ترغب بنشر مسار تعليمي؟ اضغط هنا

Production cross section measurements of radioactive isotopes by BigRIPS separator at RIKEN RI Beam Factory

124   0   0.0 ( 0 )
 نشر من قبل Toshiyuki Kubo
 تاريخ النشر 2013
  مجال البحث
والبحث باللغة English




اسأل ChatGPT حول البحث

We have measured the production rates and production cross sections for a variety of radioactive isotopes which were produced from 124Xe, 48Ca, and 238U beams at an energy of 345 MeV/nucleon using the BigRIPS separator at the RIKEN Nishina Center RI Beam Factory (RIBF). Proton-rich isotopes with atomic numbers Z = 40 to 52 and neutron-rich isotopes with Z = 5 to 16 were produced by projectile fragmentation of the 124Xe and 48Ca beam on Be targets, respectively. Neutron-rich isotopes with Z = 20 to 59 were produced by in-flight fission of the 238U beam, in which both Be and Pb were used as production targets. The measured production rates and production cross sections were compared with those of the LISE++ calculations, and overall fairly good agreement has been obtained. Furthermore, in the measurements with the 124Xe beam, we have discovered four new isotopes on the proton-drip line, 85,86Ru and 81,82Mo, and obtained the clear evidence that 103Sb is particle unbound with an upper limit of 49 ns for the half-life. The measurements of projectile-fragment momentum distributions have been also performed with the 124Xe beam, in which the low-momentum tails of the distributions have been measured for the first time at the energy of 345 MeV/nucleon.



قيم البحث

اقرأ أيضاً

304 - N. Fukuda , T. Kubo , T. Ohnishi 2013
We have developed a method for achieving excellent resolving power in in-flight particle identification of radioactive isotope (RI) beams at the BigRIPS fragment separator at the RIKEN Nishina Center RI Beam Factory (RIBF). In the BigRIPS separator, RI beams are identified by their atomic number Z and mass-to-charge ratio A/Q which are deduced from the measurements of time of flight (TOF), magnetic rigidity (Brho) and energy loss (delta-E), and delivered as tagged RI beams to a variety of experiments including secondary reaction measurements. High A/Q resolution is an essential requirement for this scheme, because the charge state Q of RI beams has to be identified at RIBF energies such as 200-300 MeV/nucleon. By precisely determining the Brho and TOF values, we have achieved relative A/Q resolution as good as 0.034% (root-mean-square value). The achieved A/Q resolution is high enough to clearly identify the charge state Q in the Z versus A/Q particle identification plot, where fully-stripped and hydrogen-like peaks are very closely located. The precise Brho determination is achieved by refined particle trajectory reconstruction, while a slew correction is performed to precisely determine the TOF value. Furthermore background events are thoroughly removed to improve reliability of the particle identification. In the present paper we present the details of the particle identification scheme in the BigRIPS separator. The isotope separation in the BigRIPS separator is also briefly introduced.
Production cross sections for neutron-rich nuclei from the fragmentation of a 82Se beam at 139 MeV/u were measured. The longitudinal momentum distributions of 122 neutron-rich isotopes of elements $11 le Z le 32$ were determined by varying the target thickness. Production cross sections with beryllium and tungsten targets were determined for a large number of nuclei including several isotopes first observed in this work. These are the most neutron-rich nuclides of the elements $22 le Z le 25$ (64Ti, 67V, 69Cr, 72Mn). One event was registered consistent with 70Cr, and another one with 75Fe. A one-body Qg systematics is used to describe the production cross sections based on thermal evaporation from excited prefragments. The current results confirm those of our previous experiment with a 76Ge beam: enhanced production cross sections for neutron-rich fragments near Z=20.
The present work reports the results of 30S radioactive beam development for a future experiment directly measuring data to extrapolate the 30S(alpha,p) stellar reaction rate in Type I X-ray bursts, a phenomena where nuclear explosions occur repeated ly on the surface of accreting neutron stars. We produce the radioactive ion 30S via the 3He(28Si,30S)n reaction, by bombarding a cryogenically cooled target of 3He at 400 Torr and 80 K with 28Si beams of 6.9 and 7.54 MeV/u. In order to perform a successful future experiment which allows us to calculate the stellar 30S(alpha, p) reaction rate, Hauser-Feshbach calculations indicate we require a 30S beam of ~10^5 particles per second at ~32 MeV. Based on our recent beam development experiments in 2006 and 2008, it is believed that such a beam may be fabricated in 2009 according to the results presented. We plan to measure the 4He(30S,p) cross-section at astrophysical energies in 2009, and some brief remarks on the planned (alpha,p) technique are also elucidated.
The interpretation of the most recent solar neutrinos experiments requires a good knowledge of the cross section of the reaction 7Be(p,gamma)8B at very small energy (Ecm=18 keV). We have recently measured this cross section for Ecm=0.35-1.4 MeV and f or Ecm=0.112-0.190 MeV. We report here on the description of the preparation of the radioactive targets of 7Be used in these experiments.
We have performed the first direct measurement of the 83Rb(p,g) radiative capture reaction cross section in inverse kinematics using a radioactive beam of 83Rb at incident energies of 2.4 and 2.7 A MeV. The measured cross section at an effective rela tive kinetic energy of Ecm = 2.393 MeV, which lies within the relevant energy window for core collapse supernovae, is smaller than the prediction of statistical model calculations. This leads to the abundance of 84Sr produced in the astrophysical p process being higher than previously calculated. Moreover, the discrepancy of the present data with theoretical predictions indicates that further experimental investigation of p-process reactions involving unstable projectiles is clearly warranted.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا