اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectrical detection of the spin polarization due to charge flow in the surface state of the topological insulator Bi_1.5 Sb_0.5 Te_1.7 Se_1.3
258
0
0.0
(
0
)
تأليف
Yuichiro Ando
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We detected the spin polarization due to charge flow in the spin non-degenerate surface state of a three dimensional topological insulator by means of an all-electrical method. The charge current in the bulk-insulating topological insulator Bi1.5Sb0.5Te1.7Se1.3 (BSTS) was injected/extracted through a ferromagnetic electrode made of Ni80Fe20, and an unusual current-direction-dependent magnetoresistance gives evidence for the appearance of spin polarization which leads to a spin-dependent resistance at the BSTS/Ni80Fe20 interface. In contrast, our control experiment on Bi2Se3 gave null result. These observations demonstrate the importance of the Fermi-level control for the electrical detection of the spin polarization in topological insulators.
قيم البحث
اقرأ أيضاً
The Kondo insulator compound SmB6 has emerged as a strong candidate for the realization of a topologically nontrivial state in a strongly correlated system, a topological Kondo insulator, which can be a novel platform for investigating the interplay
between nontrivial topology and emergent correlation driven phenomena in solid state systems. Electronic transport measurements on this material, however, so far showed only the robust surface dominated charge conduction at low temperatures, lacking evidence of its connection to the topological nature by showing, for example, spin polarization due to spin momentum locking. Here, we find evidence for surface state spin polarization by electrical detection of a current induced spin chemical potential difference on the surface of a SmB6 single crystal. We clearly observe a surface dominated spin voltage, which is proportional to the projection of the spin polarization onto the contact magnetization, is determined by the direction and magnitude of the charge current and is strongly temperature dependent due to the crossover from surface to bulk conduction. We estimate the lower bound of the surface state net spin polarization as 15 percent based on the quantum transport model providing direct evidence that SmB6 supports metallic spin helical surface states.
Several recent experiments on three-dimensional topological insulators claim to observe a large charge current-induced non-equilibrium ensemble spin polarization of electrons in the helical surface state. We present a comprehensive criticism of such
claims, using both theory and experiment: First, we clarify the interpretation of quantities extracted from these measurements by deriving standard expressions from a Boltzmann transport equation approach in the relaxation-time approximation at zero and finite temperature to emphasize our assertion that, despite high in-plane spin projection, obtainable current-induced ensemble spin polarization is minuscule. Second, we use a simple experiment to demonstrate that magnetic field-dependent open-circuit voltage hysteresis (identical to those attributed to current-induced spin polarization in topological insulator surface states) can be generated in analogous devices where current is driven through thin films of a topologically-trivial metal. This result *ipso facto* discredits the naive interpretation of previous experiments with TIs, which were used to claim observation of helicity, i.e. spin-momentum locking in the topologically-protected surface state.
We study the manipulation of the photoelectron spin-polarization in Bi$_2$Se$_3$ by spin- and angle-resolved photoemission spectroscopy. General rules are established that enable controlling the spin-polarization of photoemitted electrons via light p
olarization, sample orientation, and photon energy. We demonstrate the $pm$100% reversal of a single component of the measured spin-polarization vector upon the rotation of light polarization, as well as a full three-dimensional manipulation by varying experimental configuration and photon energy. While a material-specific density-functional theory analysis is needed for the quantitative description, a minimal two-atomic-layer model qualitatively accounts for the spin response based on the interplay of optical selection rules, photoelectron interference, and topological surface-state complex structure. It follows that photoelectron spin-polarization control is generically achievable in systems with a layer-dependent, entangled spin-orbital texture.
A combined experimental and theoretical study of doping individual Fe atoms into Bi2Se3 is presented. It is shown through a scanning tunneling microscopy study that single Fe atoms initially located at hollow sites on top of the surface (adatoms) can
be incorporated into subsurface layers by thermally-activated diffusion. Angle-resolved photoemission spectroscopy in combination with ab-initio calculations suggest that the doping behavior changes from electron donation for the Fe adatom to neutral or electron acceptance for Fe incorporated into substitutional Bi sites. According to first principles calculations within density functional theory, these Fe substitutional impurities retain a large magnetic moment thus presenting an alternative scheme for magnetically doping the topological surface state. For both types of Fe doping, we see no indication of a gap at the Dirac point.
The spin-momentum locking at the Dirac surface state of a topological insulator (TI) offers a distinct possibility of a highly efficient charge-to-spin current (C-S) conversion compared with spin Hall effects in conventional paramagnetic metals. For
the development of TI-based spin current devices, it is essential to evaluate its conversion efficiency quantitatively as a function of the Fermi level EF position. Here we exemplify a coefficient of qICS to characterize the interface C-S conversion effect by using spin torque ferromagnetic resonance (ST-FMR) for (Bi1-xSbx)2Te3 thin films whose EF is tuned across the band gap. In bulk insulating conditions, interface C-S conversion effect via Dirac surface state is evaluated as nearly constant large values of qICS, reflecting that the qICS is inversely proportional to the Fermi velocity vF that is almost constant. However, when EF traverses through the Dirac point, the qICS is remarkably suppressed possibly due to the degeneracy of surface spins or instability of helical spin structure. These results demonstrate that the fine tuning of the EF in TI based heterostructures is critical to maximizing the efficiency using the spin-momentum locking mechanism.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
