chromium triiodide (CrI3) has recently been identified as a layered antiferromagnetic insulator, in which adjacent ferromagnetic monolayers are antiferromagnetically coupled. This unusual magnetic structure naturally comprises a serie s of anti-aligned spin filters which can be utilized to make spin-filter magnetic tunnel junctions with very large tunneling magnetoresistance (TMR). Here we report voltage control of TMR formed by four-layer CrI3 sandwiched by monolayer graphene contacts in a dual-gated structure. By varying the gate voltages at fixed magnetic field, the device can be switched reversibly between bistable magnetic states with the same net magnetization but drastically different resistance (by a factor of ten or more). In addition, without switching the state, the TMR can be continuously modulated between 17,000% and 57,000%, due to the combination of spin-dependent tunnel barrier with changing carrier distributions in the graphene contacts. Our work demonstrates new kinds of magnetically moderated transistor action and opens up possibilities for voltage-controlled van der Waals spintronic devices.
We measure the current vs voltage (I-V) characteristics of a diodelike tunnel junction consisting of a sharp metallic tip placed at a variable distance d from a planar collector and emitting electrons via electric-field assisted emission. All curves collapse onto one single graph when I is plotted as a function of the single scaling variable Vd^{-lambda}, d being varied from a few mm to a few nm, i.e., by about six orders of magnitude. We provide an argument that finds the exponent {lambda} within the singular behavior inherent to the electrostatics of a sharp tip. A simulation of the tunneling barrier for a realistic tip reproduces both the scaling behavior and the small but significant deviations from scaling observed experimentally.
The non-symmetrized current noise is crucial for the analysis of light emission in nanojunctions. The latter represent non-classical photon emitters whose description requires a full quantum approach. It was found experimentally that light emission c an occur with a photon energy exceeding the applied dc voltage, which intuitively should be forbidden due to the Pauli principle. This overbias light emission cannot be described by the single-electron physics, but can be explained by two-electron or even three-electron processes, correlated by a local resonant mode in analogy to the well-known dynamical Coulomb blockade (DCB). Here, we obtain the non-symmetrized noise for junctions driven by an arbitrarily shaped periodic voltage. We find that when the junction is driven, the overbias light emission exhibits intriguingly different features compared to the dc case. In addition to kinks at multiples of the bias voltage, side kinks appear at integer multiples of the ac driving frequency. Our work generalizes the DCB theory of light emission to driven tunnel junctions and opens the avenue for engineered quantum light sources, which can be tuned purely by applied voltages.
We propose a low-temperature thermal rectifier consisting of a chain of three tunnel-coupled normal metal electrodes. We show that a large heat rectification is achievable if the thermal symmetry of the structure is broken and the central island can release energy to the phonon bath. The performance of the device is theoretically analyzed and, under the appropriate conditions, temperature differences up to $sim$ 200 mK between the forward and reverse thermal bias configurations are obtained below 1 K, corresponding to a rectification ratio $mathcal{R} sim$ 2000. The simplicity intrinsic to its design joined with the insensitivity to magnetic fields make our device potentially attractive as a fundamental building block in solid-state thermal nanocircuits and in general-purpose cryogenic electronic applications requiring energy management.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا