ترغب بنشر مسار تعليمي؟ اضغط هنا

Dynamics of the Modulational Instability in Microresonator Frequency Combs

137   0   0.0 ( 0 )
 نشر من قبل Tobias Hansson
 تاريخ النشر 2013
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

A study is made of frequency comb generation described by the driven and damped nonlinear Schrodinger equation on a finite interval. It is shown that frequency comb generation can be interpreted as a modulational instability of the continuous wave pump mode, and a linear stability analysis, taking into account the cavity boundary conditions, is performed. Further, a truncated three-wave model is derived, which allows one to gain additional insight into the dynamical behaviour of the comb generation. This formalism describes the pump mode and the most unstable sideband and is found to connect the coupled mode theory with the conventional theory of modulational instability. An in-depth analysis is done of the nonlinear three-wave model. It is demonstrated that stable frequency comb states can be interpreted as attractive fixed points of a dynamical system. The possibility of soft and hard excitation states in both the normal and the anomalous dispersion regime is discussed. Investigations are made of bistable comb states, and the dependence of the final state on the way the comb has been generated. The analytical predictions are verified by means of direct comparison with numerical simulations of the full equation and the agreement is discussed.



قيم البحث

اقرأ أيضاً

We introduce the first principle model describing frequency comb generation in a WGM microresonator with the backscattering-induced coupling between the counter-propagating waves. {Elaborated model provides deep insight and accurate description of th e complex dynamics of nonlinear processes in such systems.} We analyse the backscattering impact on the splitting and reshaping of the nonlinear resonances, demonstrate backscattering-induced modulational instability in the normal dispersion regime and subsequent frequency comb generation. We present and discuss novel features of the soliton comb dynamics induced by the backward wave.
Microresonator-based Kerr frequency comb (microcomb) generation can potentially revolutionize a variety of applications ranging from telecommunications to optical frequency synthesis. However, phase-locked microcombs have generally had low conversion efficiency limited to a few percent. Here we report experimental results that achieve ~30% conversion efficiency (~200 mW on-chip comb power excluding the pump) in the fiber telecommunication band with broadband mode-locked dark-pulse combs. We present a general analysis on the efficiency which is applicable to any phase-locked microcomb state. The effective coupling condition for the pump as well as the duty cycle of localized time-domain structures play a key role in determining the conversion efficiency. Our observation of high efficiency comb states is relevant for applications such as optical communications which require high power per comb line.
Experiments and theoretical modeling yielded significant progress towards understanding of Kerr-effect induced optical frequency comb generation in microresonators. However, the simultaneous interaction of hundreds or thousands of optical comb freque ncies with the same number of resonator modes leads to complicated nonlinear dynamics that are far from fully understood. An important prerequisite for modeling the comb formation process is the knowledge of phase and amplitude of the comb modes as well as the detuning from their respective microresonator modes. Here, we present comprehensive measurements that fully characterize optical microcomb states. We introduce a way of measuring resonator dispersion and detuning of comb modes in a hot resonator while generating an optical frequency comb. The presented phase measurements show unpredicted comb states with discrete {pi} and {pi}/2 steps in the comb phases that are not observed in conventional optical frequency combs.
With demonstrated applications ranging from metrology to telecommunications, soliton microresonator frequency combs have emerged over the past decade as a remarkable new technology. However, standard implementations only allow for the generation of c ombs whose repetition rate is tied close to the fundamental resonator free-spectral range (FSR), offering little or no dynamic control over the comb line spacing. Here we propose and experimentally demonstrate harmonic and rational harmonic driving as novel techniques that allow for the robust generation of soliton frequency combs with discretely adjustable frequency spacing. By driving an integrated Kerr microresonator with a periodic train of picosecond pulses whose repetition rate is set close to an integer harmonic of the 3.23 GHz cavity FSR, we deterministically generate soliton frequency combs with frequency spacings discretely adjustable between 3.23 GHz and 19.38 GHz. More remarkably, we also demonstrate that driving the resonator at rational fractions of the FSR allows for the generation of combs whose frequency spacing corresponds to an integer harmonic of the pump repetition rate. By measuring the combs radio-frequency spectrum, we confirm operation in the low-noise soliton regime with no supermode noise. The novel techniques demonstrated in our work provide new degrees of freedom for the design of synchronously pumped soliton frequency combs.
We numerically investigate the influence of high-order dispersion on both temporal and spectral characterizations of microresonator-based optical frequency combs. The moment method is utilized to study the temporal dynamics of intracavity solitons. T he theoretical and numerical results indicate the temporal shifts are induced by high-odd-order dispersion rather than high-even-order dispersion. The role of high-order dispersion on the frequency comb envelopes is carefully elucidated through analyzing the intracavity Cherenkov radiations. We further demonstrate that the spectra envelope of an ultrabroadband optical frequency comb can be engineered by using dispersion profiles with multiple zero dispersion wavelengths.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا