اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFabrication and Study of Large Area QHE Devices Based on Epitaxial Graphene
131
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Quantum Hall effect (QHE) devices based on epitaxial graphene films grown on SiC were fabricated and studied for development of the QHE resistance standard. The graphene-metal contacting area in the Hall devices has been improved and fabricated using a double metalization process. The tested devices had an initial carrier concentration of (0.6 - 10)*10^11 1/cm^2 and showed half-integer quantum Hall effect at a relatively low (3 T) magnetic field. Application of the photochemical gating method and annealing of the sample provides a convenient way for tuning the carrier density to the optimum value. Precision measurements of the quantum Hall resistance (QHR) in graphene and GaAs devices at moderate magnetic field strengths (<7 T) showed a relative agreement within 6*10^-9.
قيم البحث
اقرأ أيضاً
Series connection of four quantum Hall effect (QHE) devices based on epitaxial graphene films was studied for realization of a quantum resistance standard with an up-scaled value. The tested devices showed quantum Hall plateaux RH,2 at filling factor
i = 2 starting from relatively low magnetic field (between 4 T and 5 T) when temperature was 1.5 K. Precision measurements of quantized Hall resistance of four QHE devices connected by triple series connections and external bonding wires were done at B = 7 T and T = 1.5 K using a commercial precision resistance bridge with 50 microA current through the QHE device. The results showed that the deviation of the quantized Hall resistance of the series connection of four graphene-based QHE devices from the expected value of 4*RH,2 = 2h/e^2 was smaller than the relative standard uncertainty of the measurement (< 1*10^-7) limited by the used resistance bridge.
Monolayer epitaxial graphene (EG) grown on hexagonal Si-terminated SiC substrates is intrinsically electron-doped (carrier density is about 10^13 cm^(-2)). We demonstrate a clean device fabrication process using a precious-metal protective layer, and
show that etching with aqua regia results in p-type (hole) molecular doping of our un-gated, contamination-free EG. Devices fabricated by this simple process can reach a carrier density in the range of 10^10 cm^(-2) to 10^11 cm^(-2) with mobility about 8000 cm^2/V/s or higher. In a moderately doped device with a carrier density n = 2.4 x 10^11 cm^(-2) and mobility = 5200 cm^2/V/s, we observe highly developed quantized Hall resistance plateaus with filing factor of 2 at magnetic field strengths of less than 4 T. Doping concentrations can be restored to higher levels by heat treatment in Ar, while devices with both p-type and n-type majority carriers tend to drift toward lower carrier concentrations in ambient air.
Two-dimensional semiconductors such as MoS2 are an emerging material family with wide-ranging potential applications in electronics, optoelectronics and energy harvesting. Large-area growth methods are needed to open the way to the applications. Whil
e significant progress to this goal was made, control over lattice orientation during growth still remains a challenge. This is needed in order to minimize or even avoid the formation of grain boundaries which can be detrimental to electrical, optical and mechanical properties of MoS2 and other 2D semiconductors. Here, we report on the uniform growth of high-quality centimeter-scale continuous monolayer MoS2 with control over lattice orientation. Using transmission electron microscopy we show that the monolayer film is composed of coalescing single islands that share a predominant lattice orientation due to an epitaxial growth mechanism. Raman and photoluminescence spectra confirm the high quality of the grown material. Optical absorbance spectra acquired over large areas show new features in the high-energy part of the spectrum, indicating that MoS2 could also be interesting for harvesting this region of the solar spectrum and fabrication of UV-sensitive photodetectors. Even though the interaction between the growth substrate and MoS2 is strong enough to induce lattice alignment, we can easily transfer the grown material and fabricate field-effect transistors on SiO2 substrates showing mobility superior to the exfoliated material.
Large-area bilayer graphene (BG) is grown epitaxially on Ru(0001) surface and characterized by low temperature scanning tunneling microscopy. The lattice of the bottom layer of BG is stretched by 1.2%, while strain is absent from the top layer. The l
attice mismatch between the two layers leads to the formation of a moire pattern with a periodicity of ~21.5 nm and a mixture of AA- and AB-stacking. The root3 x root3 superstructure around atomic defects is attributed to the inter-valley scattering of the delocalized pi-electrons, demonstrating that the as-grown BG behaves like intrinsic free-standing graphene.
Large assemblies of self-organized aluminum nanoclusters embedded in an oxide layer are formed on graphene templates and used to build tunnel-junction devices. Unexpectedly, single-electron-transport behavior with well-defined Coulomb oscillations is
observed for a record junction area containing millions of metal islands. Such hybrid materials offer new prospects for single-electron electronics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
