ترغب بنشر مسار تعليمي؟ اضغط هنا

Chloride Molecular Doping Technique on 2D Materials: WS2 and MoS2

337   0   0.0 ( 0 )
 نشر من قبل Lingming Yang
 تاريخ النشر 2014
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Low-resistivity metal-semiconductor (M-S) contact is one of the urgent challenges in the research of 2D transition metal dichalcogenides (TMDs). Here, we report a chloride molecular doping technique which greatly reduces the contact resistance (Rc) in the few-layer WS2 and MoS2. After doping, the Rc of WS2 and MoS2 have been decreased to 0.7 kohm*um and 0.5 kohm*um, respectively. The significant reduction of the Rc is attributed to the achieved high electron doping density thus significant reduction of Schottky barrier width. As a proof-ofconcept, high-performance few-layer WS2 field-effect transistors (FETs) are demonstrated, exhibiting a high drain current of 380 uA/um, an on/off ratio of 4*106, and a peak field-effect mobility of 60 cm2/V*s. This doping technique provides a highly viable route to diminish the Rc in TMDs, paving the way for high-performance 2D nano-electronic devices.



قيم البحث

اقرأ أيضاً

Here, we propose a method to determine the thickness of the most common transition metal dichalcogenides (TMDCs) placed on the surface of transparent stamps, used for the deterministic placement of two-dimensional materials, by analyzing the red, gre en and blue channels of transmission-mode optical microscopy images of the samples. In particular, the blue channel transmittance shows a large and monotonic thickness dependence, making it a very convenient probe of the flake thickness. The method proved to be robust given the small flake-to-flake variation and the insensitivity to doping changes of MoS2. We also tested the method for MoSe2, WS2 and WSe2. These results provide a reference guide to identify the number of layers of this family of materials on transparent substrates only using optical microscopy.
In this paper, we report a novel chemical doping technique to reduce the contact resistance (Rc) of transition metal dichalcogenides (TMDs) - eliminating two major roadblocks (namely, doping and high Rc) towards demonstration of high-performance TMDs field-effect transistors (FETs). By using 1,2 dichloroethane (DCE) as the doping reagent, we demonstrate an active n-type doping density > 2*1019 cm-3 in a few-layer MoS2 film. This enabled us to reduce the Rc value to a record low number of 0.5 kohm*um, which is ~10x lower than the control sample without doping. The corresponding specific contact resistivity (pc) is found to decrease by two orders of magnitude. With such low Rc, we demonstrate 100 nm channel length (Lch) MoS2 FET with a drain current (Ids) of 460 uA/um at Vds = 1.6 V, which is twice the best value reported so far on MoS2 FETs.
A method was developed to calculate the free energy of 2D materials on substrates and was demonstrated by the system of graphene and {gamma}-graphyne on copper substrate. The method works at least 3 orders faster than state-of-the-art algorithms, and the accuracy was tested by molecular dynamics simulations, showing that the precision for calculations of the internal energy achieves up to 0.03% in a temperature range from 100 to 1300K. As expected, the calculated the free energy of a graphene sheet on Cu (111) or Ni (111) surface in a temperature range up to 3000K is always smaller than the one of a {gamma}-graphyne sheet with the same number of C atoms, which is consistent with the fact that growth of graphene on the substrates is much easier than {gamma}-graphyne.
Controllable doping of two-dimensional materials is highly desired for ideal device performance in both hetero- and p-n homo-junctions. Herein, we propose an effective strategy for doping of MoS2 with nitrogen through a remote N2 plasma surface treat ment. By monitoring the surface chemistry of MoS2 upon N2 plasma exposure using in-situ X-ray photoelectron spectroscopy, we identified the presence of covalently bonded nitrogen in MoS2, where substitution of the chalcogen sulfur by nitrogen is determined as the doping mechanism. Furthermore, the electrical characterization demonstrates that p-type doping of MoS2 is achieved by nitrogen doping, in agreement with theoretical predictions. Notably, we found that the presence of nitrogen can induce compressive strain in the MoS2 structure, which represents the first evidence of strain induced by substitutional doping in a transition metal dichalcogenide material. Finally, our first principle calculations support the experimental demonstration of such strain, and a correlation between nitrogen doping concentration and compressive strain in MoS2 is elucidated.
Two-dimensional (2d) nano-electronics, plasmonics, and emergent phases require clean and local charge control, calling for layered, crystalline acceptors or donors. Our Raman, photovoltage, and electrical conductance measurements combined with textit {ab initio} calculations establish the large work function and narrow bands of $alpha$-RuCl$_3$ enable modulation doping of exfoliated, chemical vapor deposition (CVD), and molecular beam epitaxy (MBE) materials. Short-ranged lateral doping (${leq}65 text{nm}$) and high homogeneity are achieved in proximate materials with a single layer of arucl. This leads to the highest monolayer graphene (mlg) mobilities ($4,900 text{cm}^2/ text{Vs}$) at these high hole densities ($3times10^{13} text{cm}^{-2}$); and yields larger charge transfer to bilayer graphene (blg) ($6times10^{13} text{cm}^{-2}$). We further demonstrate proof of principle optical sensing, control via twist angle, and charge transfer through hexagonal boron nitride (hBN).
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا