اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPhysically transient photonics: random vs. distributed feedback lasing based on nanoimprinted DNA
132
0
0.0
(
0
)
تأليف
Andrea Camposeo
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The authors report on a room-temperature nanoimprinted, DNA-based distributed feedback (DFB) laser operating at 605 nm. The laser is made of a pure DNA host matrix doped with gain dyes. At high excitation densities, the emission of the untextured dye-doped DNA films is characterized by a broad emission peak with an overall linewidth of 12 nm and superimposed narrow peaks, characteristic of random lasing. Moreover, direct patterning of the DNA films is demonstrated with a resolution down to 100 nm, enabling the realization of both surface-emitting and edge-emitting DFB lasers with a typical linewidth<0.3 nm. The resulting emission is polarized, with a ratio between the TE- and TM-polarized intensities exceeding 30. In addition, the nanopatterned devices dissolve in water within less than two minutes. These results demonstrate the possibility of realizing various physically transient nanophotonics and laser architectures, including random lasing and nanoimprinted devices, based on natural biopolymers.
قيم البحث
اقرأ أيضاً
The simultaneous vertical-cavity and random lasing emission properties of a blue-emitting molecular crystal are investigated. The 1,1,4,4-tetraphenyl-1,3-butadiene samples, grown by physical vapour transport, feature room-temperature stimulated emiss
ion peaked at about 430 nm. Fabry-Perot and random resonances are primed by the interfaces of the crystal with external media and by defect scatterers, respectively. The analysis of the resulting lasing spectra evidences the existence of narrow peaks due to both the built-in vertical Fabry-Perot cavity and random lasing in a novel, surface-emitting configuration and threshold around 500 microJ cm^-2. The anti-correlation between different modes is also highlighted, due to competition for gain. Molecular crystals with optical gain candidate as promising photonic media inherently supporting multiple lasing mechanisms.
Lasers based on biological materials are attracting an increasing interest in view of their use in integrated and transient photonics. DNA as optical biopolymer in combination with highly-emissive dyes has been reported to have excellent potential in
this respect, however achieving miniaturized lasing systems based on solid-state DNA shaped in different geometries to confine and enhance emission is still a challenge, and physico-chemical mechanisms originating fluorescence enhancement are not fully understood. Herein, a class of wavelength-tunable lasers based on DNA nanofibers is demonstrated, for which optical properties are highly controlled through the system morphology. A synergistic effect is highlighted at the basis of lasing action. Through a quantum chemical investigation, we show that the interaction of DNA with the encapsulated dye leads to hindered twisting and suppressed channels for the non-radiative decay. This is combined with effective waveguiding, optical gain, and tailored mode confinement to promote morphologically-controlled lasing in DNA-based nanofibers. The results establish design rules for the development of bright and tunable nanolasers and optical networks based on DNA nanostructures.
We present an ultrafast all-optical gated amplifier, or transistor, consisting of a forest of ZnO nanowire lasers. A gate light pulse creates a dense electron-hole plasma and excites laser action inside the nanowires. Source light traversing the nano
laser forest is amplified, partly as it is guided through the nanowires, and partly as it propagates diffusively through the forest. We have measured transmission increases at the drain up to a factor 34 for 385-nm light. Time-resolved amplification measurements show that the lasing is rapidly self-quenching, yielding pulse responses as short as 1.2 ps.
Zinc Oxide thin films were grown on c-sapphire substrates using pulsed laser deposition. Pump power dependence of surface emission spectra, acquired using a quadrupled 266 nm laser, revealed room temperature stimulated emission (threshold of 900 kW/c
m2). Time dependent spectral analysis plus gain measurements of single-shot, side-emission, spectra pumped with a nitrogen laser revealed random lasing indicative of the presence of self-forming laser cavities. It is suggested that random lasing in an epitaxial system rather than a 3-dimensional configuration of disordered scattering elements, was due to waveguiding in the film. Waveguiding causes light to be amplified within randomly-formed closed-loops acting as lasing cavities.
We study laser generation in 1D distributed feedback lasers with amplifying and lossy layers. We show that when the lasing frequency differs from the transition frequencies of the amplifying medium, loss induced lasing may occur due to the broadening
of the resonator mode with increasing loss in the absorbing layers. This broadening leads to a shift in the lasing frequency towards the transition frequency. As a result, the cavity mode interaction with the amplifying medium is enhanced, and the lasing threshold is lowered.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
