اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBulk Band Structure of Bi$_2$Te$_3$
133
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The bulk band structure of Bi$_2$Te$_3$ has been determined by angle-resolved photoemission spectroscopy and compared to first-principles calculations. We have performed calculations using the local density approximation (LDA) of density functional theory and the one-shot $GW$ approximation within the all-electron full-potential linearized augmented-plane-wave (FLAPW) formalism, fully taking into account spin-orbit coupling. Quasiparticle effects produce significant changes in the band structure of bite~when compared to LDA. Experimental and calculated results are compared in the spectral regions where distinct differences between the LDA and $GW$ results are present. Overall a superior agreement with $GW$ is found, highlighting the importance of many-body effects in the band structure of this family of topological insulators.
قيم البحث
اقرأ أيضاً
The bulk band structure of the topological insulator sbte~ is investigated by angle-resolved photoemission spectroscopy. Of particular interest is the dispersion of the uppermost valence band with respect to the topological surface state Dirac point.
The valence band maximum has been calculated to be either near the Brillouin zone centre or in a low-symmetry position in the $bar{Gamma}-bar{M}$ azimuthal direction. In order to observe the full energy range of the valence band, the strongly p-doped crystals are counter-doped by surface alkali adsorption. The data show that that the absolute valence band maximum is likely to be found at the bulk $Gamma$ point and predictions of a low-symmetry position with an energy higher than the surface Dirac point can be ruled out.
An important challenge in the field of topological materials is to carefully disentangle the electronic transport contribution of the topological surface states from that of the bulk. For Bi$_2$Te$_3$ topological insulator samples, bulk single crysta
ls and thin films exposed to air during fabrication processes are known to be bulk conducting, with the chemical potential in the bulk conduction band. For Bi$_2$Te$_3$ thin films grown by molecular beam epitaxy, we combine structural characterization (transmission electron microscopy), chemical surface analysis as function of time (x-ray photoelectron spectroscopy) and magnetotransport analysis to understand the low defect density and record high bulk electron mobility once charge is doped into the bulk by surface degradation. Carrier densities and electronic mobilities extracted from the Hall effect and the quantum oscillations are consistent and reveal a large bulk carrier mobility. Because of the cylindrical shape of the bulk Fermi surface, the angle dependence of the bulk magnetoresistance oscillations is two-dimensional in nature.
The electronic structure of thin films of FeTe grown on Bi$_2$Te$_3$ is investigated using angle-resolved photoemission spectroscopy, scanning tunneling microscopy and first principles calculations. As a comparison, data from cleaved bulk FeTe taken
under the same experimental conditions is also presented. Due to the substrate and thin film symmetry, FeTe thin films grow on Bi$_2$Te$_3$ in three domains, rotated by 0$^{circ}$, 120$^{circ}$, and 240$^{circ}$. This results in a superposition of photoemission intensity from the domains, complicating the analysis. However, by combining bulk and thin film data, it is possible to partly disentangle the contributions from three domains. We find a close similarity between thin film and bulk electronic structure and an overall good agreement with first principles calculations, assuming a p-doping shift of 65~meV for the bulk and a renormalization factor of around 2. By tracking the change of substrate electronic structure upon film growth, we find indications of an electron transfer from the FeTe film to the substrate. No significant change of the films electronic structure or doping is observed when alkali atoms are dosed onto the surface. This is ascribed to the films high density of states at the Fermi energy. This behavior is also supported by the ab-initio calculations.
Quantum states of matter combining non-trivial topology and magnetism attract a lot of attention nowadays; the special focus is on magnetic topological insulators (MTIs) featuring quantum anomalous Hall and axion insulator phases. Feasibility of many
novel phenomena that emph{intrinsic} magnetic TIs may host depends crucially on our ability to engineer and efficiently tune their electronic and magnetic structures. Here, using angle- and spin-resolved photoemission spectroscopy along with emph{ab initio} calculations we report on a large family of intrinsic magnetic TIs in the homologous series of the van der Waals compounds (MnBi$_2$Te$_4$)(Bi$_2$Te$_3$)$_m$ with $m=0, ..., 6$. Magnetic, electronic and, consequently, topological properties of these materials depend strongly on the $m$ value and are thus highly tunable. The antiferromagnetic (AFM) coupling between the neighboring Mn layers strongly weakens on moving from MnBi2Te4 (m=0) to MnBi4Te7 (m=1), changes to ferromagnetic (FM) one in MnBi6Te10 (m=2) and disappears with further increase in m. In this way, the AFM and FM TI states are respectively realized in the $m=0,1$ and $m=2$ cases, while for $m ge 3$ a novel and hitherto-unknown topologically-nontrivial phase arises, in which below the corresponding critical temperature the magnetizations of the non-interacting 2D ferromagnets, formed by the MBT, building blocks, are disordered along the third direction. The variety of intrinsic magnetic TI phases in (MnBi$_2$Te$_4$)(Bi$_2$Te$_3$)$_m$ allows efficient engineering of functional van der Waals heterostructures for topological quantum computation, as well as antiferromagnetic and 2D spintronics.
The challenge of parasitic bulk doping in Bi-based 3D topological insulator materials is still omnipresent, especially when preparing samples by molecular beam epitaxy (MBE). Here, we present a heterostructure approach for epitaxial BSTS growth. A th
in n-type Bi$_2$Se$_3$ (BS) layer is used as an epitaxial and electrostatic seed which drastically improves the crystalline and electronic quality and reproducibility of the sample properties. In heterostructures of BS with p-type (Bi$_{1-x}$Sb$_x$)$_2$(Te$_{1-y}$Se$_y$)$_3$ (BSTS) we demonstrate intrinsic band bending effects to tune the electronic properties solely by adjusting the thickness of the respective layer. The analysis of weak anti-localization features in the magnetoconductance indicates a separation of top and bottom conduction layers with increasing BSTS thickness. By temperature- and gate-dependent transport measurements, we show that the thin BS seed layer can be completely depleted within the heterostructure and demonstrate electrostatic tuning of the bands via a back-gate throughout the whole sample thickness.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
