اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTop gating of epitaxial (Bi_{1-x}Sb_x)2Te3 topological insulator thin films
189
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The tunability of the chemical potential for a wide range encompassing the Dirac point is important for many future devices based on topological insulators. Here we report a method to fabricate highly efficient top gates on epitaxially grown (Bi_{1-x}Sb_x)2Te3 topological insulator thin films without degrading the film quality. By combining an in situ deposited Al2O3 capping layer and a SiN_x dielectric layer deposited at low temperature, we were able to protect the films from degradation during the fabrication processes. We demonstrate that by using this top gate, the carriers in the top surface can be efficiently tuned from n- to p-type. We also show that magnetotransport properties give evidence for decoupled transport through top and bottom surfaces for the entire range of gate voltage, which is only possible in truly bulk-insulating samples.
قيم البحث
اقرأ أيضاً
(Bi1-xSbx)2Se3 thin films have been prepared using molecular beam epitaxy (MBE). We demonstrate the angle-resolved photoemission spectroscopy (ARPES) and transport evidence for the existence of strong and robust topological surface states in this ter
nary system. Large tunability in transport properties by varying the Sb doping level has also been observed, where insulating phase could be achieved at x=0.5. Our results reveal the potential of this system for the study of tunable topological insulator and metal-insulator transition based device physics.
We report mid-infrared spectroscopy measurements of an electrostatically gated topological insulator, in which we observe several percent modulation of transmittance and reflectance of (Bi1-xSbx)2Te3 films as gating shifts the Fermi level. Infrared t
ransmittance measurements of gated (Bi1-xSbx)2Te3 films were enabled by use of an epitaxial lift-off method for large-area transfer of topological insulator films from infrared-absorbing SrTiO3 growth substrates to thermal oxidized silicon substrates. We combine these optical experiments with transport measurements and angle-resolved photoemission spectroscopy to identify the observed spectral modulation as a gate-driven transfer of spectral weight between both bulk and topological surface channels and interband and intraband channels. We develop a model for the complex permittivity of gated (Bi1-xSbx)2Te3, and find a good match to our experimental data. These results open the path for layered topological insulator materials as a new candidate for tunable infrared optics and highlight the possibility of switching topological optoelectronic phenomena between bulk and spin-polarized surface regimes.
Dynamic manipulation of magnetism in topological materials is demonstrated here via a Floquet engineering approach using circularly polarized light. Increasing the strength of the laser field, besides the expected topological phase transition, the ma
gnetically doped topological insulator thin film also undergoes a magnetic phase transition from ferromagnetism to paramagnetism, whose critical behavior strongly depends on the quantum quenching. In sharp contrast to the equilibrium case, the non-equilibrium Curie temperatures vary for different time scale and experimental setup, not all relying on change of topology. Our discoveries deepen the understanding of the relationship between topology and magnetism in the non-equilibrium regime and extend optoelectronic device applications to topological materials.
We report on the fabrication and electrical transport properties of superconducting quantum interference devices (SQUIDs) made from a (Bi_{1-x}Sb_x)_2Se_3 topological insulator (TI) nanoribbon (NR) connected with Pb0.5In0.5 superconducting electrodes
. Below the transition temperature of the superconducting Pb0.5In0.5 electrodes, periodic oscillations of the critical current are observed in the TI NR SQUID under a magnetic field applied perpendicular to the plane owing to flux quantization. Also the output voltage modulates as a function of the external magnetic field. Moreover, the SQUID the SQUID shows a voltage modulation envelope, which is considered to represent the Fraunhofer-like patterns of each single junction. These properties of the TI NR SQUID would provide a useful method to explore Majorana fermions.
Topological insulators (TIs) have attracted much attention due to their spin-polarized surface and edge states, whose origin in symmetry gives them intriguing quantum-mechanical properties. Robust control over the chemical potential of TI materials i
s important if these states are to become useful in new technologies, or as a venue for exotic physics. Unfortunately, chemical potential tuning is challenging in TIs in part because the fabrication of electrostatic top-gates tends to degrade material properties and the addition of chemical dopants or adsorbates can cause unwanted disorder. Here, we present an all-optical technique which allows persistent, bidirectional gating of a (Bi,Sb)2Te3 channel by optically manipulating the distribution of electric charge below its interface with an insulating SrTiO3 substrate. In this fashion we optically pattern p-n junctions in a TI material, which we subsequently image using scanning photocurrent microscopy. The ability to dynamically write and re-write mesoscopic electronic structures in a TI may aid in the investigation of the unique properties of the topological insulating phase. The optical gating effect may be adaptable to other material systems, providing a more general mechanism for reconfigurable electronics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
